Видео

Genau diesen Fehler hat meiner auch was war Kaput.?

İyiden daha iyi bir sese sahip ne şanslıyımki bir tanesine bende sahibim bu bir mücevher

I know this is from three years ago, but a dirty reel size switch can cause this.

2 point gyro tonearm.

The steuerpimpel is the problem

Nichts sagendes Video

First off all the transportsaite mit Feder is fitted the wrong way. The Feder has to be at the other side. Try this first.

Cartridge carriage is not lowering enough and that is causing the issue. You can adjust the lowering level with the screw on top. In my case cartridge was not properly installed and spacer under cartridge was missing. Without spacer cartridge was too high. Even with the carriage lowered to the max lead out groove detection was not working, exactly the same as on your turntable. Once I installed spacer (in my case 2mm), and adjusted carriage height issue was fixed. I hope this helps.

So open it up and find the issue. B77 is the 'perfected A77', very easy to fix.

Imate li koji za prodaju.

Treba mi jedan takav ili magn glave rojal de luxe i sg 520

Krejzi stvar

Krenuo stvar.

O maj garede,o maj rode brude ,o maj krenuo lave. Strava bajo.čestitam.

Uredjaj je maestralan ali kako doći do njega??

What is causing this? Same issue here. Pimpel seems ok.

That's a very nice turntable .I own the Garrard 990b .Make sure too oil the motor it will affect the speed not being propley oiled . The idler wheel is the same as the original one from 990b You have too also check the dried up grease under the changer too . These are great sounding turntables . I bought a Audio Technica cartridge from eBay missing the stylus . I have a precept 440 and that's a great sounding cartridge too . But I have a cheaper audio Technica cartridge the green one .49.99 But the Audio Technica Precept 440 was a very expensive cartridge

Ernst practitioners mooi I'm he self den the 25th en den to 630 ended teac x 1000 war an de capstan motor defect is jammer. Greof bert.

ftp://ftp.studer.ch/public/Products/Revox/Revox_B791-B795/Revox_B791-B795_Serv.pdf

Have you tried a VERY light sanding of the edge of the idler-wheel - this can sometimes fix the problem. I have done this on many of my own Garrards... A suggestion !