Видео

Great review! B & W hnds down. SVS sub for sure!!!

Nice video. I just bought the Martin Logan Motion 60XTi in red walnut and love the looks, and the sound is breathtaking!

Why don’t you answer any questions?

Nice review, just ordered 2 today :)

I just bought two of these a few weeks ago and finally set them up last night, but mine are called AD-7300PA+, there isn't a 2.0 or 1.0 version on it. The sound is incredible, the Denon X6700 in preamp 7.1.6 with two 15" Tonewinner subs, incredible

Nice video, keep it up

I am enjoyed your video. I am thinking of getting these speakers. Could you comment on how inert/solid the enclosures are? Do the side panels sound thin or solid(no resonances) if knocked with your knuckles? Thanks.

Thanks for the review it’s just the advice I needed. B&W for me

i just bought the new 11 channel amp!! love it best amp i've had so far!!

Those speakers according to audioholics "Although Harman rates the Infinity Primus P363 as 8-ohm speakers, what I measured tells a much different story. These are clearly 4-ohm speakers. They appear to be tuned just below 50Hz, but the saddle points are quite asymmetric. This indicates a system tuning too low for the available box size needed to produce a more optimal response. The 4 ohm dip between 100Hz to 200Hz is a bit concerning for those wanting to use these speakers with budget A/V receivers. Even if bass managed, these speakers can present a rather strenuous load if the amplifiers in the A/V receiver don’t take kindly to 4-ohm loads. I found that Infinity employed a 4-ohm tweeter as evident by the impedance dip above 10kHz. I believe they did this in attempt to increase speaker sensitivity."

It's not a Emotiva knock off. Emotiva actually source their products and components FROM tonewinner.

FYI it does have XLR but it won't be fully balanced. It'll just be unbalanced over XLR connection. To get proper balanced ampliifer will cost a lot more

Are you still using your tonewinner power amplifier? If yes…..how is it?

Congratulations and enjoy your speakers man. These have been on my radar since they were announced. Just out curiosity, have you tried the previous line? Motion 20i, motion xt etc?

Great review I bought one a few weeks ago and I really like it. No thump when turned on . I had many amps , rotel, anthem, parasound, bryston, and more. This is my favorite.

I just got mine, sounds great! Mostly noticeable at louder volumes, i was thinking about getting a second one for atmos but i think thats overkill, ill get the outlaw 5000x.

Sorry that the comments were turned off. Feel free to comment away.

Great review thanks so much. Im glad i pulled the trigger and bought this amplifier to accompany my Pioneer LX-505 btw its almost 2,500.00 here in Australia and for me worth every penny!

Just bought this AD7300PA+ here in Australia - and its a beast! I heard every reviewer i watched before hand comment on its weight, but until I received it and unpacked it, I had no idea! Im using it with my Pioneer VSX LX505 to run my front stage Polk ES35 Centre and ES15's left and right, but I'm still experimenting with the setup, I might had the 4 height's as well to take more pressure off the Pioneer. I was initially going to use an Emotiva Basx amplifier but wanted more power. Man am I glad i pulled the trigger on the AD7300PA+

Nice unboxing and thoughts.

Is it 300 or 180 watts per ch

Thanks for your review and unboxing videos. I’ve been back and forth trying to decide on an amp for a while now. Appreciate you taking the time to share your experience with the Tonewinner. I think I’ll give Amir a call tomorrow and get one on order.

How long does it take for the amp to ship after payment?

Does it sound better than the monoprice?

How does it sound ….2 channel music listening?

@Jason Lewis Just an every day man doing a review! I like it! Not confusing at all. Straight to the point. Solid review. Did you upgrade to separates yet? Just spoke with Aamir and he said he's bringing in a new 11 channel from ToneWinner in a few weeks. Let's get some fresh content going from this channel. And an intro! Cheers!

What about their package deal! A 16ch home theater processor and a AD-7100 7ch amp for $2500; or the processor and two AD-7100 amps for $3500! Wish I would have know before getting my Anthem avm70.

Update from me I did get the new version of the 7300....excellent choice! It is running the LCR channels and the 4 height channels ....music sounds better, better separation more depth and more realistic and movies no problem running my 4ohm Linn Majik 140 as to the Anthem it is running the 2 rear channels and I am not running my 2 Emotiva mono blocks now ..just letting the Marantz do 2 channels the surround backs. I have a OPPO 205 and I think for the first time I am hearing how good it sounds for music with my DVD Audio and SACD collection for surround sound This amp will let you know when you have a good recording and a bad one....so I think it is very transparent for an amp. Depending on your room acoustics and speakers everybodys results will be different but for me in my small room 15x13 8 ft ceiling I am quite happy! Thanks again for your review it helped in my decision process and I have no regrets buying this beautiful looking and sounding amp!

Great review. Like your style. As much as i would love high end equipment, can't afford it. Need to find good quality products at reasonable prices. Really tempted to pick these up .and a preamp. I got the Denon s760h from Costco when it first launched and while decent, i need more power. It's so weak compared to my 20yr old Yamaha. And i totally get the channel separation thing. Denon isn't as clear as i think it could be. Anyway thanks, really tempted to get this. And it looks so good.

Hi is there any facial differences from the 1.0 compare to the 2.0.

Best review yet, real world, no BS. Don't waste my time with charts & graphs, just tell me what you heard. Loved the Chik-fil-A analogy!

