Видео

still i am saying same things don’t buy any hiteco spindles instead of other brands ant that’s why below hiteco spindles more fragile to crash to bend shaft and cracks because of hardening of shaft and heat process if you don’t believe me i can prove it with material inspection report hiteco spindle are not easy to repair because all the time you need special press tools and that not means you can perform good repair job but not %70 percent of shafts bend when you try to remove rotor even if you use special press tools hiteco spindle rotors cooper ends break up any reasons and stock between rotor and stator hiteco spindles don’t have balancing setscrew holes and every time when you balance you should drill ne holes to rotor and that means weakness for rotor rots.you should mark rotor position for much more imbalance but most of the time this is not enough for perform best balancing hiteco spindles don’t have clamp drawbar unit that means over stress on bearings when tool changing.that means piston directly push shaft towards to bearings. hiteco spindles work much more noisy but most weakness of hiteco spindles are IF YOU NOTICE THE WEAKNESSES OF THEIR SPINDLES THEY ARE NOT ACCEPT IT EVEN THEY TRY TO SILENCE YOU WITH THEIR LOCAL PARTNERS. these are the truths if you accept them or not even you try to treat me again giuseppe and try to start legal action about me look and and see that kind of surprises i have repaired for you to accept weakness of you products.i am a repair guy and i don’t have any local partnership with any other brands and my goal is keep my customers benefits NOT YOURS

👍

👌👍

👍😎

I have not had any luck with these spindles! The first one came to me dead upon arrival! With no warranty honored. My dumb ass bought a second one! it works but can’t get the tool out of it once it’s ran for more than a few minutes. It has to cool completely off before you could ever change the tool. Forget about having an automatic tool changer.

Hey Matteo ! A Real star 🥰 ! Congrats !

Please build a lower power i.e. 3Kw 2 pole spindle....

Bravo! This is impressive! I use Giordano Colombo but I think I know who is going to make my next spindle! What RPM, depth per pass and IPM were these parts cut? Thank You

what is the lubricant?