Видео

finally wrapping up installing the new transmission and turbo in the gs300 and building a new downpipe.

I finally fix my bad fuel level sending unit. Also show the I moved my coils and fixed my ignition problem. Then take a quick rip in the z.

Finally tuning the z31 after installing the megasquirt and 62omega turbo! I run into a small issue but push through and get the car mostly tuned.

Finally fixing my turbo gs300. After letting the car sit for a few years because my transmission failed im finally replacing the transmission and replacing the turbo. shauns s13 - www.youtube.com/@2JZ_S13

After installing a different turbo into my z31, I find out shortly after installing it that the oil seals in the turbo are bad. So its time to replace the turbo again for hopefully the last time. I chose to use a remnant performance omega 62 turbo (g30-900). Now it is time to get it installed and make any changes to the car to get it installed. remnantperformance.com/products/turbochargers-and-...

What I'm working on and working towards. PRE-ORDERS for the DOWNPIPE ONLY for 1984-1989 Z31: Z31 3 inch stainless steel turbo downpipe for factory turbo with O2 bung for wideband, from turbo elbow to catalytic converter for VG engines. Cost: 350$ shipping Limited to 10 orders at this time, and pre-orders are open until 12/10/2022 or the first 10 customers. US lower 48 ONLY Paypal invoice/reques...

Finishing the 3.5in stainless exhaust for my 87 300zx 2 2. Listening to it at cold start and revving it once warm.

I show some driving clips from when the new turbo was installed. I start building a 3.5in exhaust using vibrant performance parts.

Finally finishing the install of a GT35 in my Z31. I get the flanges swapped out on the turbo. I make a few mistakes along the way.

I have decided to change turbos on the z from a s366 to a gt3582r. Things didn't go as planned with switching turbos.

Finished rough installing the ms3 gold box in my z31. Finally getting the car started up with no cam fault and figuring out a few problems along the way.

Getting the megasquirt harness laid out in the engine bay and figuring out where to place the sensors and coils. Getting the harness wired up with the additional wires for all the additional sensors and looming the harness.

FINALLY Removing the Nistune from My Z31!

Installing a RYFT Exhaust On an Aventador S

The end of an era? Time to get rid of the nistune!

Test Driving the Z After The New Downpipe!

Pontiac Solstice Blower Fan Repair

The secret to a fast supra!

Whipple Supercharger Install on 2017 Mustang GT

Z31 DOWNPIPE FABRICATION AND WELDING

How Much Power Does My 2 2 Z31 Make Before Big Changes?

FINALLY the Z Runs...

How to Install Bee R Rev Limiter on a Z31

I SAVED MYSELF FROM HAVING TO BUY NEW INJECTORS

WHY DOESN'T MY Z31 RUN... Part 2

WHY DOESN'T MY Z31 RUN... Pt 1

Finally Getting My First Turbo 300ZX..