Видео

Yeah, going through the wheel well was little easier, but 140,000 still going great

Yes, what a pain in the ass! Great vidieo, I have a 2012 and the damn frame is right there

Thanks for sharing

I have a 2009 2.4L Suzuki Grand Vitara that the engine was switched with a 2012 Grand Vitara engine....I dont know where the Coolant temperature sensor is at. Any idea that you can give me so I can change it. Thanks for any reply

Where you find that seal?

Chrysler manufacturer suggestions to use coolant made from HOAT for this specific engine. User manual states the same. Good video though. 👍

The voltage signal is a pulse wave and service manual says to read with oscilloscope. thanks for sharing

What is the main cause of that?

Is the pass side as easy as you made it look for the drivers side ?

What's the fluid type you use for that?

The castrol transmax universal atf/cvt is great stuff. Been using it on my 2019 civic coupe 1.5t since 20,000 miles. Im at 87,000 now and still feels great. The fluid is very inexpensive, and the drain and fill is super easy I just do it once a year.

Hi , how did this defect manifest itself, did it bang or creak ? Thanks .

Was it necessary to remove the top bolt?

Yet another thank you. I'm handy, picked up mechanics set and went to work. Even though it was my first time doing a 'major' fix, everything was pretty intuitive to put back together. I didn't watch the rest but happy you kept filming to put everything back together. Thanks for the video!

Have you ever changed a tire pressure sensor on a 2014 Cadillac srx

754 pm.. Wednesday......I got a p0845....

How did you mount the reservoir to the top like that? Thanks.

14:45 looks like the oil bypass valve clips came undone. The spring expanded slightly. Did the plastic part shoot out somewhere? Hopefully not down into the oil cooler. 😮

what does Autel charge for the update?

You accidentally put windshield washer fluid in the coolant system, didn’t you? 😂

do you have link for the bolt you broke? i made the same mistake 😒

Does it have to be Reset using scan tool??

What's the difference in " Oil Pressure Sensor Circuit LOW vs, Circuit HIGH ? Does the car behave differently?

a big thank you. In my case the rubber boot on the ball joint on the propeller shaft is broken and that is where my transfer case oil leaks. Everyone say the prop shaft must be replaced. I wish I can buy a cardan suzuki grand vitara prop shaft to replace the suzuki one, but it sold all the way from south america. any advice? i live in Accra Ghana. see ruclips.net/video/Pm_AGD_6Glw/видео.html

I'm pretty sure that the yellow rubber/foam should have stayed inside the sleeve, just the way it was when you first unpacked it. The yellow part should not have come out from inside the sleeve. I just did my 2015 sienna rear shock absorbers and the sleeve also has a similar yellow/orange bumper inside, it is not removable. The rest of it you got right.

Is it possible to put a manual lock onto one that has a power lock?

Nicely done. A 3/4" wrench will work, since it's barely bigger than a true 19mm. Another guy on youtube showed using a large crescent wrench at the end to add torque. When the crescent wrench is closed it feels very secure. Also, a non-offset wrench helps a lot.

what’s the labor cost on a job like this

This was no help at all

Great video.. saved me a lot of headache.

Is there a reason why didn’t replace the tensioners?

Any idea if this could cause a slight misfire on cold start? I’ve replaced plugs and wires but still experiencing a slight misfire. When it’s warmed up it basically goes away

No glovebox removed... ruclips.net/video/VBwc2mma8Ns/видео.htmlsi=dvimKzkB4Pi-DKW7

😮I've seen this fan motor replaced without removing all that other stuff just from the bottom and airbag out onlye... it's in another video on RUclips

Many thanks. I've just managed to swap my blown low beam for 2010 Santa Fe which has a similar set up to yours than the blue dot and twist on most videos on RUclips.

Great video- thanks!

Thank you for video. At least you showed the problem getting the abs sensor out. Other videos did Not show this.❤❤❤

Sorry to be a bother but on these lites you just install how is the light beam and adjustment on light beam

Gracias maje

Good video

Hello, "ustDoItYourself" I was analyzing your channel and saw that in your channel have some problem, That's why your channel is not much growing and not getting much engagement, If you can solve these problems, Your channel will grow like a storm. If you tell I can tell these problems. Where can I tell? Here or ig or where?

thanks for the instructional video to flush the power steering fluid. At the end of the video, the last shot of the Reservoir shows dark colored fluid but probably not as dark as what you started with.

Part number

Today i get problem with my throttle after use smoke machine😂 its like motor dont want to open throttle 😂 dont know what now

Can you program a new cluster?

The electric pump how are you connecting the part that goes into the power steering pump container? i have a electric pump like that but i cant figure it out. how it connects

Is the cover important to the functionality of the motor or is it simply for extra protection

What is this part specifically called?

Would this work with the 2009 Volvo V70?

Help me this morning at 5am a real hero👍👍