Marvelous Tint Solutions
Marvelous Tint Solutions
  • Видео 21
  • Просмотров 49 833
2024 Mazda CX 90 window sweep removal(Don't remove door panel)
This video will show you how to remove the window sweeps from the front and rear door roll down windows. The tools that worked well for us were a small flat head tip screw driver and a plastic panel popper from Harbor Freight. Once you get the 2 screws out from each panel just pull from the front top side of the door panels and release the first 3 or 4 from left to right. The far sides on each panel have a different clip which releases by pulling up from the bottom. We advise against pulling the door panel completely because it has the same bad setup that the 2004-2006 Honda Accord 4 doors had. The plastic keeper for the interior door handle release is pron to breaking. It's metal on plas...
Просмотров: 1 574

Видео

2022 Jeep Wagoneer Sweep removal
Просмотров 8902 года назад
Welcome back to the channel! I meant to get this out there sooner, but here it is. If you are tinting a 2022 Jeep Wagoneer, this hack will help you remove the sweeps from the doors without removing the whole door panel. Don't forget to clean and lube your sweep with some soap and water before reinstalling. Tools used: Tiniest Flat head screw driver or slightly bent pick 10MM Driver Plastic Bone...
Door Panel Removal 2021 F 150 Limited
Просмотров 2,6 тыс.3 года назад
This is the full detail How to for removing the front and rear door panels of the new 2021 Ford F150 Limited and Trim lines below. For window tinters, the 3 second process of removing the window sweeps is all over for us. It is not like the 2015-2020 F150s, 250s and 350s. Enjoy and thanks for watching. Don't forget to subscribe. The master tech in this video goes my mike_magzz on Instagram give...
Cars and Coffee Folsom 1/30/2021
Просмотров 873 года назад
Drone footage of the event at El Dorado Hills Town Center. The drone used was a Holy Stone HS720. It's a beginner drone from Amazon. We have had about 10 hours of air time with it since purchase with only minor control issues. If you watch whole video or skip to the end you will see it take a quick left, flip over and be picked up. I had to manually shut it down with the power button because it...
2021 Genesis G70 front emblem removal
Просмотров 2,4 тыс.3 года назад
In this video we explain how to remove the front emblem and expose that there are alignment holes behind the emblem. Therefore a 2020-2021 Genesis G70 cannot be fully debadged. After you mask around the emblem, take the heat gun on the high or low setting and fan over the emblem keeping approx. 3-4 inches of distance from the emblem. Keep the gun moving, once it is all hot to the touch, take th...
2019 VW MK7 GTI front emblem install and removal
Просмотров 2,8 тыс.3 года назад
This video will show viewers what the back side of the emblem looks like and where to start with removing it. It also show re installation. Pardon my commentary, I just wanted to get this info out there. No Flathead Screw Drivers! Aside from plastic pry tools, I put a link in the decription of the best tool for prying on tight fitted emblems. The rear emblem you can pry apart without removing a...
No Plotter: Fastest tinted 2020 Green Audi RS5
Просмотров 833 года назад
The Fastest window tinter in the world tackles a 2020 Audi RS5 door and quarter windows in 28 seconds flat with a break in between. This is a hyper lapse video using Nest. Check out his prep and protection of the interior panels. We used Geoshield Pronano Ceramic window film. Check out our website: marveloustintsolutions.com/ Tint your car with our Visual Tinter App: marveloustintsolutions.com/...
Creating Corvette Shark Teeth for your vehicle with Vinyl
Просмотров 1604 года назад
The video explains the process in creating a set of teeth with vinyl for a vehicle. The kit pictured will fit C6 Corvettes Z06, Grand Sport and ZR1 and can be customized further. Comment if you are interested in getting a set made for your ride. #c6 #corvettes #sharkteeth Share this link ruclips.net/video/9Mf41a6br9g/видео.html Visit our Website marveloustintsolutions.com/ Follow us on Instagra...
Dodge Challenger Custom Vinyl Tail Stripe Kits
Просмотров 1634 года назад
Dodge Challenger Custom Vinyl Tail Stripe Kits
C8 White Corvette Window Tint with Custom patterns by hand
Просмотров 4304 года назад
C8 White Corvette Window Tint with Custom patterns by hand
2019 Corvette C7 ZR1 Door panel and Mirror Removal #howto #c7 #corvette
Просмотров 9 тыс.4 года назад
2019 Corvette C7 ZR1 Door panel and Mirror Removal #howto #c7 #corvette
2017 Mercedes Benz AMG G550 Brabus Paint protection has amazing healing properties
Просмотров 344 года назад
2017 Mercedes Benz AMG G550 Brabus Paint protection has amazing healing properties
2019 Audi Q7 Quattro front emblem removal
Просмотров 6 тыс.4 года назад
2019 Audi Q7 Quattro front emblem removal

Комментарии

  • @colettedubose
    @colettedubose 16 дней назад

    To confirm, just heat it up and use a tool to gently pull it up? Do the new replacement have adhesive on the back as well or we must apply our own? Thank you!

    • @MTSSacramento
      @MTSSacramento 15 дней назад

      In a sense, yes. Keep the heat moving though. We just applied new double sided tape, if you buy new ones they should come with adhesive on the back already.

  • @HighEndDetail
    @HighEndDetail 19 дней назад

    Very helpful thank you

  • @PrayingPanda
    @PrayingPanda 2 месяца назад

    You realize this is illegal and if you get into an accident, especially at night, you'll probably be blamed for low/no visibility.

    • @marcusdramis
      @marcusdramis 2 месяца назад

      I don't think that is accurate at all. Car manufacturers are not blamed when people get pulled over for speeding.

