Видео

Design by @hotlapkyle .

F16 on-board cam ( by @hotlapkyle)

Maiden flight of a 140% F16XL. Resized to fit a 70mm EDF. The plane survived the flight. But it wasn't easy. The throws seamed to be too high. I'll change that. And I'll check my servos, propably they don't center themselves correctly. Control wasn't easy. No hands off. Designed by PTIKYLE (‎@hotlapkyle ) Easy printable EDF Jet 70mm 4S EDF 80a ESC 3300mah 4S LiPo colorFabb LW-PLA Filament print...

Wonderful maiden flight! No trim needed. Same reaction as Kyle in his maiden video. Just awesome! I had to fight the plane down to the ground for landing. I'm not comfortable with models that are gliding that well! And listen to the sound when it cuts through the air with engine in idle. Wow! Designed by PTIKYLE (‎@hotlapkyle ) Easy printable EDF Jet 2x 40mm 4S EDF 2x 40a ESC 2200mah 4S LiPo co...

Filmed with an Insta360 Go2.

Sukhoi Boomerang

3d printed Bf 109 H - flybys

Short maiden video. Unfortunately the camera was set to a wrong angle and most of the flying was not in frame. There is a better video on my channel.

June 2021

June 2021

Guohong Rd. E Shanghai in August 2018

Ultralight build - FC failure in flight at the end.

Cruising at Ciqu station

This is my FT Arrow with its rear selfie stick. Awesome camera angle and stable flight characteristics. The only downright is the cg shift and the additional 40g weight in the nose.

Boeing P-26 Peashooter - golden hour

Boeing P-26 Peashooter - Maiden v0.1

FT SE5 - Between the trees

FT Mini Scout - FPV Test

FT Mini Scout - 3rd flight

FT Mini Scout - Erstflug^2

FT SE5 - Jungfernflug

FT Mini Scout - Spring

FliteTest FT ALPHA Jet - Maiden

FliteTest FT ALPHA Jet - Phantom