Видео

@@jitendranimkar2582 please visit Hariprasad kathyayini RUclips channel which has watsapp number in it.you can contact him through watsapp or else try the shop number which I gave in my description and channel itself

What is your location bro

You can loosen drain bolt at bottom of engine to remove oil

Yes, if there is a doubt first dismantle the bearing from hub and buy new one for the matching old bearing number

Let you know in few weeks

Clunking noise may caused due to freeplay in fork t stem.check that first and adjust for no freeplay

@@madbiker946 Thank you, I will check for freeplay first and proceed from there

No my friend. I m in tamilnadu only

@@madbiker946 Oh OK, Bro. Upload rx related videos or 2 stroke related videos.

@@mjshaheed sure bro.i will try

In or out doesn't matter.if first plate sharp edge placed inner means all other plates sharp edge should be placed inner

@@madbiker946 THANKS FOR YOUR VALUABLE GUIDELINES

No the clutch will not work properly with only 3 screws

13mm socket

​@@madbiker946can we put rx100 head in tvs suzuki max 100

@@chanakyareddy3201 no

@@madbiker946 why

@@chanakyareddy3201 if dimensions are exactly same as rx 100 head we can use it.or else will create firing problem

13mm box(socket) spanner

Yamaha showroom in your town

No only shaft

Lathe Shop name is Salem engineering works, Attur(near GH)

@@madbiker946 thanks for replying..

Bro it's oe for Rx 100. This is not a special reed valve.

This doom comes with bike when bought.i think it's yezdi roadking type

Rx only, other bike's kicker shaft wont match

Sure bro

I need some parts of it, like kick and other things but don't know where to get them

I forget the shop name.if you go from five roads to meyannor road, you could find KIA showroom on right.4TO 5 shops after KIA showroom there is a car accessories shop on right.in that row this automobile is second and third is a house

@@madbiker946 ok 👍..think that's kalai automobiles...will checkout

@@KK-cd7nu I m sure that's not kalai ,which is on side of road. after kalai automobiles this shop is in small street (sandhu).it's a setu kadai

@@madbiker946 ok got it...next to siva towers. On the left, a small lane. Same building where pink broadband office is there on first floor and this automobile is on the ground floor which is the last shop in that complex...

@@KK-cd7nu think you got it right

Both are equal.no worries elf is Rs.220 which is 30 -40 rupees cheaper here in attur

I bought this in Salem, Tamil nadu.already I mentioned the cost in video please watch again

No, if Reed valve is bad it will affect from low-end to top end.specifically it will reduce top speed

No you should not use this rx 135.for rx 135 part number is different and have to use that only

@@madbiker946 Bro what is the problem when using this in rx 135?

Bro in my video I showed the Reed valve for 100 cc.for 135 cc the Reed valve design will be slightly different as the volume of air fuel mixture sucked will be higher for 135 cc and the cylinder port for 135 cc is not same as 100 cc .up to my knowledge if 135 Reed valve used in 100 cc, engine will show rich condition, performance issues ,mileage drop......

Same hoti hai