- Видео 14
- Просмотров 5 839
Paul Stephenson
Германия
Добавлен 18 дек 2012
Beacon Contact
I've just added a Beacon H bed probe and configured Beacon contact.
Over 100 1st layer test patches printed on smooth PEI without glues or other fixers.
I'm well pleased with this.
Over 100 1st layer test patches printed on smooth PEI without glues or other fixers.
I'm well pleased with this.
Просмотров: 564
Видео
Finally! I'm getting closer to being able to print something other than first layer patches.
Просмотров 822 месяца назад
Finally! I'm getting closer to being able to print something other than first layer patches.
It prints.
Просмотров 9653 месяца назад
VzBot 330 Mellow AWD First first layer test. This was just to see if it works.
Why are you purging before meshing; you should do that after as to mitigate oozing.
I've dialed that out, it now purges and then goes straight to printing. I think it was in the Orca profile that I downloaded. I wasn't paying too much attention to it at the time as I was concentrating on getting the Beacon working.
@@paulstephenson5311 fair enough! Glad it got fixed!
What size are they?
www.amazon.de/KOTARBA.../dp/B08NW78MCN/ref=sr_1_9...
woot !! congrats !
@@Vez3D how do I get a serial number?
Good idea, Well done
You have 3 videos over the course of a month you must be REALLY busy trying to get the thing perfect Good Luck hope you do
@corrupted1850 Thank you. I've got it dialed in now that I've fitted a Beacon probe. It's now printing ABS onto a smooth PEI sheet without glue.
Ah yes Fans
Too slow
Speed comes later when it's tuned.
@@paulstephenson5311 i think you might wanna make the buildplate height a little bit higher :D
@@IakovosTsagaris that's part of the tuning that I'll do. This was just to see if it works.
it definitely does
or probably some z stepper motor connected to the wrong stepper driver ?
Thanks for the comment. Changing the stepper motor order in the M584 fixed the major problem. Then I found some errors in the bed.g - I wrote the incorrect coordinates. I've no just got to calibrate the extruder and then I can print.
The problem was cause by an incorrectly written M584 line. The coordinates were not in the correct order.
Hello, A chicken feed joke comes to mind.. Thanks for subscribing, Cordialement,