Видео

@@robxrto99 you are most welcome! Thank you 🙌🏽

@@avinashkongara7488 yes everything is in the description! Thank you for watching 🙌🏽

@@brownsburg.motorsportssorry to bother but I need the part numbers for front breaks

@@avinashkongara7488 oh the front ones! Send me a text on TikTok or insta and I will help you find em!

@@MrNanah38 you are very right unfortunately 🥲

@@sunnyg2977 if you have a professional scanner you could go to hot functions and put it in transport mode / Service mode if not just disconnect the battery before you start and connect it back once it’s back on the ground!

@@mexicanamericansinthedenve6768 map sensor is located on top of the air box under the engine cover on both sides of the block but it’s right there on top it would be the only sensor on the air box from the top

@@brownsburg.motorsports thank you I thought those were the mass airflow sensors but I’ll give it try

@@mexicanamericansinthedenve6768 oh you were asking about the MAP Sensor my apologies IDK why I read MAF sensor lol, MAP sensor should be located on the charge air cooler at the front of the engine in the corner of each charge air cooler

@@brownsburg.motorsports thank you very much. I suspected that was some type of sensor is telling me turbo pressure sensor when I look it up, but I’m gonna have to give it a try. It’s like the intercoolers.

@@mexicanamericansinthedenve6768 yes make sure you disconnect it even if you’re going to jack up one side!

@@larryl.3383 you are most welcome! Glad you enjoyed it 🙌🏽

@@BigBallBearingturBo you are most welcome 🙌🏽 good luck with the repair!

@@drk.walters any brake grease should work although if you ask someone else they would say it has to be only this grease and only this brand and what not lol but yeah any brake grease just apply it evenly across thin layer to prevent the relief buildup and make the job easier for the next person 🙌🏽

@@adilamin5315 hello unfortunately I don’t service the modules but there are a lot of companies that does it. Message me on TikTok and I will assist you further 🙌🏽

@@AngelVentsislavov you are most welcome 🙌🏽

@@jesuslararodriguez2985 if you have an error for a seat belt it could mean the pretensioner is deployed on one of the seat belts, and if you haven’t replaced it or reset it yet I would recommend doing that. But first see if you could get the DTC code for the actual error using a professional scanner, any mechanic shop should be able to scan it for codes and either print the report for you or tell you what the codes are. If you do get your hands on the code message me on instagram or TikTok and I will do what I can to help! Thanks for watching 🙌🏽

@@brownsburg.motorsports I think the pretensioners are not bad since the belts work perfectly, even so I will do the reset with the diagnostic machine and I will get the code if I can't solve it, I'll tell you something, thank you very much for your attention.

@@flyingartgirls1 thank you 🙌🏽

Elbow grease

Keep at it slowly and once they come off I would clean them thoroughly with a wire brush!

@@brownsburg.motorsports thank u it worked

Not yet!

@@frankplayz1462 all the li me are is in the video description 🙌🏽

@@kevinkauffman522 unfortunately I am pretty sure the AC will have to be discharged to replace the radiator 🥲 they try and make everything complicated so people don’t do it at home 😭

@@ringomandingo8900 you are most welcome! Thank you for watching 🙌🏽

@@DoyMonkey unfortunately yes, seat belts are parts of the safety and restraint system also

@@Majicman187 thank youuu 🙌🏽🙌🏽

Thank you! Unfortunately the link I used expired cuz I have some other asking me about it but if I come across them I will send you! Message me on TikTok or insta!

@@scotttaggart that is true Altho I didn’t mention it in the video but if the brakes aren’t ceramic coated they will have to be cleaned with brake cleaner! 🙌🏽

@@jamesbroomfield7799 I do not know the size of the top of my mind but it would be a good idea to have an AC o-rings kit and swap em when you are doing the repair! 🙌🏽

@@orbitaaltube the seat belt can be reset there are company’s that provide seat belt repair, and since the car was in an accident the SRS/airbag module also needs to be reset!

I have a video about the airbag module replacement as well on my channel! I am glad the video was helpful and good luck with the repair 🙌🏽

@@ryanyockey that’s awesome 🙌🏽🙌🏽 I am glad the video was helpful!

@@torontoonline thank you 🙌🏽🙌🏽

when the car is cold no bubbbles in the coolant tank all normal and the temp gauage never goes up more than 90 so i know no overheating but when it gets hot it spits all the coolant out the coolant tank is this air or the thermostat as diagnostic says stuck open ....???

im gonna try the bleed it the way you did it bleed the intercooler system then bleed the engine coolant tank but im not sure if the thermostat is causing this

I would start with the thermostat first, compression test results are within acceptable range and you do have the code for the thermostat so I would start them first and test again!

