Видео

“Too lee”

Does this work with a rhino rack?

Is it ok to install these while on uneven floor ?

Hi, where did you get the service manual.

Hey mate, have you tested the bash plates? How are they holding up to 4wding?

Where can i buy that?

Do you have links in ali express for this, but hard to find this stuff.

👍 great video thanks

What’s the thread for the strut mount?

You say putting the bolts throught he bar is bodgy then you can't even cut a straight line in steel. You faffed around to reinvent the wheel when there was no need to.

Hi, dont suppose you have a link to what u bought??? Cheers

Thx, good video. The torque required is a bit misleading in the beginning, good you mention it towards the end that it is for the second nut. For info, the stock bushings are same size as your aftermarket ones. Take care

You can't slide the bars to a custom distance apart then? You have to stick to where the holes are?

love the idea of the bar inside. Great video, thanks for sharing.

Save up a lot of mucking around when u cut thread just cut off where u want don’t worry about dies or nuts. Grind the thread end on to your bench grinder wheel. What you are doing by doing this instead of filing or grinding around the thread is forming the burr to the center of the bolt. You will never pick up even into alloy. Hope that makes your next bolt cut down less stressful. Awsome cheap awning just bought there 270 for my boys setup. Cheers

how are they holding now sir?

Do i need to jack it up?

Very helpful thank you

thanks for the vid, when you replaced your intercooler hoses i hope you used the silicone ones as those rubber ones have a tendence to crack

thanks for that vid, I'm about to do mine except i trying the Superpro bushes

Did you lift the vehicle to make te change?

Thanks mate, this helped alot, interesting to note on my 2021 Exceed the air guide panel doesn't need to be removed or shaved off. The bottom half of it is rubber that bends. Pic of it here for example :) Thanks Again i.postimg.cc/tCLCxkFb/20220713-123840.jpg

Mate what model Pajero sport do you have I have a 2022 Exceed & wanted to check if this would work on mine.

Great to have another pajero sport channel on RUclips.

Good job Brad. Did you get any vibration in the end? If you use a scan gauge is there any difference in temps?

Hi Brad The PM10 and PM2.5 means better than 50% efficiency at removing 10 micron and 2.5 micron particles respectively. It is in the note at the bottom of the insert sheet you are reading at 3:08. Cheers