Видео

Best I've seen on RUclips

This looked very graceful and theatrical.. Like a circus or ballet performer❤

Iconic

I always enjoy when you show up in your own videos. The people need the special appearances !!! 😂

love you dump truck!

OMG IS THAT GRANDMA SHANKLE!!! I LOVE HERRRRR SHES SO FUNNY!!! AMAZING MATE!!

OMG THIS IS WAY COOL!!!!!! MATSON SEEMS AWESOME DUDE!!!! I WISH I COULD WORK FOR THEM!!! DOMO ARIGATO MR ROBOTO!!

Correct me if I'm wrong .. White Teflon tape isn't for gas or diesel The Teflon tape goes in the other direction. I'm not a professional, but this is what I've learned over the past 25 years.

I know it has been a while since this post…but where should the nozzle point on the part with the white tip that everything is assembled around? Directly towards the center? I also removed and cleaned my injectors based on your video! Very helpful! Thanks

Hi - thanks for your video. Helped me a lot ! My DF15 did not start but the Suzuki diagnosis SW did not show any error codes and the actuation of the hp fuel pump produced nice fuel flow at the injector rail. But: I could not remove the „sleeve“ inside the magnetic stator. It was rusted in and the rust squeezed it so that the magnetic rotor was grinding - obviously rpm controlled and at idle/start the pump stopped. Best would be to grind off the touch points and assemble it again. I broke off the neck at the sleeve and crashed the sleeve (without the bottom with the thrust bearing). Some glue to seal it. Not sure what the fuel does to the magnetic winding.

Cuánto de aceite lleva el motor y el de transmisión motor Yamaha 25 4 tiempos

I know this is an old video. I have a 2017 15 horse. Hasn’t had much use. It runs great until you open it up. At that point, it cuts out and the red engine light pops on and off. Is that what yours was doing to prompt you to clean the pump?

I still remember seeing the stingrays (or something similar) at the bottom of cherry cove as a boy scout in the early 90’s. Good times.

Only thing is where I live I won't be able to get an oil filter for the upper unit

Wow that’s a amazing job you have 😮

Another year, another helping hand. Thanks .

Iwantbeltchageing15hp

Show me the picture of the oil

Good video. Anyone know if the motor pin inside the fuel pump, the magnetized section, should be offset?

Cómo se llama esa herramienta para sacar el filtro

Great videos. Any chance you could do a demonstration on how to put back together a fuel vapor separator for the same engine. I stupidly dismantled mine and am not sure how to put the pin and spring back correctly. Any help is greatly appreciated.

Thank you bro from Kuwait

Nice!!! Easy to follow and to the point! Good job

An o-ring fell out of mine and I can’t find where it goes any help?

After I did this, I can’t get mine started

I drained the oil from the Suzuki DF15 after about 10 hours. I left it in the bottle and after a few days a white precipitate formed from the oil at the bottom, a lot of it. What could it be and what cause could it be? New engine, only 10 hours old I also see that at high speeds, white smoke comes out of this nozzle near the cooling water nozzle

Thank you sir great video

I bought a new Suzuki DF15. Can you advise me what fuel to use? PB95 or PB98?

Hello I have a brand new Suzuki DF15 AL, what procedures do you recommend to get it in properly because everyone says something different??? Can you advise me how to reach it properly? Hello I mean how to swim for the first 20 hours?

This was really fun to watch. My aunt and uncle were the care takers of Camp Cherry Valley in the 70s. They also ran a sea plan and ferry business to Long Beach. They had a pin for javelina hogs, trapped lobster and caught abalone. It's remarkable how familiar it looks even this many years later.

I got water in the gas tank and the engine shut down. What should I do, it doesn't turn on? It is a Suzuki 20 HP Manual year 2022

Liked

That was cool.

Just saved my a$$ when I bit off more than I could chew by taking everything apart first…and…well you can guess how that turned out.

Great job! 👏🏻

Our Troop 199 from Redwood City, CA (SF Bay Area) came here in 1990, we had a blast. During our stay i'll never forget the canoe trip a few miles around the island to a private beach that we cooked dinner on and slept on the beach under the stars. Wild boars the size of a refrigerator roamed the beach at night looking for food. A huge pig came right up to my left side of my sleeping bag (of course I was terrified and had the sleeping bag covering my whole head). I'm sure most troops that live afar stop at Disneyland before the island trip and headed back north we stopped at Magic Mountain on the way home.

Excellent and interesting video. 👍

I changed my oil out and found a copper washer in the bottom of the waste oil, it does not appear to be leaking right now, do you think it will last 2 or 3 days and then I'm going to change the oil again, thoughts?

Do you have a link for the dock bumper used?

Really well-done

WARNING!!!!!!!!!!!!!!!!! This is an older motor he is working on. I could not find my manual so I added 1.6L of oil. Motor was waaaaaay to full. I had to drain our .5L because the newer motors only hold 1.1L (2021).

A good, honest video. Bloopers included with good info. I'm not sure, but it appeared you wrapped the teflon tape in the wrong direction for greatest success. It will work either way if the parts screw together. But sometimes the tape will begin to unwrap while screwing the parts together, a problem that is avoided if the tape is wrapped in the right direction.

Trey WINTERS

Nice explanation / demo. Thank you!

I need your help regarding troubleshooting of my Suzuki 30hp 4strok OBM

Great video, very helpful. Thank you!!!

Very informative! Do you or anyone else here know the approximate fuel pressure for a DF9.9-Df20 EFI? I want to install a fuel pressure gauge into the fuel line and wonder what guage range I should get...thanks!

Bisa bahasa indonesia

Awesome video!!!! Would have been better with more shots of me but still good work !

Thanks you're watching! Feel free to let me know if you have any other cruise moments you would like me to share. Thank you for all your support, for liking this video, and subscribing!