Видео

OK where are you?

Hello and congratulations again for your great video I had a question: can the JK-PB2A16S20P communicate easily with a victron multiplus II 5000VA? what equipment do you need special cable in addition? I'm trying to find out about the bms because as I have a large 24 volt 1300AH battery pack I would like it to work perfectly before investing in the BMS and the victron multiplus II! laurent

You were expecting this thing to make your water clear in no where near enough time. Those filters are great at the mechanical end but a bit lacking in the biological end. The beneficial bacteria is what will give you crystal clear water. Also will prevent sludge build up. Bacteria can be colonized almost anywhere. If you have the pond bottom filled with river rocks or gravel you’ll get colonies of bacteria. Keep in mind there are 2 types of benificial bacteria. Aerobic and anaerobic. This address the water column differences. I used one of those as a pre filter before my bio falls set up. It works pretty good but I have the larger model. For whatever reason they didn’t make that one with a crank to wring out the filters. Backwashing works pretty good but like you mentioned you’ll need to pull it all apart to do a thorough cleaning. That part isn’t much fun.

Hi, can you help explain the hardware you are using to make this happen? I have a jk bms with rs485 port, and I’m wondering if I need an adapter or something?

Just got one that looks same as this one on amazon a few weeks ago. The Amazon unit looks like a near carbon copy of the Luna unit I have but cheaper materials. My Luna filter had worked for 25 years. The ring clamp totally fell apart due to rust and one of the handles pulled right off. It would have been 500 plus Canadian dollars to replace it. So the Amazon one is 4x cheaper and its best feature :) I love the fact that the canister is shut with an easy plastic clamp and sealed with a gigantic o ring. But the cleaning mechanism is garbage. At best, it scrapes the surface of the sponge cog Wheels. The bottom sponge does not turn on first use. You have to unscrew assembly to get sponges to clean. Way harder than it should be. So you can spray it in place but the chlorine.... I have a filter pre box attached to intake pump to help. Output goes into a small diy barrel with biological filter media. The biggest issue for me was this unit clogged after just 2 weeks vs whole season for the Luna unit it has replaced. Otherwise, it is similar in its ability to Luna unit. Cleaning is way worse. But for the price...I will live with it.

Have had one of these sat in my basket online for about 2 weeks as I couldn't decide whether to get one. I'm currently running a solar fountain and filter which is a hassle to take out of the pond and clean out every week and also isn't really running long enough to oxygenate the pond. (Not enough sun in an English summer for a solar pump - should've seen that coming!) After watching your helpful video I think I'll hit the checkout button. Thank you

I had the same issue with mine regarding the mis labeled ports in the manual. So frustrating! I set my BMS to the Pylontech protocol and I'm curious if the GoodWe is the better setting. As is sits now everything works fine except the Inverter doesn't display the detected Ah rating of the battery only the SOC. Does your inverter/dashboard show a battery capacity with it set to GoodWe protocol? Also, does it follow the absorb/float settings you have set on the JK BMS. Mine skips over the absorb phase and goes straight to float.

Where can I buy??

Does that hub work with old black jk bms (2 blue wire )

Add a second or bigger filter u will be fine

Same filter system on my 600 gallon pond. Runs 24/7 365 Before the filter it was a mess. Once A week I clean with hand crank and every 6 months disassemble and clean the innards. I’ve found out that disassembling the filters isn’t necessary and just spray the filters with hose and crank the handle. At the bottom where the balls are that’s the disgusting part. Use the hose again and then clean out the container. Reassemble and do it all over again in 6 months. I Live in Arizona.

I have one of the two JK BMSs attached to one bank. I will attach the other side of the bank with its JK BMS this weekend. I want to connect it all to a Xantrex 4548 with the SCP control panel. It uses Xanbus. Think you could help me get it all communicating?

Thank my fiter is arriving today I have two ponds one for bream gold fish and talapia and it will filter both ponds since they loop together by a waterfall and a pump back into the big waterfall at the other end !

Try a bog filter. Essentially a bucket or barrel filled with rocks that fills at the bottom and empties out the top into the pond. Preferably have it waterfall into the pond to also aireate the water.

good review they can take up to a week to clear up with a few cleans between to get it better

Pretty sure you have it piped wrongx̌

Sorry I didnt watch to the end where you added hoses.

If I were you I would add a hose where the water comes out and extend it out over the pond. Your filter can become clogged when you aren't there and water could run straight down your filter side and out on the ground and drain your pond. They are meant to have a hose or sit over the pond. I've used a few different kinds over 15 years.

No where near big enough for a 2 foot long plec

thanks!

Props cavitation. So want to put it a little deeper.

I have 2 of these. Absolutely love em. Used them for years. In salt water.

before i sell a pond i tell my clients there are three stages of water . water problem , water head ache , water nightmare . yours is stage water nightmare . its a lot of work to keep fish ,water plants and don't get me started on turtles . the filter system you bought is sufficient for this pond . it just needs to turn the water over for two time a day . down fall is the cleaning . it will have to be cleaned often . more in important is your UV light . you need a in pipe uv or put the light in the filter . all the water must run over the UV light . turtles are highly toxic with saminila poisoning. the more you run the filter the more clear the water will get . you can also use aqua clear products . keep ph around 7 no more then 8 .5 no less then 6 . don't use water from your house it has chlorine . you can buy a filter or let water set for three days . after the water clears you will have algae problems any algaecide will do . i hope you enjoy the water feature i can tell you there is an answer for any problem you encounter . but they are work to maintain

Bog filter

We have one of those filters… not worth the money. Make a homemade with a bucket and poly fill. You’ll see improvement in minutes.

Did you get both jk inverter BMS running in parallel with the 6000xp recognizing them?

Why on Earth would you buy a Chinese made 6000 XP, with its low surge capacity in the first place?

you should add one more turtle for Mr turtle

nice, but without a compression ? I will do a rack mounting system

Nice, I think currently its best BMS version for DIY, I wait for my first 16x cells to setup a bank. My inwerter is a SoyoSource GTN-1200LIM48 means have a CT clamp as limiter who do hybrid OnOffGrid, export only for auto-consumption, zero export to grid, max 900W output. For me perfect !

Where can I find one of these ?

It will take days, but will work

'Promo SM' 🙂

A bunch of plants will definitely make a big difference.

Is the motor shaft vertical? Have you tried trimming the motor up so it tends to lift the bow, instead of sinking it?

2 years ago...ruclips.net/video/gEyQPKCX9XE/видео.html&ab_channel=Scottthesigncrafter

Are those 100ah cells? Which Horrible Freight case is that?

Looks promising. 4hp equivalent that's what 3kw. Wonder what kind of amps it pulls.

the hawing is brushless, I assume? If so esc potted in the foot?

That is a great power plant. That should move the yakamaran easily. Typical DIY engineer...never read the directions first!😆

Awesome!

Might be harmonics in the aluminum ladder

Sounds like a VFD squeal.

Wow. Sounds like a jet turbine firing up! Keep us posted.

I just bought same filter. Does the UV light indicator suppose to be on all the time? Mine goes off and on, stays off more than on. I think something is wrong with my bulb possibly.

Filter and pond sucks

Make room where the turtles could stay dry and bask under the sunlight.. 💁‍♀️ they need it everyday

This video reminds me there is so much stuff ppl need to know before spending their whole savings in ponds and calling it expensive :x thanks for sharing and have a great day.

Thats my kinda DIY . 😁 What does the antenna look like? Do you have it in a bowl?

Thank you for including the pump name