    • @PrayingPanda
      @PrayingPanda 2 месяца назад

      @@marcusdramis car manufacturers put tint that is within the legal spec. This clearly isn't. That's the difference.

  • @mariomontoya8939
    @mariomontoya8939 2 месяца назад

    I don’t understand why you would post this if it looks like crap

    • @marcusdramis
      @marcusdramis 2 месяца назад

      The patterns are ready for install. There are not installed yet.

  • @alexvillalobos7137
    @alexvillalobos7137 4 месяца назад

    Dam so I replaced the window but now it doesn’t want to roll up. It rolled all the way down at first and now it’s stuck at the bottom

    • @MTSSacramento
      @MTSSacramento 15 дней назад

      It sounds like it's not in the correct position.

  • @alexvillalobos7137
    @alexvillalobos7137 4 месяца назад

    Some tabs are so strong I always have a flathead wrapped in tape to pull some things

  • @rleader1
    @rleader1 5 месяцев назад

    I am about to do this. Why do you need to remove the window seals? thanks

  • @tonysautosalondallas7511
    @tonysautosalondallas7511 5 месяцев назад

    Thank you ❤

  • @oliver10041
    @oliver10041 5 месяцев назад

    Thanks for sharing 👍

  • @loyvandiver7844
    @loyvandiver7844 7 месяцев назад

    Great youtube University video. Thanks brother.

  • @TheAntiFurrySoldier
    @TheAntiFurrySoldier 7 месяцев назад

    I thought i was gonna get rickrolled

  • @MTSSacramento
    @MTSSacramento 7 месяцев назад

    There is a 2 sides toilet paper despenser that goes in there. I always remove them it makes install a dream. And I can do this.

  • @Setyjo
    @Setyjo 7 месяцев назад

    Why the hole tho 👁👄👁

  • @Reels2Elation
    @Reels2Elation 10 месяцев назад

    This video came in clutch thanks!

  • @steviel2118
    @steviel2118 Год назад

    what a retard video

  • @kylejones9910
    @kylejones9910 Год назад

    Stupid question for you Brother. Does either of those fillers come out to mount Euro Plate?

  • @stingk5295
    @stingk5295 Год назад

    Great Video!

  • @stingk5295
    @stingk5295 Год назад

    Great Video, I am looking to install Smaller Base and a Mid range in that same Slot also sound deadening materials !

  • @tommyd8813
    @tommyd8813 Год назад

    🙈 promosm

  • @jayboogie7956
    @jayboogie7956 2 года назад

    Can you do that for the 2011-2014 dodge chargers???

  • @carlosgomez9505
    @carlosgomez9505 2 года назад

    Muchas gracias me fue de gran utilidad. Dios te continúe Bendiciendo 🙌

  • @rosaelenasosa7445
    @rosaelenasosa7445 2 года назад

    What is the song

  • @slammedyota91
    @slammedyota91 2 года назад

    Y'all are the GOATS

  • @ATL2TExas
    @ATL2TExas 2 года назад

    Wish you would have recorded you actually going through the process so we can see the motions. I want to remove mine but I'm fearful I'll break one of those clips.

    • @MTSSacramento
      @MTSSacramento 2 года назад

      I can give you the run down call me. 916-969-5089

    • @ATL2TExas
      @ATL2TExas 2 года назад

      @@MTSSacramento hey thanks for the response. I watched a few more videos and actually was able to get it off successfully and back on with no "fully" broken clips. Two were a little ify but it was a overall success.

  • @raulmedina6223
    @raulmedina6223 2 года назад

    Where did you get that blacked out emblem?

    • @MTSSacramento
      @MTSSacramento 2 года назад

      Audi, you may be able to find them on Ebay as well

  • @GlossyLake
    @GlossyLake 3 года назад

    Thanks for showing! Why did you take this panel off? I’m having some door rattle by the speaker area right now and I am trying to decide if I want to try to fix the problem myself or if I should just take it back to the dealer and have them figure it out?? Thank you!

    • @MTSSacramento
      @MTSSacramento 3 года назад

      It's brand new so I would say bring it to the dealer. We were tinting the windows and the window sweeps on the Platinum seemed tighter that usual .

    • @zunar_j5_933
      @zunar_j5_933 2 года назад

      Having the same problem, did you ever get the rattle figured out?

  • @stingk5295
    @stingk5295 3 года назад

    Great Job!

  • @markp3296
    @markp3296 3 года назад

    Thanks for uploading this. I'm going to change mine out from grey to black. Did a searched and yours is the best, most detailed out there!

  • @haroldpope6243
    @haroldpope6243 4 года назад

    My drivers side speaker or door panel rattles with base sound. Any tips on padding or correction?

    • @marcusdramis
      @marcusdramis 4 года назад

      There is sound proofing goop on the factory speaker. It could be the speaker itself or something in the door panel.

  • @xavierkoenig8238
    @xavierkoenig8238 4 года назад

    Getting ready to wrap my C7 this weekend, your video helped immensely. Thank you!

    • @tonynguyen4204
      @tonynguyen4204 4 года назад

      I’m trying to wrap my car too but this is too much damn work just to remove a mirror lol

    • @thisnewcreatedaccount5286
      @thisnewcreatedaccount5286 3 года назад

      How was the wrap install?

    • @xavierkoenig8238
      @xavierkoenig8238 3 года назад

      @@thisnewcreatedaccount5286 my install went great! Took me and a buddy about 50 hours start to finish, removing both bumpers and mirrors/door panels. Did KPMF matte russet red and get compliments every single day.

  • @zorachevrolet7548
    @zorachevrolet7548 4 года назад

    Thanks