Видео

Tim - great job!!

Bill - you do a great job in these videos!

These videos are great!

Cousin Joe was the BEST!

Great website!

I laughed. I cried. I watched it again and again. Two thumbs up! Fun for the whole family.

This is a great video on a great company.

Great content straight to the point appreciated your time.

L7224...tiene un Err10...como solucionarlo..por favor..

👍👍👍

What a your recommendation on hot water temperature on a hydronic boiler for a two family house.I have no zone valve

Excellent Video! Thanks so much,

excellent video definitely saving this to my hvac education list thanks

Great video. Thanks. ☘️☘️☘️☘️☘️

Can I buy directly from Neuco, Seems like Bob is an unnecessary middle mad

Can you give some example of tools using Belt Tentioning

Excellent video on how this pilot system works! One edit - intermittent is spelled incorrectly on your opening slide! Thank You! 🙂👍

What would cause the sensor on a L7224 to fry. I have had four L7224U units in the last four year and it keeps coming up with ERR 1 Code and sometimes and ERR 6.

thanks for the video, I have the L8148E, and I want to change my thermostat for the RTH6580WF. I only use the heat and my old thermostat works with two wires. where you should connect the wires for the other thermostat. Thanks

The Honeywell website Tech Support page is down. How can I contact you?

awesome

Thank you for the training module.

I like these better than hot surface ignitor. I wonder if this dude is still around? This video looks to be from the 90s.

Thank you so much for these videos your a great help!. Please make more videos!

Clear. Understandable . Even for a non serviceman. Holy cow!

Excellent Video...

Can the L7224U replace the L8148a1017 and be more reliable?

Hi

my burner ignites but the spark does not go out

can't find the other two lessons thanks

Beads are better- That's all I see here why not make a more compelling case than that to use this over the catch-all solid core filter dryer.

are all honeywell pilot burner with orifice the same thing

Excelente video

I get spark and pilot. Cleaned flame sense rod and no 24 volts to main valve . I don't have a meter that can read micro amps . Should the flame sense rod read 0 ohms from rod to connector. What out put voltage is the flame rod suppose to sink.. It reads 20 volts ac at the module .I read 4 volts at the flame rod ,but it restarts the igniter ... that was yesterday.,, Today I wiggled the flame rod connector at the module and main gas burners now work. I am replacing both module and pilot assembly that are 27 years old,but realize how little I really know about the electronic architecture of a any module.Since the boiler burners were submerged from a cellar flood I removed and cleaned every thing ,burners ,assembly ,etc. . The small amount of resistance from my meter prevented ignition, I wonder if it was only residual moisture. A good service tech would sell a new boiler ,but it is mine and it feels like I installed only yeaterday

Thank you so much for the information. I needed the main valve pilot valve jumper. You are awesome.