- Видео 139
- Просмотров 16 007
sunwave
США
Добавлен 20 сен 2023
Видео
Anyone Can Stomp Out Smokin' Joe
Просмотров 4714 дней назад
Oklahoma City local weirdo, Gary Farris KA1VLR ducktape, only 2.5 miles north to north east from me being wiped out by skipland. Triple 6 Rattlesnake is south of me 4 - 5 miles wipes him clean out. Including 747 in Moore, Oklahoma 10-12 miles to my south.
Band Frame CB 40 channels in SDRuno
Просмотров 15214 дней назад
I forgot to mention that never to have ZIF on intended frequency. It must always be offset. SDRuno does that automatically. If you try, then everything will be garbled.
10 Minutes of Scanning the CB Band on a 14 bit adc SDRPlay RSP Line of SDR's
Просмотров 17321 день назад
I love to hear the squeal of the heterodyne of many cb radios keying up at the same time on a channel. This midday opening is common this time of year. Last part of September until about the first half of spring CB experiences F layer daytime enhancements at a variable occurrence. The Reason why I don't use RTL-SDR: Alot of channels with carriers. Some CB'ers just run factory default. Usually, ...
SDRPlay RSP1b No Desense - A Good Thing!
Просмотров 12221 день назад
Using SDR-Console. Parked on Ch 19. Seeing excessively strong signals on Ch 6. By comparison, not shown which is a well known fact that the same strong signals on Ch 6 would have "bogged down" an RTL-SDR. Not so for SDRPlay RSP1b as well as the entire line of SDRPlay RSP's. This is not speaking for the cheap clones on Amazon on Ebay. Those won't perform near as well and or not work at all.
Star Trek Online - Hive Onslaught - Playing with the Borg
Просмотров 49Месяц назад
My favorite game on pc.
72.180MHz NFM Primex Onevue Clock Sync
Просмотров 16Месяц назад
Schools use these to sync all the clocks on the grounds. I show the system clock to display it is right on time per second. Each di di da is 1 second. The system uses some sort of satellite to obtain time sync.
Problem w/SDRTrunk Nightly build Sept. 9 2024
Просмотров 27Месяц назад
Control channel is on 853.600MHz. It will only decode the two higher LCN's. It won't touch the LCN's lower than 853.600MHz. Channel event displays voice activity timers. and I proved the codec is installed.
8.137MHz USB WCY Maritime Weather Center from Florida
Просмотров 108Месяц назад
An actual recorded human voice instead of a robotic voice.
7200khz LSB Zoo of "Fine Business Operators"
Просмотров 22Месяц назад
Just over 2 minutes of misplaced CB'ers.
Manual Scan of CB Band DX Including Out of Band
Просмотров 32Месяц назад
Manual Scan of CB Band DX Including Out of Band
DSDPlus Fastlane APCO P25 Phase 2 TDMA OCPD
Просмотров 67Месяц назад
DSDPlus Fastlane APCO P25 Phase 2 TDMA OCPD
Star Trek Online - Leck's Throwing Knives Against Borg Lv 50 Map
Просмотров 19Месяц назад
Star Trek Online - Leck's Throwing Knives Against Borg Lv 50 Map
W1AW Bulletin on 7.095MHZ USB in 45 Baud RTTY
Просмотров 17Месяц назад
W1AW Bulletin on 7.095MHZ USB in 45 Baud RTTY
11635khz AM Cuban Spy Numbers Station HM01
Просмотров 9Месяц назад
11635khz AM Cuban Spy Numbers Station HM01
Another 20 Meter Ham Band Night DX into Oklahoma City
Просмотров 152 месяца назад
Another 20 Meter Ham Band Night DX into Oklahoma City
Can this work with SDR Sharp ?
@@nicholasp8978 nope. SDRPlay devs and SDR# devs don't get along. All the crybabies that whine about closed software were told to take a hike down their snowflake trail.
demoturds lmao
yo yo yo get some muffkaz
When its the end of the world but you still need memes
Donnie is a blooming idiot ........
HAM TURDS
something up with my audio
Actually no. The AGC in SparkSDR isn't set right. In SDRuno and HDSDR your audio is right.
🤣😂
Snake be dropping a big bomb on fairy gary lol!
Joe is funny
Well, the cost guard wannabe net brings it upon themselves.
Hi, What's the offset? Mine is way off at the moment.
@@sparky71a no offset. It uses a ring mixer oscillator on the R828D chip. I am astonished that some actually think this particular dongle needs an offset set in software. Not the case. Only offset there is is PPM correction. You shouldn't need any offset. Keep it in quadrature sampling. No Q branch. It is not like v3 dongle. Straight tuning 24MHz and lower.
