Видео

You're doing about 90,% more work than necessary. Glad I saw some other videos first

Do wymiany świec i oleju nie potrzeba ściągać żadnego plastiku

Fucking annoying noise.

No se ve cuando desmonta el carenado completamente, quiza sacando solo la quilla y algun tornillo de la tapa delantera es suficiente sin desmontar todo

Where is the Oil Filter here?

If my Murano doesn't have intelligent door handle and I install an intelligent one, will the smart feature work?

Should do more videos on the bike, I have the same one and found them very helpful so thanks you. 😊

do you recall what "k" you used for the smaller LED bulb and Xenon bulb?

I recently replaced my headlights with LED’s. So easy on the Murano. The tail light bulbs are a pain because you have to slide out the complete assembly

Be careful because if you replace it and it breaks again… your thermostat is in the half open or full open… this will cause the filler neck to break…. To much pressure build-up in the system.

Thank you very much for the video

❤My Humble Gratitude For Your Clear Tut😊

How does the key lock retention screw come out. Mine has a clip on the outside and the lock won’t release

Did that today, took me about 5 hours. I followed your instruction and replaced it with no problems. Thank you very much!!!

Great Video. And thank you sincerely. BTW, where is the turn off button for the music?

Good job my friend 😊

TENGO UNA MURANO SL AWD 2004 Y NO SE SI LA FORMA DE ACTIVAR LOS NEBLINEROS ES CORRECTO. TENGO QUE TENER ENCENDIDA LAS LUCES NORMALES PARA RECIÉN ENCIENDAN LOS NEBLINEROS. ES CORRECTO ESO? PODRIA ACTIVARSE INDEPENDIENTEMENTE DE LOS OTROS?

The door handle switch inside of the door wtf

What a pain in the asss I want a regular door handle

Remove window omg to hard

Remove window seal wtf

Thanks for the information

Can I get a link to where you purchased these lights

What is the size of oil drain plug washer please?!

Very helpful thanks 👍🏻

Great video thanks alot

I’m having the same issue, did dis indeed fix your issue??

Removing the clips would be easier with the right tool. It was still very educational.

Excelente ¡!!! 😁

Very helpful video. Thank you!

How to order my friend??

All 4 of my wife's locks have gone out. Your video has helped me change out both front locks. Appreciate you taking the time to make this video

This is an excellent video.. thanks a million

Immobilizer?

Since when did cbr’ have a kill switch !

Bos it can be use in24volts in truck

Good Job, man. Thanks !

What a cool colours of tour CBR, LOVE It. Thanks.

Great video. Easy step-by-step instructions. It was much appreciated.

The terrible music is too loud. Can't hear what you saying

Make one up when you set it up that way you can see how you said it up

Great video, thanks so much.

I'm just curious about the belts lining up with the new pulley. While you were showing the part about making sure the spacing was correct on the ears, I noticed the pulley was set back a few millimeters from the position of the original alternator. Did that create any problems?

Another piece of information; the set screw usually does not fully come out, it starts slipping half way, you think the screw has been fully backed out, but it has not. So if you try to pull out the lock cylinder block at this point, it won't come out because the screw is still in the block. I got the screw all out by pulling the lock block hard to put some tension on the screw to make the thread to engage again, in the same time continue to turn the screw until it is completely out. After that, the lock block is totally free, and can be pull out easily.

BTW - removing the door panel is necessary for the keyless Intelligent Door Handle. The screw hole trick works only for the base trim model without the keyless entry feature.

Thanks for your informative vid, I learnt enough from it to fix my door, specially how to disconnect the lock rod to take out the look. Saved me a lot of headscratching.

Fragile tablet... Clone vpecker

where to buy ancel x7 obd2 scanner

Thanks for the video..

Just bought one im not keen on it to be honest I don't know why iv had it 2 days and im thinking of selling iv had no fun on it really my old Chinese 125 that was a peice of shit I paid 250 pound for and id blow the cbr 125