Видео

대박 이제껏 이게 명료하지 않아서 엄청 헷갈렸는데 한번에 구분가능해짐. 감사감사

이제서야 봤네요~~ 아래 답변은 저의 견해이므로 참고만 하세요~~ All people need homes to shelter themselves from the weather. 1.첫번째 질문 to부정사의 형용사적용법은 수식받는 명사가 to부정사속 동사와 [ 1)주어, 2)목적어, 3)동격 ]으로 밀접한 관계를 갖고있고, 부사적용법의 목적은 주로 문장의 주어가 to부정사속 동사의 주어역할을 하네요. 따라서 to shelter(보호하다) themselves ~에서 의미상 주어는 homes이므로(집들이 보호한다) 형용사적 용법으로 보는게 좋을 것 같네요. 2.두번째 질문 재귀대명사(~self/selves)는 문장의 주어를 대신하기에 all people이에요. 3. 모든 사람들은 / 날씨로부터 그들을(모든사람들) 보호할 집들이 / 필요하다.

선생님~~ All people need homes to shelter themselves from the weather. 여기서 to부정사는 형용사적용법 맞나요~? 부사적용법은 안되나요~? 그리구 여기서 themselves 는 homes 를 대신한건가요~? 아님 all people을 대신한 건가요~??

딱 궁금했던 내용이네요~감사합니다~~what문제중 관대와 의문사 구문하는 방법도 있을까요?

간략, 명료. 머리에 쏙쏙

넘 유익해요 ㅡ 다른영문법 엄기탑도 만들어주세요♡♡

갯수가 많아서 어떻게 암기해야하나 고민이었는데 이방법으로 암기해보겠습니다. 감사합니다😊

좋은영상 잘봣슴다

요날 날시계 명상거리 잘외울게요. 감사합니다.

Hi, I bought 4 new shafts for my hubsan h502s together with new motors. I want to replace them, but how do I know what screw should I put in what shafts? There is 2x cw silver screws and 2x ccw screws and all 4 shafts looks exactly the same

독일에서쓰던 1차 세계 대전때 쓰인거넿^^

별~ㅋ ㅋ

any one can tell me where I can find good cuality motor for my hubsan h502s,because I change many motor but they are work only one fly,i change many time the motors,but I think the cuality is no good

와우

와우

와우

전 이거 참고해서 다른 전투기 만들었어용~

Thank you for that. The FF speed was a little too fast even when I would try to stop it in a particular spot, but it is good enough to see what you're doing. I've changed out brush motors in other drones and these motors do seem to go w/o any warning. Today, I was flying the H502S in GPS mode just before the sun went down. Suddenly, while the drone was only 40 meters high and about 60 meters away from me, I lost control of it! I realized that it was descending so I applied maximum throttle to get it to go higher. That worked and it climbed back up to about 35m before it began to drift away from me at an incredibly fast rate. I knew I was in trouble so I switched on the RTH toggle, (Return Home). However, the drone began to descend and continued to move away from my position. By now, it was too far for me to tell which way it was facing and even if I switched to Headless mode, it wouldn't have helped. Finally, the drone disappeard behind some trees and it was nearly dark. I grabbed a flash light and jumped in my car and raced to as close as I could to the last place I saw it. I took the radio transmitter with me, which I never turned off after I lost the drone. I got out of the car near a wooded area with a 6 acre swamp and trudged through the swamp with a flashlight. The entire time, I watched the radio transmitter and used the distance readings on the scree to guide me to the drone. I walked for about 20 minutes and the battery in the drone was still good enough to continue sending a signal that allowed me to follow it. I had to trudge through a large swamp at near dark and then when I found it, I had to get out of the swamp in a different direction than I went in because the 6 feet high grasses and thorns were too thick to go through in the dark. The drone was a 1/2 mile from my house. I had to walk for about 35 minutes in the dark in order to get out of the swamp after I found the drone, but I was happy because I did succeed in finding it. However, those brush-bearing motors are very unpredictable and this was the second time I had lost and then recovered the drone. The first time was very similar to this time but all 4 motors were working when I found it that time. Still I suspected the motor caused the problem that first time and when I recovered the drone this time, one motor no longer worked. I think the reason for the first crash was that same motor but I wasn't able to confirm until now. Well I'm about to change this a motor but I'd like to suggest that you use certified electrical tape for your wires, if you aren't going to solder them. In fact, you should use the electrical even if you do solder the wires, (which I always recommend). The electrical tape is a much better insulator and would help keep the transmitter and receiver signals from being interfered by the constantly changing electric frequency on the motor. I don't use electrical tape myself because I use an electrical heat-shrink insulator. Using solder and heat-shrink tubing would be the best thing to use and I have all that stuff. But if you don't have that kind of equipment, at least use electrical tape for the wire mending. FWIW, Rich

왜...댓글이 없을까용... 근데 진짜 잘 만들었떠욤!!!

same motor is grinding dude im pissed omfg im pissed

혹시 영상은 어떻게 찍으셧나요?

복엽기군용 저도 이런 클래식한게 좋더라구용 ^^ 잘보았습니다. ^^ 좋아요 꾹!

몸통 만드는게 너무 어려워여 설명도 조금 부족하구 만들고 싶은데 어트케 하죠?

고퀄

Whats your distance with this mod .i just install it to, but did not try it yet

오

감사합니다

안녕하세요. 원래 협산 H502s는 720p 맞나요? 어때요? 영상 깔끔하게 잘나와요 ?

하하하~~ 아무 의미없이 써 놓은 숫자에요~~간만에 웃네요~~~^^

혹시 비행기 옆애 150은 아빠님 키 아닌가요?

감사합니다....

좋은 영상 땡큐~~~~안테나는 어디서 얼마에 구매하셨나요 ??그리구 완전 초보인데 h502s 드론에 밧데리를 연결하면 삐~~~소리가 나는데 해결방법 좀 알려주세요

조종기 수신거리 튜닝하셨나요 ? 아님 순정인가요

안녕하세요 저도 502s모델 가지고 있는데요, 배터리 완충 비행시간이 어느정도 되시나요? 제껀 카메라키고 날리면 배터리가 금방 닳드라구요

Você sentiu diferença positiva?

Awesome video, Please keep going, one day you make it big

안테나 개조 하셨나요?