Видео

Hello Have an ML350 2007 mine has a foot brake is the cable from rear to front also runs under the centre console? any info is appreciated

This is such a great video, I have the same vehicle and it's turbo has stopped working.... great advise in your video....Thank you very much Can you please tell me where you purchased your replacement turbo?

thanks for the upload.. but uh, the sound afterwards, you're sure there's no leak of one the hydraulic lifters?

Am și eu un kymco la fel și nu vrea sa pornească deloc motorul invirte totul e ok dar mu vrea sa pornească iam schimbat carburatorul și a pornit după lam lăsat vreo 2 luni și după aia nu a mai vrut sa pornească oare e aceasi problema ca la tine ?

Do you need to replace the gasket and the o-ring?

Oil light is on.

Bro we can’t see nothing

Put some gloves on! Your hands must stink!

where i can buy these for my 1T2 06 Touran please

To access the turbo res top clamp nut: ​​⁠move yourself further back towards the middle of the car, behind a cross member or two, you will see a gap - about a foot away lies the clamp nut. Look for the orange seal! I had to use a torch. I used a 3/8 inch ratchet > long extension > 1/4 adaptor > a wobble/universal joint (recommended!) > 7mm socket. (Whatever size ratchets and extensions you use, the socket for the clamp nut is 7mm) Space is limited for the ratchet to turn, so crack the nut with the ratchet still attached and then disengage it, using your hand to turn the extension bar. To remove, pull out the other end of the res box at the orange seal, then twist and yank down the turbo res box. Done. Awkward but doable!

excellent, thanks.

Theres 2???

Very nice motor 📸

Salut, îți las o abonare pentru ca știu cum este să fi susținut! Spor la treabă ✌️

I installed the same and they broke on the first run, they broke because the spring is not seated right, has no metal support underneath ...also I recommend to install spacers on the top, as there is more flat surface. On the low side they not fit right because of the angle of the beam.

A fost faina masinuta 📸

Salut! Mulțumesc pentru video, foarte util. Îmi poți spune ce marcă de termostat recomanzi? Ca să știu ce să cumpăr.

Good ideea ...thx👍🍺🍺🍺

cam ruptus o fost suportul

it's only possible if you have the AUX possibility (XC90 up to 2007)

Faină mașinuța!

You shud try using words.

Thank you

Are arc pe foi?

Hallo!

Salut!

Is possible that due to blogged fuel filter car does not go much up the hill? I mean In on 30 kms an hour and car wont accelater when I go up the hill so now Im gonna try the fuel filter and hope it fixed it.. when flat car ok but not more than 80kms an hour 😢

SMC RAM 📸

sehr schon!

Fain ATV-UL!

What was that? Kid playing?

Asta e de la ATV-ul asta ultimu?

Hallo!

😂 gresit tot ce ai facut ! ( dupa ai fugit repede la mecanic sa-ti regleze frana de mana , ca se incinge prea tare ori nu iti tinea) ma-ma mecanicule 😂

asta ii un motor fain :D

Spor la lucru!

Thanks for the video ..how is the sound quality? Like on the fm radio or cd or does it sound worse?

Immer dieses ewige Rumgejammer. Typisch deutsch. Ob Autobahn Schiene und was weiß ich noch. Großzügig Entschädigen und umsiedeln , fertig.

Not very clear, could of done with a bit of taking through it

Why is there oil?

Spor la lucru!

Ai Audi, Dorelutz?

Jajajaja muestra todo menos como lo saca o lo introduce ...video sin ningún fin.tonteria

My pipe below the mixing chamber is also filthy. Should i scrape and vacuum it too or might it fall somewhere bad?

Bine de știut!

No ase, tre sa face si eu ce face Dore

Thanks for Help

Can’t see shit on this video!

So you have to replace the whole thing you took out ?

eres mudo?