Видео

I think I found the answer,it should be a 26pin to rns 315 running to tailgate(and should be seen be removing the trunk handle)?

Theoretically from anywhere, but using the rear light it will start the camera only when you drive backwards , since the light is on. Otherwise no supply will be available

@@fikovele i tried directly from 12v , but seems the original cable its a little bit different, except the cable with 26 pin, have 4 more outside the cable red 12v, black - ground, can high can low. from what i read on forum, because i have parking senzor i need to enable from vcds from both, navigation and parking assist, but doesent display anything. any recommend? also when i put in reverse display me on the navigation senzors and black screen where should apear the video, but nothing.

@@edypaul13 but I also use original cable and all parts are original. Keep in mind if the camera is enabled then the sensor display will not be shown only the beeping sound. Try to stop displaying the rear sensors, only the sound on.

hoffe es bringt was :)

@ Hat es. Läuft wieder sauber und leise.

Wegen der andere Baustelle 🙂

@ 😂😂😂😂

Je kunt een kant-en-klare deur kopen het is duur maar gemakkelijk

Oko 1 kg po satu, ali to ovisi od senzora i kako se nastima da se pali. 24 sata u komadu mi puno, 18 h je po meni dovoljno.

@fikovele Ok hvala na infu... Moja potrosi za 12 sati cca izmed u 2-3 vrece... Cini mi se puno,posto moj prijatelj ima Centrometal 35kw,kaze da za 15 sati potrosi max 2 vrece...

@@Thetimeisnow13 onda je nešto pogrešno kodirano jer je to puno, možeš da staviš referentnu temperaturu a možeš i preko vremenskog šaltera da se pali -gasi

Also wenn nötig dann ja, meiner wurde vor kurzem getauscht. War relativ sauber. Mein Kessel war verschmutzt, letzte Reinigung gegen 2010..

You mean these in 3rd min of the video? Camera power supply ?

@ yes , can be power from everywhere? also the last wires from the video on rns315 . That cable its very expensive.

Very Good information!

Hehe yes that's correct. Actually the whole point is to look like a Tesco guy.

​@@fikovele I Changed the original lamps because they have bad brightness in sunny weather compared to other turn lights in car. The ambient ones are better. The question is for how long they will work. Last year I changed the bottom mirror lights and one failed like 2 months after.

Chinese products are like that, work randomly, fail randomly, the argument is they're cheap

Not really sure but the beat is good

Not really, I guess he is only tricking people 🙂

Hallo, nein muss man nicht bzw verbrennt. Viel Spaß bei der Wartung

Yenimahalle, actually all buses will land there eventually. But check it on Google maps

Thanks a lot

@@fikovele you're welcome

I used hard steel wire to poke through it and screwed out the cable. But it might be that it causes some minor damage

M.green but they're the same everywhere

Thanks for the comment. Arrived around 11am. Almost 4hrs fighting for the tent, and the opening party was at 7-8 pm. I think you will make it, good luck and good time there 👍

I think Friday noon

Bro it was a pleasant experience, I really liked it, considering the fact was the first time there. Many things to see and to enjoy. I missed the lotus temple and for that feel incomplete

Ovakva priroda opušta oči i dušu, 10 puta bolja terapija nego bilo koje tablete,🙂

Glaube muss passen da es um P21W handelt. Aber Fehlemeldung wird sich zeigen wenn die nicht 21 Watt sind, da die nehmen mehr oder weniger Strom, nämlich der Sensor erkennt das Unterschied.

Wurde Kamera bereits mit 315 installiert? Hast du nur auf 510 gewechselt?

