![7kidsgarage](/img/default-banner.jpg)
- Видео 10
- Просмотров 83 775
7kidsgarage
Добавлен 8 июн 2007
Veto TP4B load out… and am I switching to Milwaukee low profile tool backpack?
As a maintenance man, you really need to be prepared. I have a separate plumbing box but this set up gets me through a lot of work orders.
Просмотров: 6 579
Видео
1999 Isuzu Rodeo transmission fluid check
Просмотров 19 тыс.2 года назад
Transmission fluid check with no dipstick. I lost a lot of footage on this one but I think it still makes sense.
Toyota Sienna radio console trim removal
Просмотров 2722 года назад
In my radio install video, I struggled with this trim. Here is the way to easily remove the trim
2006 Toyota Sienna radio install
Просмотров 6 тыс.2 года назад
Watch this video for correct method of removing the console trim ruclips.net/video/QVUDhTFxGeo/видео.html
2006 Toyota Sienna door handle replacement
Просмотров 10 тыс.2 года назад
Cheap plastic door handle replacement
2005 Buick LaCrosse side mirror replacement
Просмотров 10 тыс.2 года назад
Seven kids, all of driving age and own their own cars. Gotta keep them running! Door panel removal, side mirror replacement and review mirror replacement
Thank you!
This video is very helpful even though it was from a year ago thank you for making if I have any more questions about the specific vehicle is it okay to seek your guidance in this because we have the same kind of vehicle that we do and my man is a duet himself to the guy but he's a young mechanic thank you in advance
Great video! Just to offer a suggestion…..always after removing the coils and before pulling the spark plugs use compressed air to blow dust dirt and debris out of the spark plug holes.
I kinda liked the 2 screws to mount..lower window to adjust...no one counts the pollution caused by junking cars that cant be fixed economically a dealer would gouge you 600 bucks to fo that..i bet thr mirror would cost 250
Gm cars are trash
Thank you
Thanks for your insightful video
Awesome. Happened to me today
Just want to say. You did a great job explaining and providing key information . The T-30 bit called out Noting it was a capture bolt The use of a cable tie - was a simple solution I have my part - thanks for the short explanation A+ For you .
Just finished 2 adds I found masons twine worked better for me for the loop. Also in my case the retainer bolt wouldn’t go back in until I figured out that I needed to pull the plastic assembly out more . It apparently had gotten bushed inward . After I figured that out everything worked perfectly. Thanks again.
Great help. Thanks for the video!
if its electronic throttle pedal you don't give it gas when starting. I got mine directly from the factory (2000) tho and it had a note on the steering wheel not to press the accelerator while starting. Any vehicle if you turn it over repeatedly like that its going to have trouble starting.
It's easier if you start removing from the bottom. And the speaker cover from the top.
Your videos help a lot. Thank you for your help and for making these types of videos.
What was the purpose of having the car running at first but not during the topping off
What are your thoughts about what brand of spark plugs may i use for the same model?
very easy to do your self thank you for showing it takes all the guessing out of it and less chance of breaking parts
Son.......U got no kids???????COULDN'T even find the hole
Thank You
Thank you so much, you help me save some buck!!!!!❤
Since it's your daughters car and 7 kids... All i can say is... THANK YOU DADDA 🙏🙏💛🙏🙏 this video helped i almost wanna pay you for mines and your daughter with all the respect in the world
I have a 2004 Isuzu Rodeo and I put oxygen sensors cause of the engine light was on. Engine light is off now but my gear box won't go in park or reverse now.
I have a 94 model Isuzu rodeo. It's running really bad. It's not idiling very good. At2000; RPMs it starts to spit and sputter,and has no power. Now then if I turn it off and on real fast while it's running it seems to reset something and then it will run fine. It still has the idiling problem of up and down missing really bad. What can I do to fix the problem
Como va el testigo de precio aceite,?
what size torexbit does it take to get this apart
T30 will get it done!
If you have a Stihl T wrench try it it worked perfectly for me.
Your video helped me replace my mini van door handle with ease.Thank you so much for sharing your experience.
