Видео

Check your pcb board if the still have problem

Sure you could mate or weld half of that new piece

Thank you mate

You was right took out the starter mate changed it with the new one.... Anyway needed up putting the old one in again after i tested it it was working just fine checked contacts and I the I alway replaced a corroded 20 amp fuse on the engine bay near them important relays with came up with test probe

Hi mate you need to get origal radio mate, even if you bought the screen for the radio you then be able to communicate with cars ews system to set the code or uncode it mate emmm but I would also try get a full bmw screen and the radio unit to keep it simple mate

Use to not anymore did ejection system cleaning it sorted it but still has abit of blw by needs changing the vortex filter or something

All good mate ended up putting a box section instead

Never had a sunroof mate runs through the air filter

You can always buy the amplifier maybe even wire some Diffrent speakers, but be better off checking in with someone whose experienced with working with audio systems hope it helps

indesit water inlet valve, hope it helps

Thanks it starts on the key and uses abit of oil definitely gonna have todo full engine rebuild in the short future thanks

Thanks I've got another audi with the same engine and apparently it had full engine rebuild and it also displays the same characteristics lol

Great!

Best to give them a call mate

The shut off valves?? With like a tap I'll try and find out thanks

I bought the smallest size valve from that site but they don’t fit onto the air cable on the car, you buy an adapter aswell ? As the cars end is smaller than the 1/8 on the valve

Nice if it froughs h20 message then simply fill the water up and try to point all the select dials up to original possition, and hopefully it will reset it self thanks

Gunna get washed and then painted then waxed mate it be rreeet

Hello sir www.contextpneumatics.com/

Well I have done alot of research in. Asking Diffrent old school bmw technicians thanks

?The question is where did you find the code?

You need to find particular air lines for the front and use the method hope it helps

Hello I'll find out the sizes and the link below or ask the shop show them the video www.contextpneumatics.com/

Hello... Emmm just look at the space between the wheel and the wheel arch about the 15 to 20cm would be ideal

Hi mate emm for the rear end wheel clearance i would use approximately 15 cm from wheel to arch in height I have to double check with psi as I am made some new hacks with the pump thanks

Superb job

Best way pal

Hi matey sorry I went to the truck and trailer shop to get those valves ill add the discription of them thanks

Can you list the sizes please and thank you

I vent with pipes to the commercial trailer supply shop to get them shut off valves.

@@sssds8573 This is brilliant man thanks for posting it.

@@Prikki2k how it finds you well mate, mine air suspension not going down for a few months atleast , if you make and test the connection with foam spray and add some pvc tape then it's not going anywhere

@@sssds8573 Thank you Sir, you're a Gem.

What size is the valve tryna eBay one ?

Hi mate you would have that on the screen unless you unplug suspension sensors on the rear suspension or fuse thanks