Hi Problem gelöst. Ich hatte davor auch ein RNS510 drin ich musste nur per VCDS Rear Kamera aktivieren und auch Low Kamera wenn nur eins von beiden aktiviert ist funktioniert das nicht finde ich komisch aber egal es läuft wieder 😂

@@mirsad1583 gut zu wissen, vlt hilft jmd weiteren

what do you mean legal and where are the headlights ? this is purely daily signal light. for the main lights and led you need a licensed light bulb (e.g. with certificate), but even without it, many people use them normally. with this one no problems at TÜV

Ma izbacuje mi grešku na pasatu b7

Ako je sijalica bez otpornika onda ga moraš posebno kupiti i spojiti na kabal u seriju s sijalicom, znači moraš grlo izvaditi i crveni kabal izrezati i dodati otpornik pa ili zalemiti ili klemati

das wäre alternative, aber man muss die abdeckplatte wegmachen

D3S hatte ich schon, hab so das auto verkauft, LED ist sehr stark. steckbirne g8 habe ich noch nicht bei tageslicht gesehen

hi, i have not connected it. the cable is connected to the puddle light (that one below the mirror) cable. but you have to cut that cable and connect it (i think also green color but unsure). I didnt want to cut any cables and left it without that blue light

mislio sam da ovo gledaju samo oni iz bihaca :) iduci put stavim vise texta i opis lokacija.

correct, i have not. this is connected to the puddle light (that one below the mirror) cable. but you have to cut that cable and connect it (i think also green color). I didnt want to cut any cables and left it without that blue light showing up for 3 seconds.

@@fikovele oh. So it’s just somesort of a check wire and not needed for the actual turn signal?

yes, its not required and i personally do not like it (looks like flashing commercial in Chinatown).

@@fikovele oh, okay. Thanks for the extra info. Might do the same on my alltrack. Have you changed the front and rear turn signals for LED as well? Or are you running regular halogens? Was thinking about swapping them out as well if i’m doing the mirror turn-signal swap.

with front and rear you have to be careful, since the computer might detect a supply error and pop it up. i think there you might need extra resistance in series with the bulb to avoid it.

Hi man, you heard correctly. Even sometimes vendors write compatible with OEM parts it's bullshit, you might use some android version of the display then connect camera. Often they come with RGB connector . Try getting OEM camera or simply switch to Android unit and then use whatever is available.

Eigentlich hab ich nicht, kam sporadisch ab und zu, aber macht mir nichts, so wurde verkauft und gabs keine Probleme. Die Lösung ist Wiederstand mit der Birne zu verbinden (gibt bei eBay 2e /Stuck) , also man muss Anschluss Kabel rausnehmen und in der Leitung in Reihe anlöten

hi, its very easy, just go there and ask for it, choose a locker size and pay in the end.

hi, what link ? to purchase the light ?

@@fikovele Yes, the one you've linked to is only german amazon site

No prob bro, hope you have a good time there

This was in the late April , spring time is the best time 🙂

Thank you. I am planning to travel in April.😊😊

Wonderful, probably it will be less tourists there so you could enjoy better. Have a good time 🙂

Nice choice, but hopefully will not be so cold. Enjoy the old town and mountains outside like Trebević 🙂

Thanks

Bro glass is forbidden, cans are ok. Staklo nije. 🙂

glaube es ist klar und deutlich, dass keine Fehlermeldung behoben wurde oder kein zusätzlicher Widerstand hinzugefügt wurde. man kann das machen aber Watt-Verbrauch bleibt unverändert. Für meine Zwecke hat sich gelohnt

Hola, creo que este es de 0,9 kW o 1,2 hp.

Ist ähnlich, rns 510 passt aber ist auch 150e mehr teuer. Leider VW macht alles kompliziert um so eine Nachrüstung durchzuführen ohne VW Werkstätten, die Plastik Teile sind auch schwach leicht zu brechen . Aber auf jedem Fall machbar

Ok, danke für die schnelle Antwort! 👍

Later I did rewiring with proper connectors, but that's not in the video 😅

Hehe dobra namjera,ali nema organizacije na lokalnom nivou da se takve stvari omoguće i sprovedu.

@@fikovele e moj bosnjak, mi svi odustali.. imas fin kanal, na pravi reportazu da vidis da li bi ko htjeo da uzme Tu inicijativu.. pa nek narod malo glasa I neko ce I htjeti