![Edd Zachary](/img/default-banner.jpg)
- Видео 9
- Просмотров 283 094
Edd Zachary
Добавлен 19 мар 2015
Full Shop Build Timelapse
TimeLapse of 40x60x14 Building being built. Has Fiber reinforced Concrete
I Lost some footage so everything is not there.
I Lost some footage so everything is not there.
Просмотров: 219 737
Видео
7.3 Excursion 5 inch exhaust with 38R Turbo
Просмотров 1,2 тыс.Год назад
5 inch MBRP straight pipe exhaust S&B cold air intake 38R ball bearing Turbo PHP Hydra tuner
IronHorse Texas Chopper Ride
Просмотров 4,7 тыс.Год назад
06 American IronHorse Texas Chopper 6 Speed With S&S 124 Has Vance And Hines Big Radius Exhaust
8 Degree 7.3L Cold Starts
Просмотров 504Год назад
First Truck has 230/100% single shot injectors with only around 35-40k miles on them. Second Truck has 272k with all 8 Original injectors. Both are running 15w40
7.3 Excursion Before and After 5" inch Exhaust
Просмотров 17 тыс.4 года назад
5 inch kit www.riffraffdiesel.com/mbrp-5-aluminized-turbo-back-w-muffler-delete/
Never seen that before.
Like for support!
Ilike school buses) and like such sound. Have some on my channel too welcome)
Are you selling it?
Should have gloves on
Sounds like a cat c7. I’m familiar with those motors.
I have one of these with the 124CI, glad to see one speedometer working on a ride. Mine is one with the dreaded dead speedo's. Trying to figure out what to replace it with unfortunately. Great bike, get around 38 mpg but the tank is only 3.5 gallons. Too bad because I would definitely ride it longer distances if I didn't have that to worry about. Almost have the range anxiety my friends have with the goofy battery operated cars they drive.
Lame. You ride like grandpa. Definitely not like me and I am a grandpa. 😂
rather have a dirt bike or a goped! That bike is just 2 damn loud!!! the neighbors should of called the city on you.
The louder the better. You hate mine and wife's. Ours a lot loader. Vane hines down sweeps and no buffles. Oh yeah pure excitment.
No such thing as too loud, son.
Nice...
Made of wood😮
Thanks for the ride, 06 Pitbull.
What exhaust are you running? Sounds great!
got worried for a second until I saw the relief cuts were done in the concrete right before lumber went down
C'est qui le clampin avec les mains dans les poches qui n'en fout pas une rame ? B.
No tape joining the seams of the fabric (blue and silver).
А что на подбетонку не стали делать плиту?
Nice build! But, Is it bath salt zombie cannibal proof?
Ggggjknnhh
Kki
I wanna ride the short bus!!
I need one of these building in my back yard --- yep ....
Is that a 5 inch kit for a 7.3 super duty can’t find a 5 inch system for 01 7.3 excursion
He used a super duty MBRP 5 inch and said it fit
It sounds like the snoring AUGGHHH guy
I bet if you want to fly a kite while putting the roof on, their would be no wind.
You have the doors opening outward? Seems strange.
It appears this was built in the south so outward doors work well. Up north it’s always an in swing.
Love seeing a plan come together. I'd love to have a garage that big.
No rebar in concrete. Good grief.
Read The description... Says Fiber Reinforced
did you use rebar in any of the concrete?
I was going to ask the same question . In 30 plus years in construction . I hve never seen anyone not put steel or at least wire mesh in a slab. .Even as small as an 8X8 or 10X 10 .
My thoughts too. But what do I know :-)
@@marclangevin9152 I’ve seen a lot of concrete video’s lately and they are adding fiberglass fibers instead of mats or rebar.
нужно обязательно поставить Х опоры внутри стен, иначе от ветра здание может рухнуть
Surprise ?,,, je ne vois pas de contreventements ?
Impressive build had to watch it twice as I keeped getting side tracked with the time lapse sky
Good garage for bus
Thanks for posting. Dang wind and mud, huh? When they were putting that condensation barrier on the roof, I was thinking, oh, if that were me, it would get blown off. Yep, that’s what happened partially.
How long did this take?
That aint a straightpiped school bus that's me in class after eating a taco bell burrito for breakfast 😭😭
Probably smells the same 🤣
Never have i ever seen someone jump around so much on putting on steel? Was there any rebar used at all or under post columns?
No Rebar was used. All Fiber Reinforced
@@eddzachary1543 I know this will read negative, but...fiber mix doesn't replace rebar, especially if the owner wants to use an auto lift. I've also never seen someone use a few pile holes in lieu of a perimeter footing for a mono pour. Based on the time taken to finish the concrete (how long it stayed wet), it needed some hot mix in it. Also very odd not to wet set the post bases vs installing the weaker bolt down versions. I wish you the best and hope the owner (if not you) enjoys the shop for years to come.
@@kookiethebear Thanks for the info Michael, I am the owner. Yeah I Would have put rebar in it, But I was told we didn't need it... We did however dig down about 8-10 inches where the Lifts are going, So there's About a foot of concrete there and you only need 4 inches for a Lift
Why no rebar in the slab? Fiber reinforced mix instead?
Yeah It's Fiber Reinforced
@@eddzachary1543 thanks for the reply. I checked my local codes and looks like I need rebar due to the slight seismic activity we experience haha. What type of post cure anchors did you use for your brackets? I was looking at using those Simpson titen hd screw anchors.
@@pinestumps8622I'm the owner of the building so I only watched and filmed them building it haha. I think they used the type of Screw Anchors you are talking about.
@clawboss
Love it
Would love to stand behind and inhale
3116 sounds good man!
what kinda numbers is she putting down
It only had a PHP Hydra, S&B intake and the 5 inch exhaust and 38r turbo, So it wasn't making too much. But I sold the truck a while back, This was old video I had of it
Sounds like a dodge 12 valve Cummins
So, each cylinder has .667 valves?🤔
You know it’s about to get real when you can hear the turbo at idle
What kind of engine does it have
it really sounds like a cummins
DT466
Detroit series 60
what engine is used, it sounds like either a v6 or v10
Usually straight 6
Sounds like a Cummins so straight six
I’m pretty sure it’s an International 7.6L DT466E Inline 6
My man!
Lol
Fun fact: you searched for this wondering what a straight pipe school bus would sound like.
Correct, I did
I searched this because there is a school bus that sounds so loud from 1980s untill last year it stopped the service. It makes me miss that sound in the evening. I want to find bus video that sounds like that bus
Fr 😂😂
Just lovely. Greetings from Norway.
When riding the short bus isn't actually a bad thing.