Glad it helped you
Amazing idea never thought about this
My buddy did it and acted like everyone knew to do that.
I always forget to bring mine on solo camping trips, but hell, what a great idea.
I bring a backhoe with the hydrolic pile driver attachment
Ha. Your emergency kit is bigger than mine
cant nail it then screw it
🤣
You could also use a jack hammer to drive in steaks.
I realize this may be overkill for some but I almost always have a driver with me in my emergency kit. This way those tiny stakes don’t bend either
@@nicol73 Only kidding - it's a damn fine idea... how many inch lags do you keep handy?
They were 6” but I bet 3” would have worked in that hard of soil
Where did you get the correct color of the mirror I need one for the driver side
I just got lucky and found the exact color car at the junk yard
how can I get in contact with this junk yard. I need the parts from the station wagon it look like 1983 - 1991 ford Crown Vic LTD Country Squire or a Grand Marquie. I take parts or the whole car.
I have the 2000 Holden Frontera here in Aus, its the same 6VD1 engine. If you look inside the intake manifold there behind the throttle plate there is a small tube for the EGR valve. I usually put a 2mm steel rope in the drill and run it up the pipe to clear out all the carbon. This becomes blocked on mine about every 20,000-30,000km. Note that the EGR can become clogged and not produce a code or MIL. Mine was clogged for years and there was no code or check engine light.
Get Toughbuilt bro.
I have the exact one. U’ve inspired me to do this myself. Thank you
I have a 1995 Rodeo. Different engine, but your video helps a lot. Thanks
I am curious if these mirrors would work as a replacement for a 2004-6 GTO as well? They look nearly identical at the mounts and the trim profile looks very very similar although the glass is definitely a different form/mold. So I went ahead and bought a NOS from rockauto that was a 1 day deal and cheap(21 bucks) and a mirror alone for a GOAT is getting harder and harder to find except for junkyards(where are you on this Dorman?!?!), and then its color matching etc issues to be addressed, I started closely inspecting as many GM cars same era as the GTO(even though it is an orignal Holden VSP manufactured car out of Australia, there are a lot of things that are homogenized for these cars.) Anywho, long story short, anybody have any knowledge of what I am about to try out? Thanks in advance👍👍 (oh and yes I did check cross reference and GTO only crosses to GTO's, I am leary of that though for 2 reasons...first off, the GTO was originally only produced for Australian markets and even though its a GM/ Holden produced model, maybe they shared blueprints for certain parts but they never made it into the parts catalog... 2nd, I can clearly imagine an exec from Holden and GM butting heads over production of OEM parts and Holden fighting to retain patents and copyrights in Australia and resisting any attempts at sharing part specs with any manufacturer including GM and probably Dorman too hence the reason even the mirror glass is hard to find)
Are these cars for sale or what please reply
I think it’s parts only. Once in a California scrap yard I don’t think you can even get a salvage title
Why did you shut the car off tho
Like when there wasn’t anything pour out
What about a 2007 Buick Lucerne passenger side door panel? I have to replace my passenger side mirror...Thank you for the video!!!
It should be very similar.
😻😍🤩💖👍‼️
Great video, helped a lot!
Nice set of tools… appreciate the video 👍
not a hvac tech but got a few veto bags recently. I think you'd like the tp-lc
A agree, I had the TP-XL I tried from the TP4B and it was a bit tippy because the base width to depth ratio was a bit off. I think the TP-LC with the outside pockets is a much better bag.
I have both and defiantly prefer the Veto. The Milwaukee jobsite dumps my tools way too often
Great set up!
You wanna use the blue bottle Valvoline and NEVER synthetic.
Why??
@@TheSacrificedTV in all my years with These 2nd Gen Rodeos I’ve always heard ONLY use the DEX 3 in the blue bottle and specifically non synthetic. Why, I’m not sure but it’s all over Isuzu forums.
@@williamperri3437 Thanks That's Good To Know 💯
Thank you for the video
Thanks a lot... Just knocked mine off reversing down an alley on my jobsite
Bro,you are 1 funny dude! Thank you,tho