Видео

Thank you very much. My 2014 Silverado is having similar issues.

Thanks for such a great video! How did you disassemble the airbag cover? Did you remove the air bag before reaching the AC unit?

For those who don't want to screw/bolt anchors to the wood floor, Karavan sells a Tie Down kit for their 5" frame trailers (incl. D-rings with 1/2 x 6 inch bolts) that fits in those plastic capped holes on both sides of the trailer. Sold at TSC or cheaper if you shop online somewhere else. My 2021 Karavan 5x8 has four predrilled holes on each side with plastic caps on top, but my trailers has 3" frame. So I bought 4-pack of V-ring bolt on anchors and will get some bolts at Lowe's [for the pre-drilled frame holes].

This ABSOLUTELY should've been a recall

You my guy are my saviour 🎉❤. My current problem and I now need to get a water pump

Is it usually the oil filter housing that’s the culprit?

How much to replace? They quoted me 4k but also doing coil packs and spark plugs

I used a large chain wrench to hold the pulley wedged against the subframe to loosen the crank bolt so the starter does not have to be removed.

Hello needing some advice I have the same car It’s obvious the water pump is bad it makes noise and the pulley moves back and forth I changed out the thermostat and I’m having trouble getting all the air out of the cooling system Is it possible for the water pump to be putting air into the system?

I have the same problem, thank you!

torque settings?

There are 2 sensors... One is for the "oil pressure switch light" the other is for the "engine oil pressure switch" which one did you replace?

part #?

Amazing video man very good

Same problem but i replaced the plug wire coil and fuel injector still have a misfire on cylinder 1

If you can stop the music bang bang bang, bang bang bang bang bang that’s not good

How much would it cost to replace it with labor cost?

A job like this what's the cost ?

Mine sounds like a diesel truck on idle and worst when accelerating. I got 3 codes with cam and crank with oil and seatbelt light indicators on dash.

In these circumstances, it is the purge valve solenoid, or the mass airflow sensor In my case it was the purge valve solenoid causing high idle rough starting of the car and problems starting the car after fueling the car . My car 2019 Mazda cc’d 5 gt

4:05 smh….. chicks

Just the video I needed. Many thanks

What camera are you shooting you videos with? Thanks for the awesome videos and hope to see more.

Where did you get those roof speakers from

Being a mechanic for many years, i have seen these challenges that engine designers make difficult for any novice mechanic. Thanks for a great video.

. I like the disc brake upgrade kit you used, seemed to assemble easy enough. made is china casted brake/discs, its doubtful that those disc's were magnafluxed inspected for cracks. however I suppose those china made disc's were half price of made in the good ol united states of america.

My man 💪 you so smart I finally fix my truck thanks too you help 🙏

Hello, Are you interested in testing our products? We would like to invite you to test the Front Windshield for your 2021 Polaris General XP 1000

how to replace ignition coil connectors?

Dam😮!! that's it's a one nice machine, I like the sand color. You keep it clean man.

In you’er wife’s defense, you did ask her to throw them at you. 😂. I’d say she did great

Thank you bud!!

Thanks so much for the informative video. The wife and I have a 2012 Cruze 1.4 with 125,00 mi. What is the total repair bill on this job?

Will pulling a heavy load make it worse

I have a 2018 kia sportage and it sounds like a pencil is hitting the fan

Fuel injector

I hope you can answer this question quickly. when removing harmonic balancer does it require a puller or not? Excellent video

After replacing air suspension compressor, about 30 mins later I got this code C15A0-13 “ Air suspension reverse valve 2 control circuit open”. Please help. Everything is connected, fuses are ok. The code instantly comes on when erased.

Thank you for posting this! I have a 2012 with a similar issue.

I had this exact problem and you save me HUGE cash ... THANK YOU !!!

I have removed the starter without taking out the oil filter and it's cooler, by removing the infake. Yes, I removed the intake by removing the timing side engine mount and the mount beneath the transmission in order to be able to swing the engine freely about it's axis. I've raised the engjne as much as I could using a flat jack with rollers, took all the 8mm hex bolts out from the intercooler (charge air cooler as some name it, don't know why), put a big pry bar inbetween the AC compressor and water pump pulleys. Pushed up in the pry bar to both raise and rotate the engine backwards as it only sits on the mount beneath the battery and on the jack, forcibly put/pushe the AC system black flexible hose (which is in front if the intercooler) beneath the lower left corner intake (from your position) so that it won't block the path and as you keep the pry bar pushed as hard as needed, pull the intercooler out by rotating it up towards you at the same time. The same way I've also put it back. Yes. You may also need to take the alternator out as well, but that takes about 5 mins to take out with 3 bolts and 2 connectors, but maybe with the right tools you can leave the alternator in place.

What was the part number for it? @Paycheck Monster

Very professional 👏 thank you

I did this repair yesterday after watching the video. Now I am just waiting to see if it solved the problem. So far so good.

Quick question when u put the hub assembly back do u apply anti sieze or grease on axle awesome video

I changed this on my car, same year make and model. I changed the starter as well. After a trip it refuses to turn back on. But the car will start up cold. Any ideas?

Great video, saved my customer almost 10 hours in a missed diagnosis. Had the oil leak but no oil light coming on, looked like a rear main leak.

Omg thankyou very much, when I changed my battery I broke that wire and didnt know what is its function. Some weeks later the wipers started to activated themselves. I am going to get and install that sensor. Saludos desde la CDMX.

Thanks a lot. Been watching, doesnt understand anth, but got ELM from ali, deleted an error, and everyth got right 🤝

Nice work!!! I loved this tribute to AJ!!! Well done! ❤