Видео

No

Thanks 🙏🙏

One problem comes from many reason Kindly trace again step by step cool testing of keypad raw and colom 🙏🙏

Ckeck on off switch normal working or not otherwise may be software problem Without proper checking we can't decide which part are doing problem

Dear friends money ke koi baat nahi h But it will be best for you that Contect on mobile repair shop in your nearby market 🙏

@@newjmdtrickandtech3905 Nhi krke de rha yr koi.... Isliye.....me apko courier krdu??? Ap kr dena pls... Address?

Your welcome 🙏🙏

Thanks 🙏🙏

Thanks 🙏🙏

No 🙏🙏

Its depand on experience and practice 🙏

Its depand on smd accuracy And also depand on mother board pcb Before remove shield you should have an idea that what quality of air and heat gives your smd 🙏🙏

May be jumper on wrong track Disconnect the jumper And than check cool testing

To on this device Disconnect it buds 🙏

We can use wire tape to fix it temporary Or can use Fevikwik to fix it hardly 🙏

Bro one problem comes from many reason Every problem needs different solution 🤝🤝🙏

🙏🙏🤝

👍👍🤝🙏🙏

👍🤝🙏🙏

👍🙏

Thanks 🙏👍

Power on off switch may be faulty or Battery may be weak 🙏

Dear friends this problem maybe hardware problem and liquid log problem in charging PCB in the box clean the pcb properly and than check 🤝

Dear friends 1st check with new dash cable or clean handset charging port 🤝👍🙏

@@newjmdtrickandtech3905charger ismot working I have clicked with other charger and cable

👍🤝

Dear friends you can repair it easily according to video or it will be batter that contact your nearby market repair shop Because if neckband show repeat problem than you can easily contact same nearby shop 🙏

Falcon use to loose glu which is found in some branded neckband mostly neck band having lock system so to open these lock we use different types of opener 🙏

Very sad bro जब भी आप नेक बैंड में कोई काम करें उसकी बैटरी सबसे पहले डिस्कनेक्ट करके ही काम करें 🙏

डियर फ्रेंड्स इस कंडीशन में आपको पीसीबी के अंदर जहां पर स्पीकर के वायर कनेक्ट है वहां पर gr वैल्यू चेक करनी होगी आपको लेफ्ट प्लस लेफ्ट माइनस राइट प्लस राइट माइनस दोनों साइड के वायर पहले पीसीबी से डिस्कनेक्ट कर देने हैं फिर आपको रेड प्रॉप ग्राउंड पर रखकर ब्लैक प्रॉप से gr वैल्यू चेक करनी होगी साउंड ic से साउंड आउटपुट फिल्टर coil के द्वारा यहां पर साउंड आती है आप लेफ्ट साइड के वायर के जो प्रिंट है वहां से लेकर ic तक का प्रिंट अच्छी तरीके से चेक कीजिए हो सकता है कोई कंपोनेंट मिस हो 🤝🙏

Good job 👍🙏

For batter result should use ic from scrape board 🤝🙏

Try to remove lock from one side

Fix value 270 ohms But we can use 300 to 330 ohms 🙏🙏

​@@newjmdtrickandtech3905thanks

@@newjmdtrickandtech3905 maine kai board me dhunda mujhe is value ke approx koi res nahi mila ek mila 370 ohms ka can i use reply

👍🙏

1 ohm to 10 ohm resistor can be used as a fuse In this charger 2 amp 250 volt bearing capacity fuse used 🙏

If keypad handset than this amp consumption ok if smartphone than amp consumption should be above 1 amp Change new data cable and than check 🙏

thanks 👍🙏

Dear bro same mah battery you can purchase on an electronic shop

This charger repairing not possible at home so please contact on mobile repair shop or electronic repair shop 🙏

Front se jali ke side se 🙏

Its depand on problem

Lumsum 400 to 500

Thanks bhai 🤝👍🙏

This problem maybe due to on off switch Or may be body housing rubber switch faulty You can contact on mobile repair shop this problem can be easily repair

Near by 7000🙏

Most welcome

May be battery faulty or may be some shorting in pcb 🙏

Dear friend you can courier us 💯% we will you 🙏🙏

Address pls........​@@newjmdtrickandtech3905

It's depend on charger inside condition some charger will be minor faulty they can repair easily and some charger motherboard will be heavy faulty you can take advice on repair shop without testing we cannot say proper that it repairable or not repair able

👍🤝🙏