Видео

I ThinkYes.

I1m so sorry! OS reinstall?

@@computercollector ya reinstale muchas veces, el Windows 10 y 11 pero aún así solo prende en modo seguro

@@El_CompaChago Muy raro. ¿Qué tipo de tarjeta vga? ¿Integrado o dedicado?

Super!

Thank you for your question! Warming. The cooling system must be kept clean. You also need to pay attention to the legs of the laptop, they need to be at the right height from the hard flat surface.

BIOS reset. Try this. Put the other processor back in, does it work? Are you sure you are in the latest BIOS?

Yes! Working good!

Yes! Working good!

hu.wikipedia.org/wiki/RAM

por lo general compatible Hynix ddr3 4gb 1333mhz y esa gráfica que usa tarjetas graficas del año 2007 con lo justo corre el gta San Andrea 😂 yo actualize va bien internet el hdmi para conectar un monitor fullhd nose si el mother soportará disco ssd

@@xcexar1340 ¡Hola! Describa de forma más sencilla qué es exactamente lo que quiere saber. ¡Gracias!

Hello! I will try to help. The speaker must be connected. Is it beeping now? Does the motherboard start with a different processor? If so, you need to check the BIOS version. www.gigabyte.com/Motherboard/GA-EX58-UD5-rev-10#ov

This is extremely interesting. Is it possible that you try with a different cpu and different rules apply to the system? Are you referring to CPU power settings? (OC Tweaker/CPU Configuration/All)

Yes. In OC tweaker/ cpu configurations you have long and short duration power limits. I have Current limits instead. But as you said, it might be because of other cpu. I have 6700 but engineering sample.

Interesting. Then maybe the Engineering Sample? Can you try the motherboard with a different CPU? Thanks! I look forward to your feedback!

Видеокарта должна находиться в слоте ближе к процессору. Это точно. :)

www.asrock.com/mb/intel/h110m-hdv/#Manual English version, (71/) page 11, number 6 = CLRMOS1 And: page 23.

Thank you very much! This is new information to me. I did not know. Thanks!

Hi! This is in the description: 4 x 256Mb SDRAM, Reg. PC133, Kingsone. ECC RAM required. " Dual Inline Memory Module (DIMM) Requirements: 3.3 V, registered ECC DIMMs that are compliant with JEDEC PC133 specification • DIMM Sockets: Four 72-bit, 168-pin, gold contact • DIMMs Supported: 64, 128, 256, 512 MB, and 1GB (Min: 64 MB, Max: 4 GB) • ECC single-bit correction, and multiple-bit detection "

@@computercollector okay thank you!

Hi! I don't think this system has AHCI extension. AHCI mode must be set in the BIOS, if available. After this, it is possible/necessary to reinstall the Windows operating system.

YES! www.gigabyte.com/Motherboard/GA-H81M-S2PT-rev-11/support#support-cpu

Hi! In principle, the Xeon E5450 (S771) CPU can be used in a Socket T (LGA775) G41-m motherboard. The point is that cpu modding is needed to fit into the LGA771 motherboard socket.

¿Cuál es la CPU (771 o 775)? ¿La fuente de alimentación es correcta? ¿En qué parte se apaga? (¿Instalación, sistema operativo?) El instalador también puede estar defectuoso... (ya estuve allí)

@@computercollector ya pude resolver era problema del procesador por si alguien más le ocurre lo cambie y listo gracias de igual forma

¡Hola! Creo que la prueba de video no funciona, deberías probarla en otra placa base para ver si funciona o está fallando. Si funciona antes de la instalación, debe cambiar la configuración de la pantalla de Windows. Este es un error bastante raro. ¡Buena suerte!

❤

@@OmarAlSaadon 👍

@@TekiAldyn 👍

Hi! According to Manual, the motherboard supports Pentium 4 processors. www.asus.com/us/supportonly/p5kpl-am%20in-gb/helpdesk_manual/

Hi! Graphics card: PCIe x16 (But x4 mode) As much money as you have, but since the CPU only has 1 core, it is not worth buying a high-performance one. RAM: Max 2x1GB 400MHz, CPU: Pentium 4 HT, 3 - 3.8GHz, see the manual: www.gigabyte.com/Motherboard/GA-8I915ME-GL-rev-1x/support#support-manual

Hi! THANKS! I don't know where to download the latest BIOS. I'm sorry. If you find it, please link it here, thank you! www.google.com/search?q=foxconn+661+mx+bios+download&sca_esv=587533604&sxsrf=AM9HkKm7GrRGJKwGMuFPIFsEb6J3FuuvYA%3A1701647333389&ei=5RNtZaCvF6Gii-gPwYu8kAY&oq=Foxconn+661+MX+BIOS+&gs_lp=Egxnd3Mtd2l6LXNlcnAiFEZveGNvbm4gNjYxIE1YIEJJT1MgKgIIAjIHECEYoAEYCjIHECEYoAEYCjIHECEYoAEYCjIHECEYoAEYCjIHECEYoAEYCkjbL1CsB1igF3ABeACQAQCYAY8BoAHBBaoBAzEuNbgBA8gBAPgBAcICChAjGLACGLADGCfCAgkQABgeGA0YsAPCAgcQIxiwAhgnwgIGEAAYHhgNwgIEECEYFcICCBAhGBYYHhgd4gMEGAEgQYgGAZAGAw&sclient=gws-wiz-serp#ip=1

Hi! I don't know if your BIOS version is the latest release or earlier. Please check! It is possible that the i5 CPU should be removed in the OP system. Maybe a system reinstall. Maybe a RAM error. Does the memory controller of the 2 cpu work at the same speed? BIOS reset. Try it! I hope it goes well!

my bios is the latest, mother boards is support this cpu and the ram speeds it same, anyway i try use just one ram memory but still not work..but i buy second one CPUs 4790k and he is works greatly,,, the problem is in the CPU(must be something wrong with him), so i send the first CPU back to seller and using the second one and everythink works great, but i just need instal new cpu cooler, cuz the intel stock cooler cant handle it on full 4,5Ghz boost, temperatures become around 90-100 °C now with big fan cooler in full load is around 55-69 °C :D.. What is your temperatures in FULLLOAD? @@computercollector

THX! I have already purchased the 333MHz model. I hope I will have time to try it and show it to you as soon as possible.