@@brownsburg.motorsports i got a brand new thermostat from BMW still did the same thing i think its air in the system, im going to buy Vacum purge to hook it up to my compressor to do a full purge otherwise i can't get the air out so difficult on these 4.4

@@Smudg sorry to hear about that! Just check the ac lines o rings if they are not ripped put the AC line back and take your car to the garage for the full service recovery/vacuum & recharge and you should be good!! Nothing to worry about!

@@brownsburg.motorsports Soundds like good news, I was concerned. Thank you for your time.

@@Bsquaredplus2 yes!! We did but I didn’t show the clip 😅 definitely a great idea 🙌🏽 I got locked out before and had to go through the rear seats and it wasn’t fun lol

@@gdscott8276 well I wish that was an option the seat belt was completely locked to the seat as you saw at the beginning of the video and moving the seat forward or backward isn’t an option since the seat belt is attached to the seat itself. If you continue to watch instead of skipping forward you would have seen that before you commented 🙌🏽 glad the video was helpful tho!

My apology. I heard you say the belt was locked, but not that the seat was. Sorry friend. Yes, the video was very helpful! Thank you for sharing it!

@@gdscott8276 no need to apologize! we all skip through videos 99% of the times 😂 I am just glad it helped and if you need anything feel free to contact on social!

@@baronmunchausen645 yes!! It really is 🥲

@@ikemmanuel7859 thank you 🙌🏽 unfortunately the bumper from the 528i won’t fit on the 535i ☹️

@@Dagvi you should definitely reset the SRS module or replace it!

@@brownsburg.motorsports thank you, nice video

@@brownsburg.motorsports also, do you think it's better to reset it or replace the unit completely? i know a guy who specializes in reseting these units so i was thinking with goin with this

@@Dagvi thank you 🙌🏽 yes you should reset it because you can’t replace it with a used one it has to be a new one and they are not cheap at all 🙂‍↕️

@@MASTERMIKEEE I just added the link in the description for what I recommend using! Any electronic cleaner you can pick at the local parts store or from Amazon, spray it on the connector let it sit for 3-5 seconds and brush it with a tooth brush then run some air through it with an air gun or spray to dry it off and get the corrosion off

@@brownsburg.motorsports It’s okay to clean with a brush as long as the battery is disconnected? Also was your fuse blown? My corrosion looked just like yours.

@@MASTERMIKEEE yes you do all that with a disconnected battery! My fuse was intact 🙌🏽

@@brownsburg.motorsports ok check this out - put everything together and the corroded side still didn’t work!! After hours of troubleshooting, I realized the left and right assembly’s have the same power connection; just inverted. So I connected the (known good) right side assembly to the (unknown/not working) left power plug. It worked!! This seems to confirm that the new headlight assembly is not working, right? And then to double check, I tried the (apparently broken) assembly on the good power cable, and it still did not work! Planning to return it and get a replacement.

@@MASTERMIKEEE nice troubleshooting steps 🙌🏽 did you replace the TMS or just the assembly? TMS could also be the culprit I have ran into that before 🥲 you could swap the TMS from the good headlight that’s working to the one that seems to not be working and test again on the side with the corroded plug and see if it works if it still doesn’t the get a replacement but If it does work then get a new TMS just make sure they have the same amount of prongs because there are multiple ones!

@@nadinindre3496 I believe the car would still have to go in service mode for the belt replacement 🙂‍↕️

@@HungNguyen-sb1yu you are most welcome!!!

@@brownsburg.motorsports Actually a good question, how high can you life the engine without damaging anything if the engine mounts loosen? I don't have a lift, so maybe an engine hoist. Ed Michael

@@Smudg not having good engine mounts good potentially harm your engine depending on the make and module, I would recommend the engine hoist that’s a good idea if you don’t have a lift!

@@brownsburg.motorsports what is the maximum hgiht you can hoist and engine?

@@dr-mn7ld good input 🙌🏽

@@1000raulm I am afraid that’s only doable while the car is in service mode 🙂‍↕️

@@bwaccord99 sure text me on instagram or TikTok and I will send you a another short video that I have of the taillight

@@bladezone5672 I am sure everyone got his ways but your input is noted. Thanks for watching the video 🙌🏽 ( the video was made mostly for the people without lift access 😉)

@@brownsburg.motorsports anyway you are doing a good job bro