Видео

is there an official way to cut a roll? do print shops do it? lucky me found three rolls of 24" wide epson premium semi gloss rolls (for inkjet, amazingly not solvent), would love to have them cut to 13 inch wide so I can do 13x19s, and then 11x17s on the other half.

Can I use it for drawing?

Can I use it for drawing?

Once unrolled, do you recall if the paper edge was fuzzy or a sharp cut? Did dust inject itself in the interior side any? Thanks for posting this, I realize my questions have come years later.

Do you have any problems with dust on the paper when you unroll it

Perfect! I have a 12” double bevel miter that slides. I’m about to trim my 9’ down for my new basement studio. Thanks.

My people are here. It is sad to announce that i need to cut my 9ft into 7ft. Goodluck to me ❤

Great thank you. I have a mitre saw and wondered if I could use it for this.

Great job thanks

It was asked before by someone else and I'll ask again because you didn't answer the other person. What size miter saw/blade did you use? I assume the one in the video is a 10" saw and the new one you just bought is a 12" saw. Hence, does a 12" saw cut all the way through in one pass?

Thanks man.. Just what I was looking for.. great vid

Thank you; this is the first thing I should have thought of.

Very nice work, now I just need to figure out how I get a saw.

Its helpful ❤️❤️

This is very useful. Can you mention the (a) Roll diameter (b) Blade dia & (c) Blade type used .

Hello, What blade did you use?

This appears to be the best way to cut a roll of seamless. A bigger blade would have helped I guess. Do you still recommend using a table saw for cutting seamless or have you found a better method?

Thank you so much.

Probably could place a thin piece of wood under the roll. There is a gap between the blade and the roll before you start cutting. About 3/8 of an inch. Then you would be able to cut it in one pass. Also if you blue tape the paper to the wood you would not need the clamps. Good video!

Can you use metal cutting disk

Have you ever tried doing this with kraft paper rolls? I'm looking to source 2 in wide rolls and it's nearly impossible to find!

Once I seen the photo I knew it was burlesque. Small world.

Turn the dam clamp to the side. lol Driving me nuts over here watching that saw hit the clamp every time. #RepairmanProblems

Neat idea. I would have turned the clamps around (handle to the back) and put the end clamp inside the roll. That keeps it out of the way and gives a positive clamp. The outside of the roll isn't going anywhere the inside isn't going.

Would've never thought to do this! Was looking for a tool to cut rolls of film.. Have you tried raising the roll closer to the blade so you can cut it without having to rotate? That extra inch closer to the blade may help!