Видео

Thank you for your comment 🙏🏼 yes I agree 100% the KE is a great 3D printer. Specially for beginners doesn’t need much tweaking. One can use the default values in slicer and do great job !

Yes 👍🏻 it’s going to be fixed by adding two small pieces on sides of the wholes

Thank you for your Comment 🫵🏻🙏🏼

Thanks for your feedback! take a look at the channel you may find useful videos 👀 subscribe to see maybe useful things coming in the future. What are you looking for like content? RUclips hided your comments by the way because it maybe judged negative…

@@WarriorPNG thank you 🙏! It will be a long serie building this robot arm 😅🤣🤣

Thank very much you for the support 🙏🙏🙏

Thank you for the support!🙏🙏🙏

Thank you for the support 🙏🙏🙏

Thank you for the support 🙏🙏🙏

Thank very much you for the support 🙏🙏🙏

Thank you so much for the support 🙏🙏🙏

Thank you very much for support!😊🙏🙏

Thank you very much! 😊

Thank you 🙏😊!

Thank you for your question. If you are using a raspberry pi 5 maybe the problem is still there at least the one I had in the past is hardware pwm in gpio that wasn’t working( the architecture of rp5 is not the same as the previous rp). Only the software pwm is available on rp5.. and from my investigation 🤨 the software pwm may cause the jittering. The pca9685 provides hardware pwm 🫡 I hope I was clear. Good luck !😉

Yes 👍🏻

J’ai bien reçu votre message, on pourrait faire ça

@@dsc-dev merci beaucoup

Thanks Soufiane 🙏🙏

This is one of the easiest 3D print 😂😅 but still creasy to see for the first time

Thanks 🙏

🙏🙏🙏💪🏻💪🏻💪🏻

🙏🙏🙏💪🏻💪🏻💪🏻

👍👍👍👍👍 great clear explanation!

🙏🙏🙏💪🏻💪🏻💪🏻

🙏🙏🙏💪🏻💪🏻💪🏻

Thanks 🙏 for the comment, Will do as soon as possible 😂😂 jaja

Will do as soon as possible 😂😂

😊😊😊

🙏🙏🙏🙏

Merci docteur 🙏 🙏

Many Thanks 🙏🙏

Many thanks 🙏🙏🙏🙏

Thanks for asking, however that’s another story 😁

🙏🙏

Many thanks Soufiane !❤️

Many thanks Achraf 🙏 ♥️ from Frankfurt am Main, Viva FSTS 😎!

Thanks 🙏!

Thanks ❤

Thank you ❤