Видео

Why doesn’t my Cruze have that bleeder plug?

Just make sure you pack the bearings with dirt and grass first…

Wait so I don’t need to disengage the electronic break?

Wouldn’t start. Had to refund the customer and send them to the dealer. Triple checked all connections. Needed a battery program/relearn

massive street cred for the highway noise, those cars are going fast...and good emphasis on "you can't drop any little pieces into the dark engine bay or you're not gonna make it"

Whe you say get them pretty cheap, what should I pa for an 01 with 50,000 miles clean aluminum dump body 8.1 ?

Just got one. But it’s a project bike so I have a question. Does urs have a key fob that needs to be close for it to crank. Or is it just the old fashioned key. Ordered a battery to test things out. But don’t want to run into issues with that and need to order something else and be back waiting

no snap ring pliers, no hammer, cardboard toolbox...

I am looking for the cylinder seal kits with no luck and a hydraulic filter. Any help would be greatly appreciated TIA

Watched a few videos your was the most helpfull thank you

What kind of batteries do I need for 2021 jeep compass

Do I need to disconnect the battery or is the car being off fine?

Have a long 445.... they're great

Just spray brake clean all over the ground...Not cool

I love these tractors, but there are so few videos of them on You Tube. and usually when you find one, it has been left outside. Don't know why people that bought them did not take good care of them. How are they priced now as a used tractor? Reasonable? And what about parts?

Hi. How do you remove the caliper slide pin black rubber boots? Also how do you install new slide pin boots?

Mine won't come off

That’s one way to try and take an eye out 🤷🏻‍♂️

Worthless video, does the actual removal OFF CAMERA, because it doesn't work like that ! Take this down !

My 2005 mercury mariner cracked on driver side electric connect cracked off

Was looking for this vid thnks

I’ve done it twice without taking the air box out. Was not easy but I finagled the old battery out and the new battery in with some busted knuckles.

I downvoted. Should have shown step by step from the start.. not 70 percent completed job.

Great video with lots of good information.

Why wouldn't you show that brake pad replacement as stated in the title?

I think a 2014 Toyota Venza 4 cyl has; pretty much, the same setup. Doing my alternator tomorrow morning. I'll let you know what's up

Thank you so much needed the info on getting the battery out in the dark and heat and mosquitos...

Nice

Thanks for posting. I’ve done plenty of alternators. Just haven’t done one on this truck. And mine took a 💩 on me yesterday. Don’t look hard. But it’s always nice to see what you’re getting into.

Those freakin retaining wires are killing me. They didn't put new ones in my brake pad kit and they pop off every time i go to put the caliper in.

2018 through 2022 Equinox's don't have v6 engines.

What cruze do you have? Because my plug is under the car and its a pain to get to. I have a 2012 1.8 petrol

At idle these cars heat up 10 degrees per minute but if your driving on the hwy they can heat up 30 degrees a minute with a stuck thermostat so normally driving at 200 degrees that is the line just before the halfway mark that only gives you two minutes of driving before hitting 260 at that temp this engine will have a blown head gasket because the aluminum head will be warped. I recently fixed a VW Jetta the guy hit a racoon in the middle of nowhere drove for about 45 minutes with no coolant on his 1.4 Turbo and after fixing the car the engine had NO damage, the turbo boost was so smooth with no lag nothing like the Chevy junk.

The case 530 was not made till 1960 so yours can’t be 1957. Perhaps 1967?

Thanks bud. Between you and my buddy Adrian I managed to change my brakes for the first time ever! Feels good.

Bro, buy a torque multiplier it's a little hand operated impact tool that will get those lugs off quick ...I paid 50 bucks for Mine off Amazon.

Abangku.. Mohon ci bantu,saya ada engine 3116 di unit Grader dan unit tersebut tidak mau di marikan. Mohon solusinya🙏

So my lid is leaking air and I can’t seem to find the part number for it and I need a new cover

Well done! 👍

Máquina boa

Missing the retaining clip on the reservoir tank so you're lucky the reservoir isn't cracked from it bumping around .

The inflatable part of the cover is a good idea but designed poorly and prone to leakage. The one that came with mine wouldn't stay inflated for 48 hours, but there are aftermarket replacements that are considerably better, staying inflated much much longer. They do still appear to leak but significantly slower to where I only have to refill maybe ~once a month so far whereas the one that came with the SaluSpa wouldn't even stay inflated for 2 days.

I’ve changed the water pump thermostat head gaskets and still over heats but when I turn the heater on blast it cools down while driving when I’m parked and idle never over heats only when I’m driving and tips

That platic bleeding screw will fall apart if you never loosen it in years. You better replace it with metal one (compatible with bmw screws)

Working on cars, you have to be creative with tools 😂 because that one airfilters is in a stupid location. P.s good work with the grease, too many people use too little

WOW! thanks Ford the first thing in Heater core and build the unit on top!!!! It is like this cross the industry!

A great video...cruze owner who needs your help until he can afford better

Make sure u check steering box oil, no flash electronics BUT will keep on going and going

Any tips on if you round off one of the bolts?

It looks like the tree was already blown down by the wind. I have something much better here: 2NizBAWVbVE