James Thiessen
James Thiessen
  • Видео 4
  • Просмотров 25 968
2000-06 toyota tundra Drive indicator bulb replacement
This is a quick way fix for you burnt out drive or any gear indicator bulbs on a 2000 to 2006 tundra
Просмотров: 693

Видео

2012 Ski-Doo Summit etec chaincase oil change
Просмотров 10 тыс.9 лет назад
Changing chain case oil on my 2012 ski doo summit Rev-xp 800 etec. Make sure u add a little oil to the rubber plug to help it slide back into place. *Disclaimer:*You assume all risk if u try to replicate my methods shown.

Комментарии

  • @666dynomax
    @666dynomax 4 месяца назад

    Of course no drain on a skidoo. Im so sad Yamaha makes sleds no longer. I still have four but just got my first skidoo. Awful

  • @Marlene612
    @Marlene612 6 месяцев назад

    Hi James, so THIS is the procedure to change the D light, fantastic. Maybe even i can do this. Maybe! My overdrive light is out. Same procedure, it’s the same bulb?

  • @iandoesstuff1520
    @iandoesstuff1520 Год назад

    How much oil should I put in there

  • @chilloutyaall
    @chilloutyaall Год назад

    Awesome tip! I was looking to change my 2011 600Ace chain case oil and noticed no oil drain plug on the bottom 😡. What a stupid design by Ski Doo! I would need to take half the sled apart to remove that cover. Just loosening the bottom 3 bolts will save me hours of work! Thanks so much!!!!

  • @atikameg73
    @atikameg73 7 лет назад

    Thanks! Short, simple, and well-explained.

  • @kylechallis
    @kylechallis 9 лет назад

    how much did you tighten the bottom three screws after? to torque spec? or just to feel?

    • @jamesthiessen6331
      @jamesthiessen6331 9 лет назад

      I just tightened them to what i thought was good. i believe the torque spec is 53 inch pounds but I'm not sure. i just torqued them enough to make sure the rubber gasket/seal on the cover was sealed.

    • @kylechallis
      @kylechallis 9 лет назад

      +James Thiessen awesome thanks james doing this to my gsx 1200 but it is exact same procedure