Rodger, have to say I thought PPM correction would have done it,but didn't seem to do a great deal. I'll have another go. 👍
Good good, Is ok I am haved use sdr+++ and work very nice 👍🏻
do u recommend a bias tee powered lna or a external powered lna?
External power from a battery bank is quietest. I was demonstrating using the RTL-SDR v4 bias-T. It has satisfactory low enough noise floor at low RF Gains. LNA is there to compensate for that.
@@sunplio can i use a phone charger to power the lna?
@@nol_yaw You can but it might induce switching power supply noise. Better to use a power bank. They last a real long time on the lna because it consumes very little current.
thank you, that was most useful!
Damn mudducks 😆😆😆😆
LNAs are needed at higher frequencies. The natural noise level is high on 80 meters.
The rf-in and rf-out are not labeled on the housing of the LNA device. The dc connector is on the rf-in side, it should be on the rf-out side. The MMIC amp chip has only *one* uni-directional diode for protection. So in reality you should need two of them antiparallel. Or better: an bi-directional protection. 😇 There are many reports of malfunctions at this type of LNA...
someone should buy him a CB radio, he'd have a lot more fun
Spit my coffee out when you said that 😂
Is that old joe italiano
All of these aircraft are flying over Oklahoma. 131.550MHz is primary ACARS frequency.
lmao that's right peggy
chicken band lmao
New ham slogan "butt-(H)urt (A)ngry (M)en" lol
dewalt
Thanks for this. Sensitivity is the datum I've seen cited only very, very rarely!
What app to encode it with?
RX-SSTV also encodes sstv modes.
@@sunplio fantastic!
I have just bought RTL SDR v 4 . What is the simplest antenna that can be used to receive airband/vhf/uhf /shortwave and ham bands?
long wire with an alligator clip clipped to telescoping antenna. speaker wire works. 30ft of wire is fine.
@@sunplio which all bands will it cover?
@@ramv1564 the length of the wire should be a full or half-wavelength long for the frequency you're trying to listen to
FINALLY! This has been driving me nuts. Been getting it in Iowa, but couldn't find info on it. Had my suspensions is was in that area.
Glad I could help!
❣️ Promo*SM
???????
I'm just wondering if the LNA is REALLY in pass-thru mode when not powered??? My RTL-SDR V4 is so sensitive that it does not need the help of an LNA!!!
No passive mode. It's heavily attenuated with no power to lna.
Hi is it possable to use this on a quansheng?many thanks 🇬🇧
LNA's are for receivers and won't transmit. You can use it on that HT but if you try to transmit through a LNA you risk burning up the LNA and or radio output finals. You need to have a linear amplifier for the 2m/70cm Quansheng, All of the Quansheng HT's need the operator to have the proper license. Not going to discuss licensing.
i worked on an LNA housing for boeing satellite systems advanced design team. it had 4 LNA's with 4 mirrored and 8 redundant LNA's. ill never forget all the #0's screws for the waveguide covers haha.
-Even if two wires are same length it's still a random length on 1:9 baluns. on 1:1 baluns it's a dipole. -1:1 baluns reception is best for frequencies wire is cut for. Reception sucks outside of it's bandwidth. -For general coverage use 1:9 baluns.
Good stuff sir!
I hope it is simple and easy to grasp for the newbie. Thanks!
@@sunplio Since I qualify as a newbie, I also can confirm: that was understandable even for my newbie brain :-)
Turn all the knobs to the right,,,,, just as far as they can go.
what the hell is wrong with them ham guys
Those are Griffin Memorial's long lost escapee's LOL!!
How do these people manage to get licenses?
You mean how dare someone use the privileges of their license to prove a point. No one owns a frequency, even if they have a net scheduled or have think they have net running 24/7 on that frequency.
spatter plater
He was swatting bugs with his splatter blox lol!
ill be on there 4 till 9 ... wait maybe 10 to hell with it 12 o"clock mofo
He changed it to 2am to 12pm later. I should have recorded longer lol.
@@sunplio lol what time are they on there
@@rattlesnake1999 usually noon hours till evening. I'll listen up to find out if they for real about 14.300usb.
Great little radio
aliens
Best answer!
The actual heck is this??
What antenna were you using?
homebrew center fed dipole cut for 27MHz
Just tried to set it up, program kept becoming unresponsive Idk🤷♂️
Your computer has issues.
@@sunplio i eventually got it up and running, was putting quite the load on my OS already running other apps lol
splatter box's
STOP SENDING PICS OVER EACH OTHER.
what the...?
LOL good stuff Sunwave! good capture good audio receive.
🤣🤣🤣🤣🤣🤣🤣
😂
🤣🤣🤣🤣🤣🤣
uaahhh and uuuh but ahh
Thanks for uuhhh watching lol
Thanks, uhhhh, ahh and now i uhhh dont need to umm post this. Uuuhha😂
🤣@@juanbait9670