Видео

After sales in indonesia?

Lol I grind these types of heads all night, 12 hrs a shift and this thing is soooooo slow. My bosses would scream if I took that long to set up a cutter head.

keep going dad

Great job 👍👏

Does this also work with grinding wheels with a taper or a radius? I'd assume there's some amount of deformation because of the abrasive nature of the process

Thank you just what I needed.

Very nice sir

It says in the instructions with my abrasive cut off blade not to use it if it has been dropped. Dropped how far and how hard? Doesn't make sense. Can you test the blade to se if it is ok with this test?

Très bonne présentation.

What kind of grinding wheels do you use for rough and finish pass

Yours has a chain instead of a metal rod , you can keep that one , I would break that chain eventually , I like my solid metal rod

Good 👍

hello, what angle do you use in sharpening blanket knives?

I need radius attachment, our radius is R2 to R10

I have a diamond dresser

good video! to be safe, always look for the oSa Symbol of safety when buying safe @t

thanks for sharing

0:44 hot-teens24.online

A 0-1"" or 0-25mm mic with carbide anvils alot more accurate than those Digi verniers...Wheel not balanced either,.. could give you loads of problems....lead error..spacing.....

What is your rpm speed of this machine

I noticed you did NOT balance the wheel assembly, ie the flange hub and the wheel for true running, most metal grinding machines ( cylindrical or otherwise) of this size wheel require balancing, just like your car tyre's rims, is there a reason why?, does this "dressing" do the same job?; also noticed unlike above mentioned wheels, you didn't torque the screws on the hub with a torque wrench, why.

Nice built machine , Which is cnc controller system ?

Thanks for the video , I just purchased a profile grinder and noticed that all the brand new 10 inch wheels looked like only one side was dressed . Is that common , If so please let me know . Thank you , Pete with woodworking and Metalworking supplies in Fresno California

Helpful video. Cheers

U dont want your wheel exactly the same size because these machines have give to them. What i mean is if you push hard side to side or any angle will essentially make the wheel grind the knives like its a few thousandths bigger.

Is it as simple as flushing out old coolant and replacing with new coolant? And if so how often?