- Видео 55
- Просмотров 105 474
jean-marc Berg
Добавлен 11 сен 2013
Видео
New universal landing gear controller
Просмотров 4212 года назад
-up to 6 flaps servos -individually programmable -Brake module individually adjustable -chassis mechanics individually adjustable from 5kg to 45kg landing gears -operating voltage 7.2V 2 S Lipo -with large landing gears even with 12V operable Very easy to program
JMB-JETS/ WIND RC K8 Jet Trainer
Просмотров 9583 года назад
JMB-Jets K8 Trainer Jet 1/5 Our new K8 full composite/ Airex, as usual an exotic one in the RC World The K8 is delivered in a PNP version, including lighting, servos, linkages, electric landing gear, tank, drop tanks and thrust tube Length 2109mm Wingspan 2050mm Take-off weight from 12,8kg For turbines 10-14KG Music: Nightwish Titel : Sleeping Sun 2005
JMB-Jets PC-21 XXL Maiden Testflight
Просмотров 4,4 тыс.4 года назад
PC21 XXL powered by a Kingtech K100tp Length 3394mm Wingspan 2739mm Weight full at takeoff only 23 kg
Jet Cave by JMB-Jets
Просмотров 1,2 тыс.4 года назад
Protection for Rc planes 100% waterproof anti moisture Jet Cave
TopRc Model Odyssey "Odyssey Mania"
Просмотров 2,3 тыс.7 лет назад
TopRc Model Odyssey "Odyssey Mania"
Beautiful jet and excellent flight!
what appears a 3:14 to the left of the model airplane, drone? White Light... is it reflection?
Hi Jean, I have one of these as well, can you post a response to Dave's question? Thanks Andrew
Mail to kingtech.turbine@gmail.com
What Vector nozzle did you end up using?
Nice flight, nice video. What is your recommended Cg location?
Jean, I am just getting one of these. What are the elev, Ail, and rudder throws? Are you using flaperons and at what throws for landing vs takoff? Are you using Tailerons and if so what throws? Is the manual CG 115 correct? Thanks
send me a mail to kingtech.turbine@gmail.com
What do yo think with jetcat p100?
Nice looking Jet, is this jet basically turbine and receiver ready?
Your Specs at the end is wrong, wingspan 1250 length 1220, should be 1950, or not?
very nice, what is the brand of the model? I am looking to by one. Mirage 2000 scale 1:7. Specifications Wing Span: 1230.3mm/48.4in Length: 1897.0mm/74.7inch Turbine: 8-12kg PNP Complete Package 1. Full composite construction. 2. All surface prepainted,decals applied and clear coated 4. Detachable main wing, fuselage and horizontal fin for easy transportation 5. Removable hatch on fuselage for easy access into the plane and change accessories 6. Scale cockpit 7. All High quality Digital MG Servos installed 8. Fuel tank installed 2270CC 9. UAT installed 10. Thrust tube installed 11. Electric retract set installed 12. All wiring and connectors installed 13. Functional drop tanks - for smoke oil 14. Include 5 attachments 15. Just fit your turbine, radio and go fly. 15. Optional Smoke system
JMB-Jets kingtechturbine.lu/Mirage-2000-C-PNP_2
Is the cortex gyro a must on this model when flyging with vector thrust?
Top! Mein Erstflug findet in den nächsten 2 Wochen statt.
NIce! 😎
Nice maiden and flies well. Great landing too. Congrats!
interested! thanks for something different... hate seeing the same stuff over and over at the rc field!
Top, Jhempi! 👍😎
Power satt, gif ech son
sascha spintig jojo ;-)
what is the weight minus fuel with the 100?
about 11,9 kg
@@jean-marcberg6668 Do you have to fly most flights near full power to maintain knife edge flight? Do you have to carry a fair amount of power during landings?
lucky macy no need only lot of power and good runway to start, after in air it is easy and enough, need not so much power gor landing 1/4 throttle only and at the end on idle
@@jean-marcberg6668 did you use a smaller and lighter fuel tank? how many batteries and of what capacity do you use and where did you put them? What specifically did you do to avoid putting in any dead weight? Where did you end up with the CoG? I am also using a 100N engine so looking for tips.
lucky macy yes used a fuelbag of 3L very light and no UAT needed 2x 2200 Lipo and 2100 LiFe
Superbe !!!!!!
website?
Wich turbine was flame out ? 😂😂😜 nice jet hope the small one I've got flys the Same
Not Engine fault we build the proto in 3 days and the tube on tank was not fixed correctly so goes off during flight 😜 but was a good training to see if the plane can glide 😉
The proportions look kind of wierd?
Super Jet, mal was Anderes , als was man überall sieht - da kommt "will haben " auf :-)
Gl,ad someone finally made the jet I've been asking for for years.
Ça donne envie !!!!!!
Nice! Would K80 be enough for it? Since it is a bit heavier and leas thrust? Thanks
K80 is more than enough even for grass operations :) Flown tested, great model!
pls, how much is the size of the inlet diameter of the compressor blade and turbine?
👍🏼
Really bugs me when everyone says like on Fakebook. Not everyone is a loser and does fakebook.
Very nice Marc! is the price range known, estimate at least , performance is great!
Tomislav Reskovic Hi Price Kit ARF + retracts lights installed pipe and tanks 2599€ pnp with all installed incl. HV servos only need turbine and receiver 2899€
Super light is always a good way to go: easy flying and easy landing. Do you know the wing surface/wingload?
Philippe Veyt 2270 mm wingspan and 2050 mm lenght
NICES .... MORE INFO ....
Why the K30 and not the K45? I want the K30 but the price point between the two are none.
K30 is 63 mm in diameter meaning you can put it in 70 mm fiberglass models
very nice. fast reponds. I'll buy one soon.
That looks great!
Hy Jean-Marc. Ist das bei der k45g restart auch dabei? Wir sehen uns bei jetpower event Genderkingen wie besprochen :-)
Is this flying with a VT-80? Thx in advance
I have this problem, how is it solution?
grazie
forgive me, but I have problems with translation and I did not understand well. I wanted to ask you that if I did not understand, you tried the model with an 8kg and a 14kg, according to you with a jetmount 100, how would it be?
SALVATORE BARBA with a 10kg Jetmunt the Odyssey fly perfect 10-12 kg thrust are ok for all airfields
Hi, where did you get the drop tanks?
Klasse geflogen. Wieso ist die PC21 eigentlich nicht von der anderen Seite gelandet und ist mit der Tragfläche ins Gras?
Superbes vols du PC 21 et du Rafale. Surtout le pc21 ;)
ma con la 8 kg come va' ?
Yes 10 kg is perfect
se va' gia' bene con una 8kg, una 10 kg sarebbe perfetta?
no prima 80-140 ok
ciao, ho letto motorizzato turbina da 8 kg , e' giusto? come va' ? non e' piccola?
Ich ärger mich ja schon etwas... Da hat Kingtech echt ne klasse Turbine auf den Markt gebracht!
Yup cant wait! cant wait to build a 3d foamy with it!
Da hat jemand Spaß! Klasse Erlebnis.
Dennis Modellflug Blog Ja war geil 😃