Видео

Thank you

Man thanks didn't know that was a thing

Thanks so much for this video. You saved me a headache trying to find that last bolt in the rear.

Great video 👍🏽🇺🇸

Put together very well, you can see everything, hear everything , and your explanation is great !

Thank you 🙏

Thank you that was very helpful! That last screw wasn’t as hard as I thought it would be. I was able to use a light to get a visual and that helped me then get r’ done! Great video🎉

my menu doesnt show that "reset oil life", 2021 diesel

You couldn't make it any better, straight to the point. Thank you for your time!

Should have put that filter where it's easy to access.

Bad location

Hey, I have a 2024 MV607 with 50k miles. It is asking for trans filter. Do I replace both filters or just the exterior with 50k miles on it? Thanks in advance

Keep up the great work. Very helpful videos. Slowly getting my 64 Galaxie 500 back to life.

Damned expensive little filter. Thanks for the Video.

I live in Phoenix Arizona.110+ all day I mean here we are going into October it was 114 today. I am going to use the 15w 40. Unless you think I should look into getting something different.

I can not seem to find a oil change for this Hino. Have you done one yet? I have looked on your site, but yet to see one. Wondering if I have missed it. want to say Thank You so much. You have saved me soooooo much. I have just started my small business and bought this truck. All I need is the oil change.

Great video

I have a 2001 4300 it runs rough at idle and while driving. Starts fine doesn't die. Just runs rough low power. I checked and my fuel pressure is only 45psi not the 60 psi as needed. I cleaned out fuel lines back to the tank. No change Do you think it could possibly be my lift pump? Thanks

Wil u plz let me know throtle body sensor position in hino 338 model 2013

What kind of grease?

What kind of grease?

I'm a female who knows nothing about vehicles but can really appreciate your skill, amazing video thanks! I had my alternator replaced. The car was noisier afterward, especially when the air conditioner was on. Eventually, the a/c started blowing hot air. During an inspection of the vehicle, mainly near the front bumper, 2 bolts were missing. I have been googling trying to figure out what bolts. I suspect it's the a/c compressor bolts. Could that be why my a/c stopped working? Thanks in advance for any advice!

How much does it cost? To replace tie rods

My transmission is not shifting properly between 45 mph to 65 mph,it does erratic pulls and when spending up it takes so much time to reach 65 mph! An Allison Shop already changed the TCM but same results! Lost here,any thoughts?

I have a question, I hope you can help me. I have a 2003 3.2 CTS that doesn't go over 70 km/h. My mechanic suggests that I change the strainer and check the transmission, but is there anything else I can check?

Thank you for your series of videos on the hinos. They are very thorough and easy to follow. You're the man 👍

You are the King of the Hino videos, my friend. Thank you.

Great video!

I own a 2010 F-150 Raptor. I'll have to check it out to see if I can do what you did. That is really clever. What you did. 👍

were is the filter to change

Thanks so much. First oil change on a new Transit and had a hard time identifying the drain plug. This video explained more in 10 minutes than a call to Ford Direct and a visit to the local dealership. The dealership said that Ford designs the product so you'll be compelled to return to the dealership for service? Loved the child support comment too. d

Thanks

Gracias. Thank you

Getting anxiety watching how stupid they designed this just to remove a bulb.

That bigger fitting has a specific zerk smh don’t stab a bigger hole than need to in your boot.

I need to replace the mesh element inside, how does it come out?

Very useful. Ty!

Thank you mister, i learnt a lot t'day

What if there’s not one there

Would a leaky seal cause truck to not start after sitting overnight? After a Squirt of starting fluid it starts and runs normally. Leaking at seal between engine block and pump. When hot doesn’t leak and starts fine. Would you recommend new pump or just new seals? Thank You sir, appreciate it!

Great video! I’m experiencing this same issue. When it first began my technician thought it was a dirty cap issue so he cleaned it and replaced it with a new cap. Same problem happened so then he replaced the sensor with a new sensor. It’s still happening. What could it be??? I put new batteries couple weeks ago. Could the new batteries have caused this issue?

Thank you

This was right on time!!!🫡

Thanks for showing how to remove that clip!

❤

Thank you sir

Do you have to remove all the water?

Do you have to seal the holes you created in the rubber fittings?

I had a grease fitting installed on my knee, when i had a knee replacement. My first knee replacement didn't have a fitting, Since using this method, I don't squeak anymore on my knee when walking. Great tip.

I'm 69 and running out of time,i better get this done on my 67 cougar at one point i wont be able to get under the car! Thanks for posting this !