Видео

so you are adding the extra spikes in the same spots showed in sections 3 and 4 correct?

Hi Sir, nice explanation. is it possible corn harvesting with Tangential Axial Flow (TAF)?

I just bought an 8120. What pad configuration do you have for the 36 pad small tube rotors? 28.10 studs or bats? For corn, durum wheat

thanks sir

Hello, don’t know if there is a better way to contact you but I am having serious issues with grain falling into the fan housing and gernading it. We’ve got slopes up into the 40% range and need some guidance with the automation and the fan over speeding.

What is the part number for the module that has the larger spacing of 25mm round bar in rear of combine?

Do you know where i can find the def on the case tr340?

I get how the sensitivity’s on the rotor loss and grain damage would balance out the rotor speed. But what balances out the vane position? If you have grain loss and the vanes slow down what speeds them back up if your grain loss goes away?

Great videos Jesse! Was wondering if you could do one on adjusting the concave pinch point sometime, the manual can be a little vague! These videos are a real help when I’m setting our machines up for harvest!

What’s the benefit of having those Gordon rasp bars in front of the rotor? At 2:13

I'm thinking I need the round bar in my 3rd one like that lots of green material

Can you do a video on adjusting the whales tail for 50 series not adjustable in cab

Korszerű technológiával ellátott gépek,de mennyibe kerül egy szervíz???!!!

Hi friend sens me your whatsapp number becuse i need help with Excavator WX188 Calibration UCM

Cool

sea

Really nice tool! How much for this tool? Where can I find one tô buy? TIA

Good info

Does the automation still run without having feed rate engaged?

Can you tell me the difference from a 2019 7250 to a 2020 7250? Just curious any changes comming to the 21 model

Hello what concave to put on 1i2. 3.4position on the left and right side for wheat for best performance on case 7250

in our country only dream of such a combine

Case supper

Hi Jesse, I was wondering if you could do a video showing how to set the pinch point on a flagship? Excellent job on your videos, helps a lot!