Видео

I use tie wire, solder is expensive. Lol

Bro just put screws in the flange only grabbing the plastic spacers. This shit won’t last very long could’ve used hydraulic cement, or something to fill that void. Those screws didn’t grab nothing but the spacers.

What the hell are you doing? Go below and add a coupling to your toilet riser and bring it up above the floor then use some plywood to seal the bottom and attach your flange to that piece of plywood you secured to the bottom using 3 inch wood screws. This will 100% leak

Hack job

Bolt holes are way off...

😂 well done! but I’m sure you know like comments above it’s not always that easy… also ever had an inspector tell you they can’t see if you used primer?😃

Making it look that easy should be a crime!

Male plastic into female metal, always.

Open walls, no mud. Jealous. Solid work brother

Lazy. Why not just do it right? Everything is exposed.

That toilet is gonna fall over once a fat person gets up off it. Its not bolted to the actual ground 😂😂😂😂

You don't need to tighten brass into plastic that much it will contract with cold water and crack trust me i know.

I’m putting pipe dope and Teflon tape for added insurance. I don’t care what anybody says. I don’t need callbacks.

Cutting a little close on that drain line

Must be a rental

U fortunately that will still lift the waste bend if the line beneath isn’t secured or anchored. There still isn’t support

Nice work buddy. Glad to see professionals not stacking 34 wax rings and using 2 tubes of silicone 😂

Wish we had these in Scotland 😭

Honestly I’ve never been in a spot I couldn’t make it look good lol

Yeah of course it’s “super easy” when you can hold the pipe and fitting in your hand on a work bench. What about when you’re in a super tight spot with minimal access?

🔥👌🏽🔥👌🏽

I was admiring the work till I died when The guy at the end said it looks like shit.😂

Lol new construction only.

Now do that inside a wall

do that with installed pipe while standing on your head mr. " super simple"

Pipe dope on a compression fitting? Does that help or is it paranoia?

The professor...

Ask how high you put the water

Wouldn't you want that cleanout to be closer to the ground? I feel like it would be easier to service/snake if it were lower.

Those r the cleanest solder joints ive ever seen im skeptical that some are ever solder

I've done that. This guy showed me that solder trick some years back. I never seen anyone else do it. Nice work

Nah bruv, only on shower drains.

Use tapcons don't be cheap

Clean joints brother

I fucking hate those moen faucets. Lol i deal with alot too

The old chrome sleeve wouldn’t fit over your coupling so you had to go with that dull piece of aluminum eh

I use the same trick with all the leftover wire the electrician throws on the ground. Solid advice

Breaks tile immediately just taking the crap off pipe 🤦🏽

He didn't shimmer dap you have to dab around the toilet shimmy you can't bolt it to ceramic to ceramic

could have left some drain pipe

Type M on the first drop. So wrong!

Assim é que se faz

He cut the drain nipple extremely close to the wall. At least 2" of bare PVC nipple.

Would've been a cool vid to press

Reem your copper pleas3

Pipe dope on the compression valve?

Where’s the supply valve?

The silicone boys are out again 😂

After 25 years, I learn something new again

Didn’t seal the toilet to the floor