dauntless89
dauntless89
  • Видео 16
  • Просмотров 51 765
Power Driven Diesel, Sled Pull #2, UCC 2018
Power Driven Diesel, Sled Pull #2, UCC 2018
Просмотров: 350

Видео

Shop Air Compressor Charge Air Cooler
Просмотров 47 тыс.7 лет назад
Putting an automotive AC condenser and auto drain filter in your compressor discharge line is a great way to reduce moisture buildup in your shop air system.
Hunting 4 Horsepower 2016 - Pull 2
Просмотров 818 лет назад
Hunting 4 Horsepower 2016 - Pull 2
Hunting 4 Horsepower 2016 - Pull 1
Просмотров 1318 лет назад
Hunting 4 Horsepower 2016 - Pull 1
Hunting 4 Horsepower 2016 - Pull 3
Просмотров 1008 лет назад
This pull was made with AFC Live in bypass mode.
Big Rig Alternator 2.0 Running Grids
Просмотров 1758 лет назад
A short video of the 28si running the grid heaters at idle. Swap thread here: www.cumminsforum.com/forum/94-98-powertrain/1977393-d89s-big-rig-alternator-install.html
Cody @ SCR 8/13/16 Pass 2
Просмотров 208 лет назад
13.88 @ 108 mph.
Cody @ SCR 8/13/16 Pass 3
Просмотров 258 лет назад
13.79 @ 109 mph
Cody @ SCR 8/13/16 Pass 1
Просмотров 208 лет назад
"Preboost fuel only." Uh-huh, cool story Cody.
Cody @ SCR 8/13/16 Pass 4
Просмотров 198 лет назад
13.90 @ 100 mph
5/28 Fan Controller Update Part 2
Просмотров 618 лет назад
Progress update for my fan controller project. Part 2 of 2.
5/28 Fan Controller Update Part 1
Просмотров 1658 лет назад
Progress update for my fan controller project. Part 1 of 2.
Big Rig Alternator Running Grids
Просмотров 5458 лет назад
A demonstration of the Leece-Neville 110-555 JHO 160a alternator on my truck fully powering the grid heaters at idle. Swap thread here: www.cumminsforum.com/forum/94-98-powertrain/1977393-d89s-big-rig-alternator-install.html
Cummins Startup 31 Degrees
Просмотров 5318 лет назад
For comparative purposes, the startup of my 12v Cummins at 31 degrees ambient. 20 degrees of timing, 5x14s, 025 DVs. No throttle, allowed grids to run normally before starting.
Set-up for Milling a 12v Rocker Pedestal
Просмотров 2,1 тыс.8 лет назад
Set-up for Milling a 12v Rocker Pedestal. Discussion thread that prompted this video: www.cumminsforum.com/forum/94-98-performance-parts-discussion/1972633-milling-rocker-pedestals.html Please review the thread if you're going to do this. Some important details are omitted in the video.
Cummins Startup 63 Degrees
Просмотров 2248 лет назад
Cummins Startup 63 Degrees