Видео

Your paper instructions talk about the corner brackets as A & B. Unfortunately the rod that is obviously made in China, has R&L stamped on the bottom of the brackets. No where is there any instructions that refer to R&L which I would assume alludes to RIGHT & LEFT. Your instructions are terrible! If your staff in China, cannot differentiate between A&B and R&L, you should contact the patent office and tell them you have a mistake on your product. Not impressed at all.

Hey your product mislabeled the pieces. R AND L are backwards

The box says they fit 48" to 96" wide, however each piece is only 46" long so the ultimate max length is 92".

What are the 2 inch markings for? Do they line up with the center of the brack? The far edge? What?

newly-design

These curtains are so long

Your instructions don’t mention whether to mount the brackets center/inside/outside of the mark.

I have two sliding patio doors right next to each other, configured similarly to an XOOX double door setup, although they do not actually close onto each other, and they are both surrounded by 2 1/4 inch trim, with a gap of 3 1/2 inches between them. Each set of doors is 64 inches across. Since a single rod, even fully extended, cannot be used across the both sets of doors, I purchased two rods. I’m not sure how to place the INSIDE brackets, since it seems they would need to occupy the same space (2 inches out from the trip, as the instructions recommend). How can I make this work? Can I use the support bracket in that place, somehow - or perhaps use the support brackets from both sets, spaced out - and purchase a longer rod? Even better, could the two rods be combined, somehow? I’m stumped.