Great review. Keepin it real. I like it. Im actually lookin at this and outlaw amps. Tough decision to make. I have a denon x6200w for now. This would help with my new Arendal speakers once I get them all. Thanks man. 😀

Hello sir: appreciate all your video- question- do you use any special circuit breaker for all your devises?my Denon 3700 h with emotive shuts down the power circuit off after couple hours of playing- planning to switch to tone winner for this. Your advise will be appreciated

This is a very good review Mr. Lewis. Not too many of those around on the Tonewinner amps. Can you do a follow up review now that you've had them for awhile? Have you had any issues and is this still a good purchase? I'm on the fence right now between the 5 channel version and the Xpa 3. Will be using it to power my front stage. Prime Pinnacles and a Ultra center.

Jason, I'd love to see a home theater 2021 tour of your setup looks great from what I can see. It doesn't have to be fancy, just walk around with your camera. Thanks.

Jason, Great review! I have the Denon x4500H also you've got me ready to buy. Thanks for sharing.

Would love to actually see pics of the internals of this amp. There is noting online. Just a half pic. Would like to see picks of the transformer. If there is 1 or 2

looks like im going to be getting these. thx for the review.

That is a pretty amp. I may upgrade from my old ATI and get it.

Hi, nice review mate I’m buying Emotiva nine channel amplifier I don’t trust this cheaper brand. You buy amplifier for at least 5-10 years I think. And it needs to be really good.

I was about to get the 5 channel last month but they dont have the 5 channels. So went to get the outlaw 7000x, now saving to get a bigger watts.

Saving my pennies! Great video!

I like your channel -- please get the tone winner preamp

Hey Jason! I to also worked that second shift..till mid night ...then up till 2 or 3 or 4 lol ..then sleep to noon or 1 ...then get up and go to work for 3 pm ...Glad to see the weekend! But getting back to audio . You are right if you want to hear an improvement in sound quality to have to have better amplification first..then go from there and of course the more money you spend on that amplification the better it will be....as told to me by my Audio Dealer who sells Bryston and Mc Intosh or Linn for example ,I was looking at the LInn 5 channel and it would cost me in Canada $5000 with 13% tax thats a lot of Canadian Cheddar to say the least. So for the rest of us that dont want to spend that kind of money ...we have to look at other options and our budget .That has been my experience with my budget ...I just try to get the most bang for my buck And with this hobby its like owning a boat ....you get what is called foot fever ...this year I have a 20 foot boat....then next year I want a 22 foot boat and it only stops when you hit your limit. So it all depends on what you want to spend and go from there.and be happy with what you have ...till the next time you get the itch to do an upgrade of some sorts lol! As I was first looking for a new receiver for an upgrade with 2.1 hdmi support and IMax and Auro 3D were some of the feature I was looking for in a receiver or a processor ....thats when I was told by my Audio Guy ...if I wanted to hear an Improvement ...I had to do a upgrade in amplification to hear an improvement ...but going his way with the stuff he has is going to cost big big bucks. So I am still going to wait and see on my next upgrade and which way to go ...if ToneWinner comes out with a newer processor with the features that I am looking for ...might go that way with some better amplification. I do like Marantz sr 8015 it does eveything that I want but again its $5000 for me to buy in Canada .Glad you like your new amp and it does help with the separation with Dolby Atmos movies as some of them are better than others ...it all depends on how they did the transfer and how much time they spent in the sound room doing the transfer...some of the reviewers on You Tube are saying if you have a bad Dolby Atmos ..try using Auro 3d because it will sound better....I dont know how true this is as I dont have Auro 3D on my Marantz sr 6011 which I have had for 4 years now. I have a LG C9 65 inch tv that is 2.1 ....thats why I am waiting till this chip thing gets sorted out ...and ToneWinner doesnt do 2.1 HDMI support on their processors ...and dont know when that will happen ....but if you are looking down the road as to what is next ...Foot Fever! lol Have a good one ! Good video ...you cracked me up when you said your dumb ass ...I have that same dumb ass! lol

Been running mine for bout a month, using xlr to a marantz 7006 and monolith 7x200 for other channels. Tone winner is excellent, great dynamics

You need to make more Home theater-related videos.

Is there a review coming? Just wondering how good or bad this amp is?

Like your shirt! Yes I like the look of their amps with the meters I also talked to Amir he is a great guy ! I first heard about ToneWinner in early of 2020 ...when i was looking for some more external power to go along with my 2 mono blocks from Emotiva which were running my 2 front channels . Great for movies.... with my Marantz which is processing 11 channels along with my 3 subs ...I was just looking for some external power to handle the fronts for movies and for music ...as I thought the Emotiva mono blocks could have done a better job when it came to music.I did a lot of research at that time on ToneWinner ...but could not find anything about them as it seems they were new to the scene ..at least its the first that I had heard of them So I ended up getting an Anthem amp for the front 3 channels (Which is made in Canada just down the road from me about 200 miles lol) Happy with the Anthem for music and movies for sure..If there had been more info on the ToneWinner amps I might have pulled the trigger on them. So I see the AT 300 pre amp processor looks good and thinking about that ..but will need at least 6 more channels of power to do my heights and surround backs. So I am still interested in ToneWinner ...but now I am waiting to see about their processor if they come out with 2.1 HDMI support The AT 300 is 2.0 HDMI support . I have a LG C9 which supports 2.1 HDMI and my next upgrade ..I would like it to be the 2.1 HDMI . Looks like you have a nice set up and looking forward to your next review!

Thanks for the unboxing. This amp is on my radar

Just ordered one of these few days ago. You right Amir is great.