G- Side
G- Side
  • Видео 5
  • Просмотров 5 056
Freeland Si4 and Evoque SI4 VVT issue
This video shows you how to remove and clean the VVT filter on your Freelander or Evoque with the SI4 petrol engine fitted.
normally procedure is carried out if one of the following is found to be a issue
rough running
sounding like a diesel engine
engine light with fault codes related to VVT performance /slow response/range
oil pump failure causing filter to block with partials
lack of service causing oil sludge to build up
skimming of head causing shavings to clog filter
normally noticeable when engine starts and aloud to idle for approximately 10 to 15 mins the noise is heard from idle to 2000 rpm and seems to quiet down when driving.
not to be confused with VVT failure which is an chatte...
Просмотров: 6

Видео

Freelander and Evoque service indicator reset
Просмотров 333 месяца назад
reset the service light easy with this video and without a scan tool or a dealer visit
Velar rear brake pads
Просмотров 4,5 тыс.Год назад
quick guide to replace rear brake pads not to bad to do just remember to put rear calipers in service mode first to avoid having to replace rear calipers time beginner 1h more advanced 30 min make sure to tighten all bolts specs are online and use your trestles.
Range Rover velar pollen filter Fitment
Просмотров 490Год назад
in today's video we will be fitting a range rover velar pollen filter. difficulty level ; 1 tools required ; this video and your hands parts ; pollen filter
place's you didn't know were haunted in South Africa
Просмотров 325 лет назад
Ten places that are said to be haunted in South Africa. Sorry if the quality is a bit off this is my first video post rest will get better still learning the whole RUclips thing please enjoy ,like,subscribe

Комментарии

  • @SherwinCharles-ud4li
    @SherwinCharles-ud4li 5 месяцев назад

    I have a 2020 velar and the process used to get it into maintenance mode work, you just have to get the timing right when you do it. Also I pulled the park lever for 2 secs, then pressed the gas pedal to the floor and turn the car off and on at the same time. That worked for me.

    • @g-side4816
      @g-side4816 5 месяцев назад

      that's great to know thanks. There are some differences between year models think it's just software difference

  • @rckyrcky
    @rckyrcky 10 месяцев назад

    What year is this velar?

    • @g-side4816
      @g-side4816 10 месяцев назад

      Hi there its a 2019 180D

    • @rckyrcky
      @rckyrcky 10 месяцев назад

      @g-side4816 i was told it needed a computer to be hooked up and would cost $1500 for the back and $1300 for the front its a 2018 dynamic r 380. Does that sound right?

    • @g-side4816
      @g-side4816 10 месяцев назад

      Holy S%$t sorry about that where I'm from total front and rear would not even come to $1500 ( including rotors ) all together but hooking up to a computer makes it easier but it can be done without it ,front brakes work like any other vehicle just rear brakes need to be put in service mode before fitting brake pads thinking i should move to the states i would be rolling in the $$$ lol

    • @g-side4816
      @g-side4816 10 месяцев назад

      checkout a company called DFC (dynamic friction company ) they are in the USA I'm sure they will assist with better prices unfortunately I have never delt with them As I'm from South Africa hope you come right

  • @belenellory2508
    @belenellory2508 Год назад

    🤤 *Promosm*