Видео

Just FYI, the White and the Green Wires are the Reed Switch Wires. Put an Ohm on those 2 Wires and it should show "Open", hover a Magent around the door lock and it should show a "Short".

How do I bypass this turd all together so my machine will work without it? I live alone. No kids over, ever. I was expecting 2 wires id splice or something I could trick with a magnet when I ripped it out. I hate smart sensor bull crap. I'm gna find an old late 70s GE w dials switches. The kind that never die.

the first test showed continuity when plunger was out and when plunger was in. So the switch is bad yes?

i bought 2 already..F samsung

Can I put a jumper wire to bypass the door lock?

Thank you! I was looking everywhere to figure out how to test this.

How do you bypass the switch?? What wires do you connect together?

Asdfgnm

Thanks for the wiring diagram. That helped out tremendously! Our washer just started doing the clicking as if trying to lock. Though it was already locked. And the display wasn't recognizing it being locked. So there was no indication stating it was locked. I took the lid off, found the switch, tested it at the connector, and found it wasn't reading right. Instead of buying a new locking device, I opened the switch up to find the "legs" were dirty. Cleaned them off with some alcohol and a q-tip. Its been running just fine since. Saved $160 bucks on a part that just needed to be cleaned. Thanks again.

This really doesn't help at all as the first two points that you tested (brown and black wires) are wired straight to the locks Actuator motor. There is also a chip on the motherboard that controls the power sent to that motor,and if that chip fails no power will be sent to the motor. This is the issue I am dealing with now and I am 90% certain the power chip on the board has poped as there is a bunch of brown crap trapped in the gel around one of the chips where the lid lock connects to the motherboard.

This is what he said: Time frame 1:53. Open, close. locked ,unlock. Open=locked. close=unlocked. And open door is a locked door. A close door is an unlocked door. If you are not confused you must be on drugs.

Elk are deer. Elk are the 2nd largest deer in the world. The largest deer are moose. Wolves hunt all of these deer. An expert in biology says wolves hunt deer and the biggest point in this video is the erroneous repetition that elk are not deer.

Excellent washing machine✰✰>allmy.tips/SamsungTopWasher?gG Large capacity, cleans well and easy to install with standard fittings.

are you Kevin Costner?

LOOK I DON'T WANT TO MAKE ANGRY TO NO ONE BUT THE WAY YOU TESTED IS NOT RIGHT BECAUSE THE CONTINUITY THERE IS JUST CONSEQUENCE OF THE ACTION OF THE MOTOR WHICH IS OK BUT CAUSE IS PART OF THE TEST, BUT IT CAN BE DAMAGE EVEN AFTER THIS TEST BECAUSE THE MOST IMPORTANT IS THE PIN OF THE CENTER AT THE BATON AND THE PIN OF THE RIGHT ON YOUR DIAGRAM. THEY ARE THE CONNECTION FOR THE VARIABLE RESISTANCE WHICH GET ACTIVE WHEN YOU CLOSE THE DOOR BY MAGNETIC ACTION AND THIS REQUIRE THE MAGNETS ON 100% CAPACITY AND IF THE MAGNETS INSIDE THE TOP ARE GETTING OLD THEN THE SYSTEM WILL FAIL WHIT APPARENTLY NO EXPLANATION, AND IT HAVE NOTING TO DO WHIT THE CONTROL BOARD, BETTER TESTED WHIT MAGNETS TO BUT YOU HAVE TO FIND THE RIGHT POLARITY ON EACH SIDE.

what about if the lid is open or shut, I have been having problems and Iv'e determined that it is the reed switch, It would have been nice to be able to test that too without pulling the machine apart. Since my reed switch is broken, i'm not sure if it is by default connected when the lid is closed or open with the lid is closed, I think you would be able to find out by connecting the white wire with the green wire and opening and then closing the lid, it should turn off and on.

www.sciencedirect.com/science/article/pii/S0378112715003333

Do you know the Park Service hired trappers to live trap beaver. The Park service released 129 beaver. That is called fraud. At first the coyote population dropped but today the numbers are back to pre wolf. There is no science study on the songbirds proving there was increase in songbird number it was all lies. The river never changed course. You did a great job.