Видео

Zero Waste Sculpture

Pinewood Derby Car Timer

Kinetic Sculpture Assembly

Soldering Led Strip and DC Barrel Jack

Machining Spacers

Sieg Super X3 Seized Lead-Nut and Leadscrew Replacement

Kinetic Sculpture Circuit Assembly

Bed Adhesion Tips and Slicer Setup. If you have any questions, comment down below!

Leave any questions in the comments below! Thanks for Watching! Happy Flying!

Outfitted my flying wing with a flight controller for osd and voltage sensing capabilities. I was unable to flash this board with inav as it is not supported so my control link is still fully manual.

Unfortunately, the wind was parallel to the slope, so no lift was generated, I will try flying further down the beach as the slope makes a sharp turn and juts out into the wind. Thanks for Watching!

3 person team Tallest tower, or tallest tower that can support a small ball 100 toothpicks One small tub of playdough

Inspired by ProjectFlightDesign Specs: Wingspan: 30" Root Chord: 11" Tip Chord: 9" Sweep: 9" Electronics: 2 sg90, 9 gram servos DYS Samguk Wu 2206 2400kv 30 amp ESC Flysky i6x and Ia6b 3s lipo, 850-1100mah OR 3s 18650 li-ion See prop specs in the video. Thanks for Watching! Comment down below any questions! Happy Flying!

Made from 3 layers of 1/2 inch insulation foam, tape, gorilla glue, and wood dowel spars. This plane exceeded my expectations and was able to fly for a comfortable 20ish minutes, traveling 12km. After some calculations, I predict that the plane could fly up to 20 km, possibly flying out to an oil rig or something of the sort. Subscribe for more! Leave questions in the comments. Thanks for watch...

RS2205 2300kv Motor | Thrust Tests | 2s and 3s

DYS Samguk Wu | Thrust Tests | 2206 2400kv | 2s and 3s

DIY Nano Goblin | FPV Coastal Flying | Foamboard Scratchbuild

Foamboard Nano Goblin | First True FPV Launch | DIY 75% FT Goblin

75% FT Goblin | DTFB Nano Goblin | FPV Maiden

5$ FPV Helical Antennas | 5.8ghz Long Range | Cheap DIY Antennas

FPV | California Bluffs | 5$ DIY Helical Antenna

Maiden! Sub 250g Foamboard Scratchbuild

Best Printable Ender 3 Hotend Assembly? DD-SM from Thingiverse

Useful 3d Print #2 - Caster Wheel Rubber Rim

Functional 3d printed part - kayak bilge pump handle

Best Budget Upgrade for Traxxas Slash 2wd? - Surpass Hobby F540 V2 Brushless Motor with 60a ESC

Traxxas Slash - Short Video 4 - I discovered SPORT mode finally!

Traxxas Slash - Short Video 3