Видео

What is the name of the glue that goes deep under the composition?

Nice video

Peel test start karne ke pahle kaun sa temperature dekha aapne aur kyo dekha and kitna temperature hona chahiye? Please bataiye sir?

Epoxy lagane ke bad kaun se instrument se epoxy ko check kiye please bataiye

Actor banna hai kya sir? 🙂🙂 nahi horah acting...😂

Bahut bahut badhiya sir ji

How can I contact to you

Hello Sir

Thank you

Also please mention ASTM standard for peel strength test

What is ISO standard related to Peel strength test?

❤

Sir please make a video of presso film in field joint coating

Great work sir

What is the norm for this test? Usually this test is carried out at 23°C, but OK, infield can deviate. Moreover, usually, you pull max possible force to figure out the peel strength. The resolution is not good, but the applied force seems to be pretty low. This product can handle way more 😉

Very nice 👍 work

Good 👍

Lol

HTLP 80 normal sleev & Direx sleev thickness ??? please tell me Sir

Dear sir, direx sleev and normal sleev melting point??

WHAT IS THE DIGITAL INSTRUMENT NAME

Good work sir 👍

Nice Bava Garu 🎉

Yes Sir quality is first of all... I'm QC Inspector 16 years experience.

I have all information about 3 layer and FBE Internal and External coating... Al Qahtani Pipe Coating Industries...

Good work sir 🙏

Very good information 👍👍👍sir

In case if you purchase this sleeve you need to purchase primer😊

v informative

You also try TSD80 Heat shrink sleeve?

👌

Thanks 🙏

Sir I have your contact number pls.

Mr.Narongsak 's Worley

Sir send me number

SIR CAN I GET YOUR EMAIL ID, I HAVE FEW QUERIES REGARDING COLD APPLIED PE TAPES

Sir I went to all notes for how to coating process

Very useful video

Think you sir

what professional qualification do you have or what position?

Shir coating me kaun kaun sa stumeant name check karane wala stumeant

So 180 microns deduct instead of 50?if so how to justify to consultant?

What? Any English subtitle pls

Good

Very nice information thanks

DEAR SIR,I HAVE DONE MY BTECH IN METALLURGICAL ENGINEERING AND DID JOB FOR 2 YEARS,QUIT JOB FOR HEALTH REASONS,NOW PLANNING AGAIN TO DO JOB,I HEARD ABOUT PAINTING INSPECTOR COURSE OF BGAS AND NACE,WHATS THE FUTURE AND SHOULD I DO IT???/NEEED YOUR ADVICE

Ok sir

Trilling experience your patience is appreciative,God will be always with you sir

Frame should be pneumatic powered. Inadequate PPE for FBE application. Poor overlap preparation. PIH perform better and that is an insult of the highest regard.

Great sir ji