- Видео 26
- Просмотров 32 553
Henri Matthijssen
Добавлен 28 апр 2018
Видео
Rode buurt bij binnenkomst 4 Daagse Nijmegen Dag 3
Просмотров 186 месяцев назад
Rode buurt bij binnenkomst 4 Daagse Nijmegen Dag 3
Witte buurt bij binnenkomst 4 Daagse Nijmegen Dag 3
Просмотров 286 месяцев назад
Witte buurt bij binnenkomst 4 Daagse Nijmegen Dag 3
Biertje drinken voor Waalbrug op dag 1 van 4 Daagse Nijmegen 2024
Просмотров 256 месяцев назад
Biertje drinken voor Waalbrug op dag 1 van 4 Daagse Nijmegen 2024
Live Muziek bij Darkey Kelly's in Dublin
Просмотров 379 месяцев назад
Live Muziek bij Darkey Kelly's in Dublin
Gordijnen snel Automatisch openen en sluiten
Просмотров 1,3 тыс.6 лет назад
Gordijnen snel Automatisch openen en sluiten
Fake you can't cut steel wires with nife
This is not going to have any precision for positioning unless you mate it with another segment of belt while joining. Even then the difference in elasticity might show as positioning errors as the joint crosses pulleys.
Can you please explain this?
Did you end the video by saying sow it together?
Watch my video for DIY GT2 Timing Belt Connector which cost me Less than 1$ ❤ ruclips.net/video/eHjgRXwwEXo/видео.html
tried mine but it always cut off
Watch my video for DIY GT2 Timing Belt Connector which cost me Less than 1$ ❤ ruclips.net/video/eHjgRXwwEXo/видео.html
This mathod good or not please tell me.
@@prashantrajput2801 i just bought a closed looped already and just add thread-less bolt on center to tension it… this is too hard to me tried every method and still cut off…
I like this method. As I saw commented on another video, cutting the belt diagonally and using a longer ribbon to cover the seem makes the meshed area much larger increasing the strength of the splice.
Watch my video for DIY GT2 Timing Belt Connector which cost me Less than 1$ ❤ ruclips.net/video/eHjgRXwwEXo/видео.html
Is that super glue?
yes
What type of ribbon?
See eye-vision.homeip.net/ecurtains-automatische-gordijnen-bedienen/
ECHT ZALIG BRO