- Видео 8
- Просмотров 1 376
The Apprentice
Австралия
Добавлен 3 окт 2021
SPID Rotator Controller MD-02 Firmware Problem
Documenting the problems with SPID Rotator Controller MD-02 Firmware V2
Просмотров: 394
Видео
BF20LV Z Axis
Просмотров 633 года назад
A look inside the BF20LV vertical axis. Thanks to BaronJ from metalworksforum.com for his contribution to this video.
What is you motor frequency set to?
Hello, what material do you have a supporting horizontal tube in the rotator? FiberGlass?
Fibreglass tube, 50mm. Sourced from a safety handrail supplier.
@@thehamradionook1301 Thanks for information.
Hello great videos. Are you happy with the mill as I am thinking of getting either 20lv or hafco hm46. Still looking at pros and cons
It is a small mill and therefore has some mechanical limitations. A 50mm face cutter is fine on Aluminium but not so good on Steel, even a 20mm end mill on steel is a challenge. If you have the space available, get the largest mill you can afford.
Any recommendations to control this programmatically ? Tried the Rot2prog via USB for the md 01 but failed. Any resources?
I have written my own driver. The protocol documentation is available on the internet.
@@thehamradionook1301 Is it possible to download the latest version of firmware for MD-02 somewhere on the Internet?
@@ok2slc147 contact the supplier of your SPID and they will provide you with a download link.
@@thehamradionook1301 Do you remove my comments?
@@ok2slc147 No, all comments are still there