- Видео 39
- Просмотров 322 539
3oh
Добавлен 20 дек 2006
Glock 43 ETS Magazines
The seven and nine round Magazines for the Glock 43. I know I called them ETC, oops!
Просмотров: 5 433
Видео
Glock G26 and G43
Просмотров 907 лет назад
My wife and I took my new 43 out for some break in shooting. She’s shooting her 26, then I’m shooting the 43. I wanted her to get some time with it also she didn’t like it as much as I hoped. Oh well she’s doing great with hers.
Traxxas Rustler, Viper VX4.39 Copperhead
Просмотров 2 тыс.11 лет назад
My XL-5 Traxxas Rustler that I Installed the Viper VX4.39 Copperhead Brushless Combo. SPC, 5000mah, 40c Lipo. The Motor is 4pole, 3900kv. Hope you enjoy the Video.
Jconcepts Illuzion body for Traxxas Rustler.
Просмотров 4,8 тыс.11 лет назад
Showing the Jconcepts Illuzion body for the Traxxas Rustler.
Traxxas Rustler XL-5 Speed Runs.
Просмотров 41 тыс.11 лет назад
Speed Runs on a Bone stock XL-5 Traxxas Rustler with different Pinion and Spur Gears.
Supercharged Ranger
Просмотров 3 тыс.11 лет назад
Messing around at this year's Ranger meet in Acworth Ga.
My Edited Video
Просмотров 7111 лет назад
I created this video with the RUclips Video Editor (ruclips.net/user/editor)
Switch Easy Tones & SGP Slim Armor iPhone 5
Просмотров 1,9 тыс.12 лет назад
These are my Two favorite cases for the iPhone 5 and thought some of you would like to see them side by side.
Waterfield's iPhone 5 Jacket/Sleeve
Просмотров 10012 лет назад
This is a sleeve type case from SFBAGS.com. You'll love it if you prefer a pouch case.
Breaking Down An Eaton Supercharger
Просмотров 223 тыс.16 лет назад
Breaking Down An Eaton Supercharger
A little not safe flailing around during load
i love when a video tells me exactly what i need to know, and nothing els. ty good sir
Can you shed any insight about the gray coating on the blades ?
What gears you use and where
3.73 and what do you mean by where?
Where did u order it from?
Great video!!! So.. what gearing to hit 30mph
I’m getting these on my 94 gt
How did you know it needed new bearings?! Did it make a noise?
Clean ranger man I want one just like this. Should of came factory like this, svt ranger .
I tape the cell phone underneath the chassis and I promise it won't lose control because the geometry will remain the same not causing the car to get out of control
I have the XL-5 86/28 gearing. On 2s 80c Lipos, with street tires. hits 40mph
How much Power did you get out of her?
It looks way faster than 22 mph though, possibly the measuring wasn't correct?
Can I puke?
I want videos like this in my life more. This was insightful to me. 12...years...l8er...
Do you recommend changing your supercharger oil?
yours still work for nissan?
What year is the truck and did you have to add longer wheel studs to get the cobra wheels to fit up front?
Why is the back so tall
Badass truck! Im not too far from acworth myself 👌
Thanks Man, it’s been a fun project for along time! We used to have ranger meets down your way. About time for another.
Ow loud intercom lady
Dude are you focking kidding me
You dissgust me how why'd you feel if you were shot
David Wilson It was hit by a car.
Fuck off why are you even watching this
Did u have any proplem putting tha front wheel on ur ranger. I have 1995 ranger and I'm trying to find tha easiest way to put some FR500 wheels on tha front. Could u please give me some idea what's tha best safest way to make it work.
Larry Smith I’m running 1/4 inch spacers with this set of wheels to clear the center of the hub. Some wheels will require an inch spacer.
thank u 4 your video, it has been very helpfull 4 me because im going 2 hav my m90 ported & hav 2 disemble it prior to dropping it off , if u think of anything i would need 2 know please do not hesitate. thanks again!
Can t run mine on 3s the led fash red and green
Use it in NIMH mode
at least the deer went to heven.
today i bought a Rustler
That's a Bad Girl!
badass man, thank you
Love this video. Because of this video it sparked my interest to see how fast I could actually make this setup run. We have now made a challenge that has people all over the country trying it out. Thanks for making a cool video.
LightningDad13 glad you liked it Bud! Had a lot of fun building speed with that motor.
I thinking about to buy this car. I read that it run up to 35mph (56kph). You have tested it with 86T Spur and 28T pinion and it liked to be fast, but i´ve a question for you: Had you the real percepception it was very fast? or just it was some fast?. Thank you.
Enrique Fernandez with the Brushed Motor, the Rustler is fun but not too hard to handle. I’d recommend staying with the brushed motor to bash it. It’s way faster with a Brushless motor.
thanks for the video.
Posi is a gm term ford uses trutrac or trac lock
looks real good.
when putting everything back together (serpentine belt)do you need to set the charger in a certain timing with the engine? or just put it back together ?
No synchronization necessary...just mount the supercharger to the intake manifold using a NEW gasket; afterward, simply attach the drive-belt & you're done!
looks like a very simple rebuild. why is it not recommend to open it? looks easyer than a starter rebuild.
the replacement of bearings on these superchargers requires a press and knowledge that the average DIY mechanic doesnt have.
So you much take your car to a dealer shop and replace with a NEW $5,000 UNIT.
mine goes 34 with the high speed pinion gear included lol
with da stock battery
btw i love your accent
hopefully getting one soon
Great video!
so was the stock gearing not fun?
Good for bashing and racing offroad
What app did you use to detect the mileage????
the way he handles this precise machine is why i would never take a car to a mechanic
Well you weren't listening when he said it was a junk charger and that he wouldn't attempt to take it apart if it were good. 01:40 is where he says this.
Where do the two nipples go to on the actuator?? I have a m112 and how do I tell on the actuator which one is boost and vacuum? Thanks
man that looks faster than what its reading. not sure if thats accurate
Agreed for some of the runs
The Needle Bearings Were bad, I fixed this particular Blower later on. Coupler was fine.
How do you tell if the needle bearings are bad?
3oh How do you know if needle bearings are bad in a m90 supercharger?
3oh How do you know if needle bearings are bad in a m90 supercharger?
I know this is late but I'm new to rc and I was wonder what you did to make it go 33mph I didn't really understand it
CuddlesTheCobra look on RUclips your car came with at least one spare gear and you can put that gear in look it up if you need help and get a 2s limo and you should reach at least 30 with stock motor
cant wait till I get mine
hey man, just thought you might want to see your comment from 3 years ago, did you ever get it?
if put big batter on three sell should get better results
Andrew Steger u can’t put a 3 cell on a brushless motor😂 and learn how to spell
very nice home that you have there wheatjr. All the best. Your supercharger video was great but too short.