Видео

No, it's generally not recommended to twist incoming VDSL pairs together and then tighten them with a clamp on the terminal. VDSL signals are sensitive to interference and noise, and proper termination is crucial to maintain signal integrity and prevent issues like crosstalk and attenuation. For best performance, you should: Use proper connectors and terminals designed for VDSL. Avoid twisting the pairs together manually. Ensure each pair is properly terminated and secured to maintain signal quality. If you're unsure, it's best to follow the guidelines provided by the VDSL equipment manufacturer or consult a professional.

It's good to hear that it worked for you.👍

It's generally better to be honest with your internet provider. Explain that you accidentally cut the cable and ask for assistance in getting it repaired. Providers typically appreciate honesty and will be more likely to help you quickly and efficiently if they know exactly what happened.😊

@@TECHNICALSZHZ Is there a charge??

Do you mean a set of RJ45 and a union?

A Coupler Ethernet Extender Connector. ​@@TomBVoxman

Dear just 1 camera only working with this method.

you NVR not PoE,single port to switch,i prefer PoE switch 8 port,if you use normal switch,use rj45B(use orange and green for data,and blue positif brown negative)This for camera,and for switch just termination like usual(rj45B)

Bule wire ka jarurat nai tha

If you need an urgent solution for a wire joint, here are this step you can take.

It's worked

Same

same😂😂

Haha. The street dog did it for me.

Same bro😂

Rat did my cable dirty

Yes jis mein 12 volt current ho bas wohi

না ভাই, এই বাসের ভিডিও দেখবেন

Yes. It's ok no issue pair yaad rehna chaiye apko both of side Kay..

Dear, If you have a cable tester, use it to check the connection. This will ensure that the wires are correctly connected and that there are no issues with the joint.

It seems like you're describing a setup using Cat6 wire with an RJ45 connector on one side and a power supply on the other side, possibly for a 2MP IP camera. This setup could work to provide both data (video and possibly audio) transmission through the Cat6 wire and power to the camera through the power supply. Just make sure the IP camera supports this type of power and data configuration and that you have the correct wiring and components for the connection.

The power supply's capacity should be sufficient for four IP PoE cameras, but it depends on the power requirements of each camera and the total power output of the power supply. To ensure proper functionality, you should check the power consumption of each camera and verify that the total power requirement does not exceed the 10 amp capacity of the power supply. If you're unsure, consult the camera's specifications or seek assistance from the manufacturer.

50 meter wire 3A power supply

Am talking 200 meters

If you used smps power supply it's work.

Thanks

Thank you

No record just live view and camera checking.

Thanks dear 🤗

Ok I will trying to explain in English ..

You're welcome

If you have 4k LCD tv to support all 5mp 8mp cameras

Yes dear it is good for joint

Yes you should solder it as after some months copper will catch carbon you will losse connectivity So its better to join both end by soldering.

Dear agar apki wire achi quality ki hai our pure copper ki hai to 100 meter par giga switch par ping ok aye gi .....magar joint sahi tarikay SE bana ho Jesa k video mein banaya hai .

In your case, you mentioned using the blue and brown wires for both power and data. This is possible, as long as the cable you're using supports PoE and the camera you're connecting is PoE-compatible. However, it's important to make sure that the cable is wired correctly to avoid any damage to the camera or the equipment providing the power.

Thanks