Видео

Thanks 💞💞

Rs. 2106

Thanks 💖

Thanks 💖

Just upload the new firmware to VC-02 module and it will automatically replace by the previous firmware.

docs.ai-thinker.com/_media/hummingbird-m-update-tool.zip Also description Mai v add kr di hai baki links ko..

Also 🙋‍♂😂😂

Thanks bro 🤣🤣🤣💖

Thanks 💞

Thanks 💞

It's my pleasure 💞💞

Thanks 💞💞

💞

💞💞💞

I have faced the same problem too. After 1 and 40 minutes later, I refreshed the page and finally firmware was ready to download. There is a problem that they only accept Chinese and English language and limited commands for instructions, like 'wake up' command. You can use limited letters for commands.

💞💞

Thanks 💞💞

💞💞

Thanks 💞💞

A v tq Maine uske upar vdo banaya nhi hai... Filhal ap Arduino IDE mai ja k example mai se EEPROM ki ek example dekh sakte ho... Mai Nxt time iske upar ek vdo bana dunga...🤞

💞💞

Thanks 💞💞

Ohk bro... I'm trying my best... Plz keep supporting and stay connected.. ❤

@@aviyansthoughts Yes bro... Always..!

💞💞

☺❤

Thanks 💞

Thanks bro 💞

Thank you, I will

Yup 🙌💞

Thanks bro 💞

Thanks 💞

Thank you 💞💞

Thank you 💞💞

Thank you 💞

Thanks vai 💞💞

Thank you 💞

Yup

Thanks bro 💞💞💞💞

CH340 driver ko install kr ne k baad Ek baar firse nodemcu 1.0 board ko and exact port ko select kr k blink example ko upload kijiye, agar nhi hua to board Ki reset OR flash button ko 10 seconds k liye press kr k hold kijiye jabtak blue LED on na ho jaye... Agar fir v nhi hua to pehle power connection ko check kijiye, NodeMCU board ko check krne k liye ap apki PC Mai Wi-Fi settings pe ja k "ESP8266 Access Point" search kr k password dal dijiye "thereisnospoon" and then terminal open kr k ek ping kijiye 192.168.4.1 pe... Uske baad dekhiye apka NodeMCU response kr raha hai ya nhi...

@@aviyansthoughts thanku so much bhaiya abh node MCU me light glow hone lag gahi .. lekin light glow- down hone lag rhi he

@@aviyansthoughts bhaiya light glow nhi ho rhi he blink ko upload krne pr ho rhi he .... Program code ko upload karne se glow -down ho rhi he lekin ushke bad jabh program code ko dalte he to light glow nhi hoti ... Please bhai kuch solution bta dijie 😔😔

Actually NodeMCU board Ki LED signal k liye use hota hai, jab v ap koi program upload kroge Tabhi wo Thodasa blink krega and stop Ho jayega aur blink example ko use kr k usko just test kr raha tha...jaise Ki arduino board Ki 13 pin ko use krte hai ham.... Ap dusra koi sensors add kr k ya fir koi aur program upload kr k dekho wo kam krega....

Used Raspberry pi, pi camera module, 1.5 kg servo motors, buck converter and a battery

@@aviyansthoughts can you share build plans and code?

Thank you 💞

💞💞