Видео

Replaced the cooling fan but didn't fix the problem, could be the swicth but whenever i look up the fan switch for videos there's none

Harbor freight has a coupon for 25% off on this knife, right now.

Thank you so much for your video its literally saved me

What would a bad Cannister purge valve cause? I have a very rough idle, when the car is in gear and at a stop it is really bad and it gets a little better when the ac compressor is turned on. I thought I had a vacuum leak, but I did not find one.

👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍

I did mine. 3.5 litres drained out, add 3.5 litres in the level check hole, you’ll have to start engine to allow it to fit. Get a pump and a long hoses to make the process easier.

I’d it worth to buy it ?

You forgot about the tension springs. and how did you get the caliper back on without compressing the piston. the piston would still be out from the old-worn pads and would not fit over the new pads.

I’ve tried bumping engine to install AC belt at least 6 times. The belt on AC pulley always walks forward one groove at best and does not seat. I can’t figure out how to do this very frustrating and ridiculous design. Love my bmw though There has to be a trick I tried almost everything. Some cars are probably more difficult than others if alignment isn’t perfect in the same plane of rotation. I gave up ordered a crank socket to rotate it by hand and watch the AC pulley. It needs some extra pressure to keep belt seated in grooves

Que quiere decir eso

To check if your fan is working, remove the wire harness from the coolant temp sensor, the fan should start working.

1/2 inch wrench for my drain plug

I need your help

Seeing a diesel BMW in the US is really cool 😎

Whats the difference in run time?

Used this button but if I'm doing a burnout still having power cut once on gas and brake 😅

You didn't show how to unplug the coil

Reviewer also from harbor freight

Flew off the road with this one turned off. Not turning it off anymore. But it really gives you full performance.

Stupide question but how did you crank the engine to get the AC belt on?

Great video...thanks!

What type of fluid,brand,did you use?

Thanks for making this video, like you said in the beginning, most of these cars have disk brakes. Unfortunately, I thought the same thing until I pulled my tire off after ordering parts, lol! It was hard to find the right parts because most parts places don't pull up brake drums and rotors when you select the ES as the sub model.

Serious question, my 335d got some oil leak,i open the downpipe and its a lot oil coming from turbos. is there a leak from intercooler seal ? Can you help me with any suggestions and see what part i need replace 😢

Good video guy,..thank you.

I have a different model, but this video could have saved me $1,500. I replaced every component of my cooling system, but it was an electrical problem. Good news is my car now basically has a new cooling system!

Do you know if this is in the same location on a 2013 Dodge Dart as well?

That is NOT the fill point for the 4F24 transmission, I believe is for the air vent. That is why it takes you 1/2 hour to fill it. The fill point and plug are further back and is similar in appearance to the drain plug. It is easier to reach from the bottom then use the funnel from the top with a length of flexible hose placed into the fill hole.

Thank you! Very helpful. Ours was almost black! 😮

Tbh tho you didn’t even resurface the rotors which you should if you’re not replacing them. To each their own.

Maybe take it out the box before start filming

What part is that called

part numbers on the belts? length? ac belt number ? length

Thank you sir

Think you so much man you saved me 250$ idn why thay were going to change me that

My neighbor allowed me to borrow that tool. It was awesome.

That icon would make a fine light for home inspectors in attics and crawl spaces.

This video is saving me so much time. Thank you so much for the great video

🎉🎉

Just get a Carly

It looks easy EXCEPT WHEN THE DUMB T25 STRIPS OUT!!!!!!!!

Straight to yhe point flashlight video, i like 👍👍 the Braun is a bit smaller and can fit underneath dashboards easily!

LCI E61 2009 N47 Hi. Does anyone know or have faced such an error? ISTA wrote: DDE: Electric fan, starting. CODE: 0041F2. I did a test, but it doesn't turn. Maybe there's something wrong with the program. I installed the second one, nothing. Does anyone know what the diagram looks like and what elements work with the fan? Does the fan work with a relay? Or just a fuse? Will you help? I will add that the connection at the fan on the pins is clean and functional. The harness looks fine. No. What needs to be done to ensure there is current in the cable that goes to the fan. Maybe then the fan will work.

Gonna need that phone to call 911.

Ok l don’t think harbor freight sells quality stuff- cheap yes

Harbor freight

Did you do the test of the fan voltage with the car on or off?

Hey I have a 2009 lancer and I believe I need to change this purge valve. Any idea where I can also find those bolts online as mine are very rusty.

i have all the strions but i may have to get a stinger too. probably the dual switch because im used to the strion being on the back

how do you crank the engine without it starting?