Видео

Got a p0882 low voltage code and in limp mode in 2011 jeep liberty wonder if this is the same makeup

Crowtown the goat😊

I am ordering one soon. My truck started acting up about 2 months ago... defroster wouldn't turn on right. had to play with the touch screen about 5 times to get it to work. Next a few weeks later the air would only come out of the floor vents...no panel,,and no defrost. I got 2 new actuator motors, replaced them behind the dash. Turned the truck on FIXED !! for ONE time.. It literally worked perfect, i let the truck run, let the auto A/C do its thing.. ran it for 15 minutes, and i was smiling, until i shut it off and went to drive it an hour later. and i was right back to where i started. Then over the next few weeks it would randomly work fine like once a week, SO i knew the actuators WERE working. Today i disconnected the AC control module, and the battery. FIXED !! for ONE time again. Then back to the same broken, only on the floor. SO this time i pulled the glove box out, disconnected ONLY the A/C control for 2 minutes, plugged it back and FIXED again. SO i feel pretty strongly that i narrowed down the issue. its the control module.

Is this also the same for the 04-08 crew cab as well?

I am going to replace this on my 2008 Nissan Versa Hatchback. The reason why I am replacing it is because the front wipers have been malfunctioning and I think this should be the issue.

Is this the same for 2010 model challenger?

Hi, when this part is bad, do you change only this part or other parts also?

Did it work when you replaced it or did you need to sync anything?

Dumb question but I have 2015 jeep cherokee sport is it the same place, I need to replace my tcm

Can you show how to remove the fuse? Without removing the module?

What made you replace this?

thanks

Does this amp have a fuse ?

Cool thank you !

Tks very useful

NICE!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Hello it is related to the head light bulb when it is not working

So much easier in a chysler 300😅

Im looking for the bcm location on a 2015 honda pilot. Went behind glove.compartment passenger side and in dash on drivers side, no luck yet.?

Do you know if the customer ended up needing to get the Control Module Falshed bud? Hoping its a plug and play.

the green plug in isn't the same and so far i cant figure how to remove it

How do you prevent the steering wheel from locking? Do you think it would be safe to release the two access points while the vehicle is on? Then disconnect the battery before disconnecting the wire harness?

Is it the same for the Sportage

great video buddy... you just didn't show us where to look for that box front of the car back of the car .. thanks

Isn’t there a plastic holder at the bottom of the left and right seat belt cover sides behind the seat ? They are a pain to get loose with the seat in place on my 2006…

Good video, thank you. When the PATS unit goes bad, what are the symptoms? Because I'm not getting anything, when I turn the key, no dash lights, nothing. The only thing that moves is the oil pressure gauge. (2002 Ford Ranger)

I have a 2024 Kia Sorrento and it has the basic dumb rearview mirror. I would love if you or anyone could tell me if the plugs for the mirror are just inside the headliner or do I actually have to wire it I keep getting conflicting answers it would be awesome to see a video.

Thank you so much for posting this video! Daughters 2021 Sportage started delaminating down the right side Kia forums. I’ll say this is a pretty common thing yet the dealership still charges almost 2 grand do what you just did in 10 minutes! This is awesome thank you so much for doing this.

I have a 2016 Ram Promaster 2500 and the airbags have deployed before from original owner, but everything got replaced but steering wheel airbag. I am aware of it having no steering wheel airbag, but my only concern is the horn isn't working! Would it be because I have no steering wheel airbag in? Or maybe the connectors arent plugged into the wheel airbag, so there is no power to the horn button, etc? I heard that could be the problem, but I've never looked into it! But the fuses and everything are working! No burnt fuse and I used a multi meter to test! Any advice or tips would be greatly appreciated!

do you have to take it to the dealers to reprogram it?

I just want to get the silver trim piece off so I can cover with vinyl 😭...... this is def making me rethink if it's even worth it 😒..... but my OCD is going to keep whispering "yes" so it can match what i've already done 🤦🏾‍♀️ 😂

thank you

i tried but it doesn’t come off 😭

10mm for the win

My radio in 2013 Buick enclave comes on and play but it makes a lot of noise noise with it on or turn off with the power still on or when I make a turn with signal light it makes noise as well so I don’t no if that would be the issues with the amplifier

Prefect thank you

7c3a-12b565-am

Very helpful thanks!

Do u need to program the new module?

Thanks…wasted 3 days finding right one ☝️

Thanks a lot

Thanks for the instruction

so im dealing with front doors not locking or windows rolling down i do hear a clicking sound coming from this module, i went to the junk yard got one but the numbers dont match so im thinking thats why it still dont work, the power door locks dont work or the key fob

16

That's the one at fault.

🎉

THANKS FOR YOUR INFORMATION IT WAS VERY HELPFUL FOR ME ; VERY WELL EXPLAINED

MUCHAS GRACIAS DESDE COLOMBIA!!!! THANKS

My 2009 challenger srt8, everything works except the push button start. I push the button and it says damaged key. Got a new fob from the dealership, had the program it, still didn't work. I push the button and i can hear a faint clicking noise in the dash somewhere, then the car dings and says damaged key. I've had to remove the button and turn the ignition manually for 2 years. Any thoughts? Thanks

Looks like you need to pull the rubber grommet from the bottom of your spare tire well and fix the leak by the lift gate hinge and the roof seam...my 2013 PIU had the same problem