Hello! Some simple heatpipe cooler.

Hello! Yes, I think this CPU will work. I already tried it in some motherboards and it worked. It should be the latest BIOS. Good luck!

so I can't go to Windows EasyBCD does not open

just tell me which button to go to the Boot menu

@@FnfSong Press and hold the F1 key during POST to enter the BIOS Setup Utility menu, and then select Advanced → Intel AMT

Привет! Вводится в биосе на 1:56. Изменение частоты не сильно меняет производительность, но возможно. Обычно это не так в меню BIOS. Мне просто показалось это интересным. (Hello! It is introduced in BIOS at 1:56. Changing the frequency does not change the performance much, but it is possible. This is not usually the case in the BIOS menu. I just found it interesting.) (Privet! Vvoditsya v biose na 1:56. Izmeneniye chastoty ne sil'no menyayet proizvoditel'nost', no vozmozhno. Obychno eto ne tak v menyu BIOS. Mne prosto pokazalos' eto interesnym.)

¡Hola! Es posible que la fuente de alimentación esté defectuosa, pero, por supuesto, la propia placa base también puede estar defectuosa. ¿Supongo que sabes qué bola tienes que tocar para encenderlo?

Hi! I do not know what you're thinking. It has 2 ram cards. 2x256MB According to the description of the motherboard, shouldn't it work with 512MB of memory?

That is due to BIOS version 3.2, which can be written to BIOS Flash 2Mbit on 5ALI61 Rev: F. On early revisions of that board installed 1MBit Flash, so you can write there only BIOS version 1.5 which supports only SDRAM sticks on 128MB. But potentially there is possible to change BIOS Flash to 2Mbit on old revisions and write there BIOS version 3.2.

Thanks! Unfortunately, I don't know the version number of the motherboard. If it's really important, I'll check it out. Required? Is it possible that they forgot to write the 4790K support for your motherboard?

@@computercollector I believe it's missing for all revisions, it's not a big deal. I found that the temp sensors on the board read pretty hot after running intensive workloads for extended periods of time (worst one being prime95), so maybe that's a hint as to why it's not on the support list.

@@computercollector The 4790K is also on the support list of every other H81 board Gigabyte made, so I think this is an intentional omission rather than them just forgetting.

@@aggserp4340 I do not know. Maybe when the motherboard came out it wasn't 4790K yet. This motherboard is in daily use with this cpu. For a game. It has a GTX660 TI associated with it. They still work. What temperature did you see?

@@computercollector Nope, the 4690K is on the supported list, and that processor came out the same time as the 4790K. Who knows why they omitted it. To answer your question, it's been a while since I ran prime95 but I think the sensor was reading something like 120°C. To be fair, the motherboard is still working fine and it's hard to tell what that reading is supposed to mean as HWiNFO64 simply reported the sensor as "Temperature 5". During normal operations like gaming it doesn't go above 70°C.

Yes!

I'm after this too

A specific motherboard requires the appropriate version of the flash program. usually you have to start the system in DOS mode (but there are also windows flash applications). Start the flash program. It is worth saving the original BIOS. Shall I make a video about it?

Hello! Unfortunately, I do not know. I don't think it has Secure Boot. The system is too old.

hi! motherbiard name is x58. (chiset is x58, i think) All settings is default. All cores running, default speed.

Hi! Unfortunately, I don't remember that the motherboard has an indicator light for this status. Maybe you should look at the downloadable user manual on your website. www.asrock.com/mb/intel/h110m-hdv/#Manual

Hello! I don't know what the FJ BIOS code means, but the version 7.60 BIOS should be uploaded.

Yes, supported, but only 7th Gen Intel CPU supports DDR4 up to 2400; 6th Gen Intel CPU supports DDR4 up to 2133. www.asrock.com/mb/intel/h110m-hdv/

I'm sorry! I don't know what the problem could be. Please try using another monitor output or reset the BIOS on the motherboard with the BIOS clear jumper. Thanks.

Hello! In principle, yes. I didn't check the BIOS, but I downloaded it, it was modified and it's there. Most of the machines start with the original BIOS, only malfunctions occur during operation.

Did you think of this? support.microsoft.com/hu-hu/topic/-hi%C3%A1nyz%C3%B3-bootmgr-%C3%BAjraind%C3%ADt%C3%A1s-ctrl-alt-del-a-windows-ind%C3%ADt%C3%A1sakor-8bc1b94b-d243-1027-5410-aeb04d5cd5e2

¡Me alegro de poder ayudar! ¡Gracias por el comentario! Si te gusta mi actividad, por favor suscríbete, ¡Gracias!

Hello! I think the memory is set to automatic mode in the settings. Or does the ram not support (533?) 1066? I have an Asrock motherboard, with automatic setting the frequency is 800MHz, but in manual mode it is 1066. I will upload the video soon.

Yes, I have a 1333MHz RAM, but it appears as at 3:02

@@bodisoftware6530 I understand. I didn't even notice that. I think you have to look at the operating states with a CPU-z or an Aida64.

Thank you brother for helping me, thank you very much 😅😁🌹