Видео

This is a tracked FPV camera rover that I designed and built in Feb 2021

My 2018 Kubota GR2020 with bar tires, rear weights and blower. This is with the blower raised up to its highest position. First pass down the driveway, with the bar tires are chewing through the snow left below the blower. My Kubota handled this snowfall nicely but this is about as deep as it can cut in a single pass. I wouldn't want to try this with turf tires.

No actual robots were hurt during the filming of this clip.

This is my latest project. The track, wheels, gearbox, toothed pulleys, battery & electronics mounts were all 3D printed in PLA on my Anycubic I3 Mega printer. All parts were designed in Fusion 360. It is running a pair of 45T 540 R/C motors and I am using a Pololu TReX Jr twin motor controller.

R/C tom-foolery

Honey Badger takes a ride.

Robotic Arm gets a software upgrade. Now has record and replay functions with data stored on an SD card.

Robotic Arm RUclips

Stepper motor drive robotic arm #2

Robot arm 4-axis test

Robot Gripper Design #2, First Test

Robotic arm test controlled by six potentiometers. possibilitiesrover

Robotic arm test assisted by Coco

Packing peanut snowstorm with RC Helicopter