Видео

Good pt; if it was only 5% done eating, instead of 95% done, he might not have walked away from his kill so easily when he heard me coming. Also the mother moose would likely still be very close by and may also be aggressive towards us.

The orange label because it's the softest I've found; Scott Comfort Plus Double Rolls

@@borjonx thank you

I do not, but I will make one for you.

Me too! mine quit working after this hard freeze in Feb. and has EA code. I want to take apart but im nervous. downloaded manual but videos sure do help!!! Thank you!!!

@@borjonxdid you make video to how to open Heat exchange

No - I should have recorded it while I was doing it, but I was in a hurry because guests were coming.

My stomach sank as it unfolded right before my eyes - for years and years it has only been peaceful interactions. What is the preferred contact method?

@@borjonx be careful, vet everything Alex says before you sign anything

We got her from a rescue about 7 years ago - out there in the Mat-Su valley. She's almost 10 now - can not underestimate the power of exercise!!!

When I realized this was unfolding right before my eyes, I was horrified. The only thing I could do was "beg" the moose to stop. Afterwards I ran inside to get my car keys and bear spray(mace) so I could run the moose off if she had put my neighbor down. Fortunately the moose stopped the charge & I was able to get the lady into my car & drive her home.

It ran as far as it's leash would allow. It's ego was bruised, but no it wasn't touched.

Is your error code the same as mine was? Have you popped the lid off to see if something is burning on the surface?

The gyro can start to increment when the robot isn't moving - you can tell by looking at the real time value on the robot or in the EV3 software. If it's incrementing (drifting) you'll need to unplug it, wait a second then plug it in again. That's the most common cause I've seen, for spinning a robot.

Thanks jerry. I’ve noticed the incrementing before on certain test runs of other programs. So would the incrementing explain the lack of stopping when we incorporate this turn mechanism later in a program and it keeps turning?

@@ericstephenson8749 Yes. basically the program says "turn until the gyro is equal to 90 degrees"... but since the gyro is in a bad state(drifting/incrementing by itself) the turning continues forever because the gyro was already at five thousand degrees(et al.) - because it's been incrementing the whole time(or decrementing). Another tip use >= or <= instead of just = when comparing, because even when everything is going right, it might miss the one degree you're looking for. 1KHz sample rate iirc. If nothing else you can send me your program & I'll load it to my ev3 to help debug, or send a screenshot if there's no "myblocks".

On the normal blocks the software tries to control & measure rotation - like if you say go forward for 2 rotations, the motors provide feedback to the EV3 so it can correct for things like low battery, resistance, etc.. I want to have full control of the motors, because I will control them based on the gyro sensor.

@@borjonx Cool, I didn't know that. Thanks for the reply

We have used toilet paper that dissolves extremely well for 23 years and have never had a problem with our leech field or even need our septic tank pumped.

Yes

​@@rickfrase2663what the name of the toilet paper you use.

Name of toilet paper please​@@rickfrase2663

+ahmed tolba Here's the pic of my demo program: drive.google.com/file/d/0B0HcLWK4J-28blA0c05UZEdsemc/view?usp=sharing