- Видео 9
- Просмотров 31 045
subramanian p
Добавлен 20 мар 2013
CSWIP 3.1 Chapter 12 MMAW
In this video i have explained about MMAW Welding variables current ,Voltage, Travel speed, Welding Consumables, Operating factor, Duty cycle
Просмотров: 132
Видео
Cswip 3.1 introduction of welding process chapter -11
Просмотров 1212 года назад
In this video i have explained about introduction of welding process heat input, voltage, current, polarity, power source characteristics (constant voltage) (constant current)
How to draw DAC by using using 19mm SDH block70 degree Olympus Epoch 600 Ultra sonic flaw detector
Просмотров 14 тыс.2 года назад
In This Video I have explained How to draw DAC by using 19mm SDH block with 70 degree angle in Olympus Epoch 600 Ultra sonic flaw detector
surface profile measurements calibration by using surface profile needle gauge
Просмотров 1262 года назад
in this vedio surface profile measurements calibration by using surface profile needle gauge
surface profile measurements calibration by using dial indicator with replica tape
Просмотров 1,4 тыс.2 года назад
in this vedio i have explained surface profile measurements calibration by using dial indicator with replica tape
Ultrasonic angle probe v2 block calibration by using olympus epoch 600
Просмотров 15 тыс.2 года назад
in this video I have explained about following calibrations and how to use the olympus epoch 600 flaw detector exit point range calibration verify the angle of beam & sensitivity
